Confetti Cannon Kit Includes: 1 Mega Cannon View a demonstr 1 100-Ft. of Lead Line Conf ation of th Mega-Cannon etti Canno e 1 Control Box ns on Con Tools of win’s 1 Control Box Battery Charger the Trade Instruction Sheet 1 Helium/ Nitrogen Recharge Hose DVD 1 Carrying Case Charging the Confetti Cannon 1 2 3 4
Hand-tight connect the regulator to a helium Make sure the bleed valve on the Remove the cap from the filling Hand-tight connect the filling hose to or nitrogen cylinder. The cylinder must have regulator is closed before filling the outlet on the cannon. The cap has a the cannon. a minimum of 1,000 psi gas pressure to cannon cylinder. bead chain attached to insure that it properly charge the cannon. doesn’t get misplaced.
Slowly open the cylinder valve. The preset 5 Cylinder regulator on the filling hose will Charging the Control Box Pressure automatically recharge the cannon with Gauge the proper amount of gas. The gauge on the cannon will read approximately 1,000 psi when the cannon is fully charged. Filling Close the cylinder valve. Open the bleed Outlet valve to release the pressure from the filling hose. Remove the filling hose from the cannon. Screw the cap back on the Bleed filling outlet and tighten. Valve
Cannon Cannon Recharge Pressure Hose CONFETTI TIP: If using bundled confetti, Gauge be sure to remove the rubber bands before placing them in the barrel. To avoid confetti from clumping, do not tightly pack the Plug the Control Box Battery Charger into a 110-volt electrical outlet. confetti in the barrel. Plug the other end into the back of the Control Box to charge it. Important! Recharge the battery with the Battery Charger for at Loading the Barrel least 8 hours prior to use. The battery can be recharged at any level.
1 2 3 4 5 Use a foil balloon to Place one foil circle Screw the barrel on to the cannon. Remove the cap ring from the barrel and fill the barrel with confetti. seal the barrel. Cut a 6” radius over the end of the barrel and TIP: For best results, place a rounded plastic cup lid in the base of the cannon barrel before loading circle out of a foil balloon (Use screw the cap ring onto the the barrel with confetti. Use clear packing tape to cover the straw hole on the plastic lid. The a popped or scrap balloon). cannon barrel. rounded plastic lid will act as a pusher to evenly distribute the force of the gas when the cannon is One circle will provide two fired, and launch the confetti load. Plastic lids are readily available at restaurant supply stores. pieces of foil material. Rigging the Cannon Firing the Cannon
1. The rigging 2. Plug the detonator On cue, push 1 mount, located at 2 line into the cannon. and hold down the bottom of the The 100-foot spool the Control Box barrel fits a 1/2” of line is designed to detonator button electrical conduit. remain on the until the cannon Place rigging mount holder–unwind only has completely over the conduit the length needed to fired. and secure using Firmly plug the connect the cannon duct tape. lead wire into to the detonator box. the cannon.
IMPORTANT: Prior to event, always verify that the battery is fully charged. To avoid accidentally firing the cannons, do not plug the wire into the Control Box until the event is ready to start. Make sure that the lead wire is taped to the ground to prevent potential tripping danger. As a finishing touch, cover the conduit with a column of balloons.
Cannon Accessories & Other Great Special Effects Products From Conwin
Balloon Bulb Kit Dual Cannon Outlet Create brilliant decor with Balloon The Dual Outlet plugs into the Bulbs. Designed by Conwin exclusively Control Box to fire 2 cannons for balloon decorators, Balloon Bulbs per zone. Using 2 dual outlets, are a perfect accent for dance floors, up to 4 cannons can be fired. entrance, decor, buffet areas, or any special location indoors or out. Conwin #85300 Conwin #86700
Create amazing special effects Now Available! for: Weddings, Corporate Events, Confetti Drops, Parties, etc. Deluxe Exploder Kit Conwin’s Pneumatic Balloon Everything you need to create Exploders are safe, easy to use, spectacular exploding balloon effects. and are non-electric. Powered by Kit includes: Carrying Case, Compact helium or nitrogen gas, they are Aluminum Cylinder, Automatic perfect for exploding balloon Cylinder Charger, Balloon Exploder walls and for special effects Regulator, Detonator Box, 100-Foot created with confetti-filled Air Line, 6 Continual Exploders, 6 balloons. Elbow-End Exploders, 6 Connecting Tees, 6 Connecting Crosses, 6 Connecting Air Line Splices
Service & Warranty Conwin’s Portfolio Builders For assistance with service & repair Update Your Portfolio! issues, or for warranty information, A picture is worth a thousand words. please visit ConwinOnline.com, Is your portfolio up to date on the latest? or call (818)246.9233 Conwin’s Portfolio Builder images are the perfect solution for making winning presentations to your clients. Thirty-two photo quality images are available in the full series.
04012006 Visit www.ConwinOnline.com today!