Postal Pro PP200 Post Kit - Instructions

Postal Pro PP200 Post Kit - Instructions Parts List

A. Vertical Post - 4” x 4” Square 50.75 inch Length F. Post Hardware Kit B. Cross Arm - 3.5” x 3.5” Square 24 Inch Length - (4) 10-24 x 1 ¼ Machine Screws C. Support Arm - 1.75” x 1.75” Square 21 inch Length - (4) 10-24 Nuts D. Ball Finial - (7) #8 x 1 Self Drilling Screws E. End Caps (2) - (5) Screw Covers (white) - (4) Metal L-Brackets - (6) Post Cap Clips (metal)

Postal Regulations recommend that the floor (Mail entry point) of the mounted Mailbox be between 41”-45” above road surface and that the front of the mailbox be set back 6-8” from edge of road or front of curb. The USPS suggest that all customers contact their local Post Office before erecting your Mailbox/Post to ensure correct placement and height at the street. Install Ground Mounting Post  The PP200 Post is designed to slip over a Mounting Post made from a standard 4x4 wooden post. Two 2x4 boards can be combined to provide an alternative Mounting Post.  Mounting Post should be set 18 inches in to the ground and between 18-23 inches above ground. The height above ground will need to be lower than 23 inches to allow for PP200 Post to mount completely over wooden post.

WARNING: “Call before you dig” – Call 811 . 811 is the designated call before you dig phone number that directly connects you to your local one call center in your area. Each state has different rules and regulations governing digging to insure that buried utility lines will not be disturbed.

Assemble PP200 Post 1) Slide Support Arm into small opening of Cross Arm. ( Figure 1 )

2) Slide Cross Arm in to large opening in Vertical Post. Do not push cross arm all the way through back side of post

at this time. This will allow flexibility to insert Support Arm in smaller hole below. ( Figure 2 )

3) Pull Support Arm up and push into small opening on Vertical Post. ( Figure 2 )

4) Push Cross Arm through Vertical Post until approximately 4 inches extends out the back of the Vertical Post. ( Figure 3 ) You can now slip Assembly over Ground Mounting Post. Use (4) of #8 Self Tapping screws to secure PP200 Assembly to Mounting Post. The white Screw Covers can be used with the #8 Screws to hide the screws. Install Mailbox Mounting Kit and Mailbox

1) Align your Mailbox on top of Cross Arm and

mark 2 locations of mailbox mounting holes

as shown in Figure 4.

2) Remove mailbox so L-brackets can be mounted.

3) Measure inside width of Mailbox bottom and set

side-to-side dimensions of L-brackets as pictured

in Figure 5 to that width. Secure brackets with

# 8 Self Tapping screw to Cross Arm at pre-marked locations .

Use (1) screw per pair of L-Brackets.

4) Set Mailbox on top of L-Brackets and align

Mailbox holes with L-Bracket holes.

5) Secure Mailbox to L-brackets with the (4) #10 Machine Screws/nuts. ( Figure 6 )

Install End Caps and Finial (6) clips have been included in hardware kit for installation of End Caps and Ball Finial to PVC pieces. Attach Clips as shown in picture below with barb side on outside of PVC posts. Use (2) Clips per post end application. Slip on caps for secure installation.

Problems with your purchase? If you find that you have any missing or broken parts during assembly, please contact our Customer Service Department for replacement.