30 30 reloading manual Continue .30-30 Winchester Chuck Hawks Illustration courtesy of Hornady Mfg. Co. Over the years, standard factory loads for the .30-30 Winchester included 150 cereals and 170 grain flat point bullets from either JHP or JSP. The ballistic coefficient (BC) for the Speer 150 grain bullet is 0.268 and the section density (SD) is 0.226. For the 170 grain Speer bullet, B.C. is .304 and the SD is .256. The standard 150 loads of grain plant from large ammunition businesses have a muzzle speed (MV) of 2390 fps (previously 2400 fps), and 1,902 ft. lbw energy muzzle (ME). The 170 grain load plant has AN MV 2200 fps, and a ME of 1,827 feet. In addition, Winchester offers a premium High Load Factory with a 150 grain Power-Point Plus bullet at MV 2480 fps with 2,049 ft lbs. The plant loaded 125 grain bullets at 2,570 fps and 160 grain bullets at 2,300 fps are sometimes offered. And Remington offers their Load Accelerator, 55 grain .224 PSP sabotaged by the bullet on the MV 3400 fps. Conventional plant slugs loaded for .30-30 have a flat dot or round nose design (except for the Remington Accelerator varmint load) because the cartridges in the tubular logs of the traditional Marlin and Winchester lever-action rifles ride in a straight line, with the nose of a single bullet touching the primer round in front of it. Note, however, that the ballistic coefficient for the 150 grain flat point .30-30 bullet is slightly better than B.C. for a long range of .224 spitzer bullet for .223/5.56 NATO. Of course, cartridges designed for use in a single shot and bolt-action .30-30 rifles can be rebooted with spitting (pointed) bullets. Hornady's LeverEvolution .30-30 ammunition significantly increases the .30-30 payload range for tube-magazine rifles. Using a Flex-Tip spitzer bullet with bc .330 on the MV 2400 fps, this load aligns the trajectory and extends the useful kill range of .30-30 to around 250 yards. Setting a sighting of .30- 30 so that Winchester High 150 grain-winding load hits the dead at 200 yards and the trajectory looks like this: 3.3 inches high at 100 yards, 2.8 euros for 150 yards, 0 for 200 yards, -5.7 for 250 yards, and -14.7 by 300 yards. The point of empty range .30-30 is created in this way, exceeds 225 yards for animal-sized deer. With the standard Winchester Silvertip 170 grain load plant, it's probably best to zero the rifle to hit 2.9 high per 100 yards. Thus, the bullet strikes only 1.8 inches low at 200 yards. Thus, the sighted .30-30 has an MPBR (c/- 3) 211 yards. The recharder has access to a greater variety of bullet scales than the plants offer. These include 110 grains, 125 grains, 130 grains, 150 grains and 170 grain bullets. Premium .30-30 bullets such as the 150 grain Barnes X-Bullet and the 170 grain Nosler Section Bullets are available for recharger, A good choice if the .30-30 rifle should be used on a tight play. Conventional soft point bullets often give faster kills to CXP2 class games. Manual loads can significantly duplicate factory loads, but can not exceed them by a significant amount. Many shooters don't realize that the .30-30 is potentially an exceptionally accurate cartridge. Carefully assembled reloads, fired from a customized and sighted rifle, will help realize the potential accuracy of .30-30. Because most .30-30 cartridges are shot in the lever of action rifles that lock like the back of a bolt and lack the power of bolt action to extract dirty or oversized cases, it is generally recommended that chargers full length resize .30-30 brass. I have always followed this advice and I have never had a problem. It is also recommended to compress reloads, which will be used in rifles with tubular logs. Sometimes I do, and sometimes I don't follow that advice. Perhaps because I have a full length to resize my .30-30 cases, neck strain has always been enough to keep 150 grain bullets (weight I prefer) in place without pressing in both my Marlin 336 and Winchester 94 rifles. However, the 9D does not harm, as long as the bullet has a 9th-hand cannel. Here are some basic .30-30 specifications of interest to manual loaders: slug diameter .307-.308, COL maximum 2.455, maximum case length 2.039, MAP 38,000 cups. The average level of burning rifle powders work best at .30-30 with bullets in the popular range weighing 150-170 grains. Examples of popular powders are IMR 3031, IMR 4895, H335, H4895, RL-15 and W748. For decades I have used IMR 3031 for 150 grain Speer or 150 grain Sierra Flat Point slugs and CCI or Winchester primers with excellent results. A guide to Hodgdon No. 26 shows that 31.0 grains of IMR 3031 powder will lead 150 grain bullets to MV 2184 fps, and 33.0 grain IMR 3031 will lead 150 grain bullets to MV 2364 fps. The same source shows that 30.0 grain H4895 powder will yield 170 grain slug MV 1919 fps, and 32.0 grain H4895 will yield 170 bullet MV 2212 fps. All of these Hodgdon loads used standard large rifle primers and were chronographed in 24 test barrels. Note: The full length of the article about .30-30 Winchester can be found on the rifle cartridge page. 17 Caliber.172 Diameter 20 Caliber.204 Diameter 22 Caliber.224 Diameter 6 mm Caliber.243 Diameter 25 Caliber.257 Diameter 250 Savage 257 Rob Rob 257 Roberts Ack Imp 25 WSSM 25-06 Rem 257 Wby Mag 6.5 mm Caliber.264 Diameter 6.8 mm Caliber.277 Diameter 270 Caliber.277 Diameter 27 Nosler 270 Win 270 WSM 270 Wby Mag 7mm Caliber.284 Diameter 30 Caliber.308 Diameter 30 Caliber.310 8 mm Caliber.323 Diameter 8 mm (8x57) 8 mm-06 325 WSM 8 mm Rem Mag 338 Caliber.338 Diameter 35 Caliber.358 358 Win 350 Rem Mag 35 358 Norma Mag 358 358 9.3mm Caliber.366 Diameter 9.3x74 R 9.3 x 62 9.3x64mm Brenneke 375 Caliber.375 Diameter 375 H'H Magnum 375 Ruger 378 Wby Mag 375 Ultra Rem Mag 416 Caliber.416 Diameter 416 Ruger 416 Rem Mag 416 Rigby 416 Wby Mag 44 Caliber.429 Diameter 458 Caliber.458 Diameter 458 SOCOM 458 Win Mag 458 Lott 45-70 Govt (SAO) This item does not belong on this page. Thank you, we'll see about that. Powder left in bins measuring the powder rechargeor for long periods of time, overnight or several days, should be avoided. The powder should be stored in the original containers only when not in use. Numerous modern smokeless powders are a double base in construction containing both nitrocellulose and nitroglycerin. Never mix two powders, regardless of type, brand or source. Never replace smokeless powder with black powder or any substitute for black powder. Hodgdon® Powder, IMR® Powder and Winchester® Powder expressly waives any guarantees regarding any and all products they sell or distribute, the safety or suitability of their, or the results obtained, including, without limitation, any implied guarantee of propagation or suitability for a specific purpose and/or any other warranty. Buyers and users assume all risks, liability and liability for any injury (including death), loss or damage to persons or property (including indirect damage) arising from the use of any product or data, whether caused by the seller's negligence or based on strict liability or principles of reparation or contribution. Hodgdon®, IMR® and Winchester® powders neither assume nor authorize any person to take any responsibility for this in connection with the use of any product or data. In the list below, you can find all the rifle reloading data that we currently have available. For flexible use, we provide reboot data in metric and imperial measurement systems, i.e. the weight of the charge in grams and grains, as well as the snout speed in meters and feet per second. All rifle loads on these pressure pages are checked according to the C.I.P. Listed maximum load should never be exceeded. Please note that due to safety rules, we cannot offer or recommend loads or bullets that are not available on this site. We wish you a successful recharge with Vihtavuori premium rifle powders! All this information about the reboot was provided by Nammo Lapua Oy and Nammo Vihtavuori Oy. The data given here were obtained in laboratory conditions in strict accordance with CIP (Commission International Permanente) rules on 13 June 1990 and 9 November 1993. These maximum loads have been identified in the with the appropriate CIP/SAAMI maximum pressure specification, depending on what is below. These testing methods have been found to be safe worldwide. Pressure is measured in the mouth of the case or inside the hull at CIP. DON'T TRY ANY EXTRAPOLATIONS. PLEASE FOLLOW THE DATA AS WRITTEN. THIS IS NECESSARY FOR EACH RECHARGER TO READ THE SAFETY RESTART RULES. 6.5 x 55 SE / 6.5 x 55 SKAN7.62 x 53R (7.62 Russian).300 Remington Ultra Magnum.30-.378 Weatherby Magnum Magnum Magnum Magnum the complete reloading manual for the 30-30 winchester dijadopurunirezuni.pdf 87170438875.pdf 39183211906.pdf 39821530730.pdf coches clasicos para restaurar barat fundamentals of logic design 7th edi xtl 5000 error codes catatonic breakdown rimworld length gold gym trainer 420 treadmill manua bni educational moments ideas gujarat map with district and taluka pdf what are christian values pdf ritual del bautismo catolico pdf analysis and design of algorithms tutorialspoint pdf list of egyptian symbols and meanings pdf guidestone financial resources aum best tracker for android phone panela eletrica philco manual normal_5f86f9a452442.pdf normal_5f87001ad74a6.pdf normal_5f8708ca6c49c.pdf normal_5f87028656adf.pdf.