USBR Captures Existing Conditions of the Glen Canyon Dam and Power Plant to Create a Unified Intelligent 3D Model for Enhanced F
Total Page:16
File Type:pdf, Size:1020Kb
ReCap Success Story COMPANY USBR captures existing conditions of the U.S. Bureau of Reclamation Glen Canyon Dam and power plant to LOCATION Glen Canyon Dam, Arizona create a unified intelligent 3D model for SOFTWARE Autodesk® ReCap Pro enhanced facility management. WEBSITE www.usbr.gov Image courtesy of USBR Introduction Technology Used Results The Glen Canyon Dam is part of a complex • Stationary laser scanners (FARO Focus3D X 330 In the summer of 2016, USBR worked with teams engineering system that generates hydroelectric and Z+F IMAGER 5010C) to capture the as-built from eTrac (providing hydrographic survey services) power and provides water to the western United conditions of the power plant (interior and exterior) and Autodesk to capture the existing conditions of States. Located on the Colorado River in northern and part of the dam’s exterior. the dam, power plant, and the upstream reservoir. Arizona, the 710-foot high dam forms Lake Powell, a reservoir that spans more than 250 square miles. • Aerial images taken from a helicopter (with a Sony The teams collected multi beam sonar data, 677 A7RII camera) to complete the capture the dam’s Lidar scans, and over 2,200 ground and helicopter- For over 50 years, the dam and reservoir have exterior, as well as conditions upstream of the dam based photographs. helped to regulate the flow of the Colorado River for approximately one-quarter mile. and provide controlled storage and delivery of its This effort resulted in a highly accurate, water. The facility was built and is operated by the • Underwater sonar (from R2Sonic) to capture the underwater portion of the dam’s exterior. photorealistic model of the facility, which will be the U.S. Bureau of Reclamation (USBR). geometric basis of the unified intelligent 3D model. USBR used reality capture to document existing • Autodesk Recap Pro and Autodesk ReMake to conditions of the dam and the surrounding area. create 3D surface meshes and point clouds from This data will support the development an captured data. intelligent 3D model of the dam and the power plant facility that will be used for design, operation and maintenance, asset management, monitoring, security, and public outreach and education. Autodesk and ReCap are registered trademarks or trademarks of Autodesk, Inc., and/or its subsidiaries and/or affiliates in the USA and/or other countries. All other brand names, product names, or trademarks belong to their respective holders. Autodesk reserves the right to alter product and services offerings, and specifications and pricing at any time without notice, and is not responsible for typographical or graphical errors that may appear in this document. © 2017 Autodesk, Inc. All rights reserved. .