Paper ID Session Paper Title Author Names 5 M1-TS1 12 June 2018 9
Total Page:16
File Type:pdf, Size:1020Kb
Paper ID Session Paper Title Author Names Mikel Larranaga Aizpurua, Wroclaw University of Science and Technology, Zbigniew Leonowicz, Wroclaw University of Science and 5M1‐TS1 12 June 2018 9:00‐11:00 Advanced solar energy systems with thermoelectric generators Technology Jan‐Harm Pretorius, University of Johannesburg, Dirk van Vuuren, University of Johannesburg, Annlize Marnewick, University of 63 M1‐TS1 12 June 2018 9:00‐11:00 A Theoretical Pre‐Assessment of Solar Photovoltaic Electrical Production for Commercial Retail Centers Johannesburg, 129 M1‐TS1 12 June 2018 9:00‐11:00 Sustainable Outreach and Lifelong Advocacy to Rekindle HOPE John Mark Napao, University of the Philippines Diliman, Philippines Jana Růžičková, ENET VSB‐ TU OSTRAVA, Petr Pavlík, VSB‐ TU OSTRAVA, Helena Raclavská, ENET VSB‐ TU OSTRAVA, Marek Kucbel, 236 M1‐TS1 12 June 2018 9:00‐11:00 Effect of pre‐treatment of layered cartons on the quality of pyrolytic carbon intended for thermal use ENET VSB‐ TU OSTRAVA, Barbora Švédová, ENET VSB‐ TU OSTRAVA, Veronika Sassmanová, VSB‐ TU OSTRAVA, Konstantin Raclavský, ENET VSB‐ TU OSTRAVA, Hana Škrobánková, ENET VSB‐TU OSTRAVA 337 M1‐TS1 12 June 2018 9:00‐11:00 Pinus Pinaster and Eucalyptus Globulus Energetic Properties and Ash Characterization Leonel Nunes, Univeristy of Aveiro, Radu Godina, University of Beira Interior, J.C.O. Matias, UA 381 M1‐TS1 12 June 2018 9:00‐11:00 Evaluation of Allowable Penetration Levels of Distributed Energy Resources Based on IEEE Std. 1547 Mark Halpin, Auburn University Gabriel Paiva, Federal University of Goias, Marco Mussetta, Politecnico di Milano, Sonia Leva, Politecnico di Milano, Sérgio Pimentel, 538 M1‐TS1 12 June 2018 9:00‐11:00 Assessment of exogenous variables on intra‐day solar forecasting models EMC/UFG A modified multidimension diode model for PV parameters identification using guaranteed convergence particle swarm optimization 590 M1‐TS1 12 June 2018 9:00‐11:00 Pedro Bento, University of Beira Interior, Hugo Nunes, University of Beira Interior algorithm 211 M1‐TS2 12 June 2018 9:00‐11:00 A case‐study of green roof monitoring: The building of Council for Agricultural Research and Economics in Bagheria (PA), Italy Gianluca Scaccianoce, University of Palermo, Maria La Gennusa, Università degli Studi di Palermo‐DEIM 220 M1‐TS2 12 June 2018 9:00‐11:00 Study of influence of the led technologies on visual and subjective/individual aspects Laura Cirrincione, Università di Palermo, Gianluca Scaccianoce, University of Palermo Cinzia Capitano, University of Palermo ‐ DEIM, Giorgia Peri, University of Palermo ‐ DEIM, Gianfranco Rizzo, University of Palermo ‐ 273 M1‐TS2 12 June 2018 9:00‐11:00 The role of transportation and its involved sources of energy in the environmental assessment of marble producing sites DEIM, Concettina Marino, Mediterranean University of Reggio Calabria, Antonino Nucara, Mediterranean University of Reggio Calabria Reducing electric and thermal energy needs in buildings by using innovative envelope materials Laboratory results of bio‐composites Maria La Gennusa, Università degli Studi di Palermo‐DEIM, Giorgia Peri, Università degli Studi di Palermo ‐ DEIM, Gianfranco Rizzo, 302 M1‐TS2 12 June 2018 9:00‐11:00 embodying tomato plant stems Università di Palermo ‐ DEIM, Joan Rieradevall, Universitat Autònoma de Barcelona 326 M1‐TS2 12 June 2018 9:00‐11:00 Energy saving on air conditioning using adsorption heat exchanger for the air dehumidification instead of conventional chillers Vincenzo Gentile, Politecnico di Torino 492 M1‐TS2 12 June 2018 9:00‐11:00 The Role of Housing in Future Energy Thinking Phil Jones, Architecture, Cardiff University Dynamic interaction between a wind‐photovoltaic‐battery‐heat pump hybrid trigeneration system and a residential load and the electric 515 M1‐TS2 12 June 2018 9:00‐11:00 Domenico Mazzeo, University of Calabria, Giuseppe Oliveti, University of Calabria, Nicoletta Matera, University of Calabria vehicle charging Natale Arcuri, University of Calabria (UNICAL), Marida Bevacqua, Università degli Studi di Brescia, Giovanna Grossi, Università degl 530 M1‐TS2 12 June 2018 9:00‐11:00 Passive Cooling Techniques for Less Energy Consuption In Buildings. A Comparative Study On Green Surfaces studi di Brescia 2M1‐TS3 12 June 2018 9:00‐11:00 A PFC‐ Bridgeless SEPIC converter with Multiplier Cell for Universal Input Voltage Applications Ganesh Yamavarapu, Politecnico di milano 18 M1‐TS3 12 June 2018 9:00‐11:00 Fault Diagnosis on a Wound Rotor Induction Generator Using Probabilistic Intelligence Elsie Swana, University of Johannesburg, Wesley Doorsamy, University of Johannesburg Kiran Maroti Pandav,University of Johannesburg, Sanjeevikumar Padmanaban, University of Johannesburg, Dan Ionel, University of 31 M1‐TS3 12 June 2018 9:00‐11:00 Configurations of Modified SEPIC Converter with Switched Inductor Module (MSCSI) for Photovoltaic Application: Part‐II Kentucky, Pierluigi Siano, University of Salerno, Zbigniew Leonowicz, Wroclaw University of Science and Technology 109 M1‐TS3 12 June 2018 9:00‐11:00 External Load Characteristic of Synchronous Generator with Wound Excitation and Permanent‐Magnet Exciting cores Nobuyuki Naoe, Kanazawa Technical College, Akio Imazawa, Kanazawa Technical College Martin Mach, Brno University of Technology, Radoslav Cipin, Brno University of Technology, Marek Toman, Brno University of 215 M1‐TS3 12 June 2018 9:00‐11:00 Impact of Number of Rotor Slots on Performance of Three‐Phase and Single‐Phase Induction Machines Technology, Vitezslav Hajek, Faculty of Electrical Engineering and Communication,Czech Republic Mohamed Salem, UNITEN, Vigna Vigna K. Ramachandaramurthy, Universiti Tenaga Nasional, Sanjeevikumar Padmanaban, University 269 M1‐TS3 12 June 2018 9:00‐11:00 Three‐Phase Interleaved Multi LLC Resonant Converter With Full Bridge Rectifier For HV Applications of Johannesburg, Frede Blaabjerg, Aalborg University, Denmark 378 M1‐TS3 12 June 2018 9:00‐11:00 Analysis and Measurements of New Designed Reluctance Synchronous Rotor Pavol Rafajdus, University of Zilina. 543 M1‐TS3 12 June 2018 9:00‐11:00 Energy Harvesting Device with Magnetostrictive Materia Domenico Curto, University of Palermo, Alessia Viola, Uni Palermo, Marco Trapanese, University of Palermo Rodrigo Martins, University of Alberta, Petr Musilek, University of Alberta, Holger Hesse, Technical University of Munich, Johanna 72 M1‐TS4 12 June 2018 9:00‐11:00 Linear Battery Aging Model for Industrial Peak Shaving Applications Jungbauer, Smart Power, Thomas Vorbuchner, Technical University of Munich, Andreas Jossen, Technical University of Munich Qingru Cui, National Energy Investment Corporation, Yanqiu Zheng, North China Electric Power University, Yaohan Wang, North China 84 M1‐TS4 12 June 2018 9:00‐11:00 A turbine energy storage utilization evaluate method in thermal power unit Electric Power University, Deliang Zeng, North China Electric Power University Massimiliana Carello, Politecnico di Torino, Alessandro Ferraris, Politecnico di Torino, Andrea Giancarlo Airale, Politecnico di Torino, 123 M1‐TS4 12 June 2018 9:00‐11:00 Alternative Efficiency Test Protocol for Lithium‐ion Battery Santo Scavuzzo, Politecnico di Torino, Roberto Guerrieri, Politecnico di Torino Valentin Boicea, Universitatea Politehnica din Bucuresti, Mihai Sanduleac, Universitatea Politehnica din Bucuresti , Lucian Toma, UPB, 143 M1‐TS4 12 June 2018 9:00‐11:00 Primary frequency control in a power system with batteries and energy recovery Alexandru Mandiş, Universitatea Politehnica din Bucuresti Giovani Giulio Vieira, University of Sao Paulo, Mauricio Salles, University of Sao Paulo, Renato Machado Monaro, Universidade de São 150 M1‐TS4 12 June 2018 9:00‐11:00 Voltage and Frequency Regulation in Marine Vessel’s Electrical Power System Paulo 152 M1‐TS4 12 June 2018 9:00‐11:00 Comparison of Supercapacitor and Flywheel Energy Storage Devices based on Power Converters and Simulink Real‐Time Bartosz Kedra, Institute of Power Engineering, Robert Małkowski, Gdańsk University of Technology 162 M1‐TS4 12 June 2018 9:00‐11:00 Evaluation of Energy Storage in Distribution Systems Using Battery Energy Storage Systems Renata Varfolomejeva, Riga Technical University, Aleksandrs Gavrilovs, JSC Sadales tikls, Lubov Petrichenko, Riga Technical University Jevgenijs Kozadajevs, Riga Technical University, Renata Varfolomejeva , Riga Technical University, Dmitrijs Boreiko, Riga Technical 241 M1‐TS4 12 June 2018 9:00‐11:00 Detailed Modelling of a Battery Energy Storage System in an Energy‐Intensive Enterprise University, Ivars Zalitis, Riga Technical University, Aleksandrs Dolgicers, Riga Technical university Francisco Arredondo, Carlos III University of Madrid, Edgardo Daniel Castronuovo, Carlos III University of Madrid, Pablo Ledesma, 12 M1‐TS5 12 June 2018 9:00‐11:00 Comparative Implementation of Numerical Integration Methods for Transient Stability Constrained Optimal Power Flow Carlos III University of Madrid, Zbigniew Leonowicz, Wroclaw University of Science and Technology 30 M1‐TS5 12 June 2018 9:00‐11:00 Reconfigurability of all electric ship with faults Wanlu Zhu, Naval Engineering University Pouya Jamborsalamati, Macquarie University, Mojtaba Moghimi, Griffith University, M. J. Hossain, Macquarie University, Rasoul 48 M1‐TS5 12 June 2018 9:00‐11:00 A Framework for Evaluation of Power Grid Resilience, Case Study: South Australian Blackout in 2016 Garmabdari, Griffith University, Junwei Lu, Griffith University, Georgios Konstantinou, UNSW Australia Sunny Katyara, Sukkur IBA University, Zbigniew