www.seicane.com

Seicane S127005 2001-2011 TIIDA QASHQAI SUNNY aftermarket car stereo upgrade installation replacement instruction

Seicane S127005 2001-2011 QASHQAI SUNNY head unit after installation

Please note: This unit can be suitable for the following cars which are also with the same installation steps as follows. 2004-2010 NISSAN TIIDA 2007-2010 2005-2011 2001-2011 NISSAN X-TRAIL 2005-2011 NISSAN PALADIN 2001-2011 NISSAN FRONTIER 2005-2010 2004-2010 2005-2010 NISSAN TREEANO 2004-2010 2002-2010 2002-2011 2003-2009 2006-2010 2001-2011 www.seicane.com

2001-2011 NISSAN MP300 2007-2011 2009-2011 NISSAN NV200 2009 NISSAN SYLPHY

Before and during installation, you should notice: 1.Before connecting, please make sure the ignition is off to avoid short circuit. 2.Ensure connect the yellow and red power cable at last. 3.Ensure that all loose wires are isolated with electrical tape 4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails). 5.Ensure that all ground is connected to the same place. 6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional. 7. For your convenience, here’s the recommended tools for removal and installation from Seicane, please check for more details: http://www.seicane.com/car-dvd-dismantling-device- srd-400

NISSAN Series head unit installation guide

1·Remove the original panel with a plastic knife, pry gently along the gap and pick up the panel, then remove it and then set it aside. www.seicane.com

2·Remove screws that fixed the radio on the dashboard.

3·Pull the factory radio out of the dash. Pull it with medium force, as the wires are connected to the radio.

4·Unplug the connectors at the back of the factory radio. www.seicane.com

5. Make antennas and cables connected step by step, and you should be very careful when you are doing this for it will affect whole procedure.

6. Put the new Seicane head unit into your car, you should check whether your connections are correct, and you’d better have a tidy for the cables.

7· If everything is OK, firm screws into their original place.

8·Firm the panel on the new Seicane head unit. Finally the new Seicane head unit is installed and a comprehensive test should be conducted on the new radio. www.seicane.com

Attention: We suggest you arrange a professional to install it. If you have any questions about installation, please send us photos about your original car's plugs, we can make a wiring diagram for your car.