Dnazone Classroom Kit Classroom Kits Created by Carnegie Mellon University and the University of Pittsburgh the Center for Nucleic Acids Science and Technology
Total Page:16
File Type:pdf, Size:1020Kb
Load more
Recommended publications
-
Universal Indicator, Bogens in Alcohol Safety Data Sheet According to Federal Register / Vol
Universal Indicator, Bogens in Alcohol Safety Data Sheet according to Federal Register / Vol. 77, No. 58 / Monday, March 26, 2012 / Rules and Regulations Date of issue: 04/25/2014 Revision date: 05/15/2018 Supersedes: 04/25/2014 Version: 1.1 SECTION 1: Identification 1.1. Identification Product form : Mixtures Product name : Universal Indicator, Bogens in Alcohol Product code : LC26500 1.2. Recommended use and restrictions on use Use of the substance/mixture : For laboratory and manufacturing use only. Recommended use : Laboratory chemicals Restrictions on use : Not for food, drug or household use 1.3. Supplier LabChem Inc Jackson's Pointe Commerce Park Building 1000, 1010 Jackson's Pointe Court Zelienople, PA 16063 - USA T 412-826-5230 - F 724-473-0647 [email protected] - www.labchem.com 1.4. Emergency telephone number Emergency number : CHEMTREC: 1-800-424-9300 or +1-703-741-5970 SECTION 2: Hazard(s) identification 2.1. Classification of the substance or mixture GHS-US classification Flammable liquids H225 Highly flammable liquid and vapour Category 2 Serious eye damage/eye H319 Causes serious eye irritation irritation Category 2A Specific target organ H336 May cause drowsiness or dizziness toxicity (single exposure) Category 3 Full text of H statements : see section 16 2.2. GHS Label elements, including precautionary statements GHS-US labeling Hazard pictograms (GHS-US) : GHS02 GHS07 Signal word (GHS-US) : Danger Hazard statements (GHS-US) : H225 - Highly flammable liquid and vapour H319 - Causes serious eye irritation H336 - May cause drowsiness or dizziness Precautionary statements (GHS-US) : P210 - Keep away from heat, hot surfaces, open flames, sparks. -
Determination of the Amount of Sodium Carbonate and Sodium Hydroxide in a Mixture by Titration
Module 9 : Experiments in Chemistry Lecture 38 : Titrations : Acid-Base, Redox and Complexometric Objectives In this lecture you will learn the techniques to do following Determination of the amount of sodium carbonate and sodium hydroxide in a mixture by titration. Carrying out acid-base titration using a pH meter. Carrying out acid-base titration by conductometric measurement. Determination of the composition of a mixture of acetic acid and hydrochloric acid by conductometric titration. Determination of ferrous ion using potassium dichromate by internal indicator. Determination of hardness (Ca2+) of water using EDTA – complexometry method. In this lecture, you will be introduced to a few experiments in chemistry. These experiments complement the theory you have learned in chemical equilibrium and kinetics. 38.1 Acid-Base Titrations: Acid-base reactions are of great practical importance in analysis, not only because of their use in titrating a large number of inorganic and organic substances, but also because the hydrogen ion concentration of a solution often is of great importance in controlling reactions. Titration : The process of determining the volume of a given solution of a reagent equivalent to the amount of another reactant present in a standard solution is known as titration. Equivalent Weight of Acids and Bases : The equivalent weight of an acid is that weight which yields one mole of hydrogen ions in the reaction employed whereas the equivalent weight of a base is that weight which reacts with one mole of hydrogen ions in the reaction. Normal solution : A solution containing one equivalent weight of solute per litre of solution. Equivalence Point : When the number of equivalents of acid (respectively base) added is equal to the number of equivalents of base (respectively acid) taken initially, we have reached the equivalence point. -
Chapter 7 - PHYSICAL and CHEMICAL ANALYSES
Water Quality Monitoring - A Practical Guide to the Design and Implementation of Freshwater Quality Studies and Monitoring Programmes Edited by Jamie Bartram and Richard Ballance Published on behalf of United Nations Environment Programme and the World Health Organization © 1996 UNEP/WHO ISBN 0 419 22320 7 (Hbk) 0 419 21730 4 (Pbk) Chapter 7 - PHYSICAL AND CHEMICAL ANALYSES This chapter was prepared by R. Ballance In compiling this chapter, care has been taken to avoid procedures that require delicate or sophisticated equipment. For many of the variables for which methods of analysis are presented here, further information relating to their selection and inclusion in water quality monitoring and assessment programmes (such as their environmental significance, normal ranges of concentrations, and behaviour in the aquatic environment) can be found in the companion guidebook Water Quality Assessments. 7.1 Preparation and use of chemical reagents The following general rules should be followed in the preparation and use of chemical reagents. The best quality chemical reagents available should be used - normally “analytical reagent grade”. For most laboratory purposes, water distilled in a borosilicate glass still or a tin still will be satisfactory. For preparing some reagents, dilution water requires special treatment, such as a second distillation, boiling to drive off CO2 or passing through a mixed bed ion exchanger. Where such special treatment is necessary, this is stated. Recipes for the preparation of reagents usually give directions for the preparation of a 1-litre volume. For those reagents that are not used often, smaller volumes should be prepared by mixing proportionally smaller quantities than those given in the recipe. -
Chem 321 Lecture 13 - Acid-Base Titrations 10/10/13
Chem 321 Lecture 13 - Acid-Base Titrations 10/10/13 Student Learning Objectives Indicators A common end point for acid-base titrations is the color change associated with an acid-base indicator. An acid-base indicator is usually an organic weak acid or base that has a different color in solution than its conjugate form. These substances strongly absorb light so that even a very small concentration in solution produces an obvious color. If the weak acid form of the indicator is taken as HIn, the acid dissociation process for this indicator is represented by: K a + - HIn + H2O º H3O + In At equilibrium, and + This means that as [H3O ] changes, so do the relative amounts of the different colored conjugate species in solution. Thus, the indicator in solution will take on a specific color depending upon the solution pH. As an example, consider the acid-base indicator methyl orange indicator. The weak acid form is red in solution while the conjugate base form is yellow (that is, HIn = red and In- = yellow). In order to anticipate the pH range in which this indicator changes from yellow to red, or vice versa, assume that a 10-fold excess of one colored form over the other is needed to establish the color of one of the conjugate pairs. Thus, to see predominately yellow in solution, In a similar way it can be shown that the red color dominates when the solution pH is about equal to pKa - 1. Therefore, an indicator color change is expected in a pH range equal to pKa ± 1. -
Acidbaseindicators/Index.Html Acid - Base Indicators Phenolphthalein, Methyl Orange, Methyl Red
Aris Kaksis Riga Stradin’s University RSU : http://aris.gusc.lv/ChemFiles/AcidBaseIndicators/index.html Acid - Base Indicators Phenolphthalein, Methyl Orange, Methyl Red Acid - Base indicators (also known as pH indicators) are substances which change colour with pH. They are divalent weak acids or bases, involved in protolytic water acid-base equilibrium and form two type coloured ions as Brensted-Lowry protolytic pairs. Consider an indicator which is divalent weak acid, with the formula H2In. At equilibrium, the following equilibrium equation is established with conjugate base In2- of different colour: + 2- H2In(aq) + 2 H2O(l) <=> 2 H3O (aq) + In (aq) acid conjugated base (colour A) (colour B) The acid and its conjugate base have different colours. At low pH values the + concentration of H3O is high and so the equilibrium position lies to the left. The equilibrium solution has the colour A. + At high pH values, the concentration of H3O is low - the equilibrium position thus lies to the right and the equilibrium solution has colour B. Phenolphthalein is an example of an indicator which establishes this type of equilibrium in aqueous solution: coloureless 8,9▒▒▒▒▒▒▒▒▒▒▒9,9 pink → pH O H O H H O H H H H H H H + O O H H H H H + H H H + H H H + H O H H H H H O O H O H H O H H O H H H H O coloureless (Acid) pink (Base) + 2- H2Fen(aq) + 2 H2O 2 H3O (aq) + Fen (aq); (1) Phenolphthalein (pdb version) is a coloureless, weak acid which dissociates in water forming pink anions. -
Acid – Base Indicators
Acid – Base Indicators SECTION 6.3 PG. 245-247 Acid – Base Indicators Substances that change colour when the acidity of the solution changes are known as acid-base indicators A very common indicator used is litmus, which is obtained from lichen Litmus paper is prepared by soaking absorbent paper with litmus solution and then drying it. Acid – Base Indicators Acid-base indicators are unique chemicals because they can exist in two forms, each with a distinctly different colour The form of the chemical depends on the acidity of the solution. They usually have very complicated formulas, so simple abbreviations are used: Lt – litmus; Bb – bromothymol blue; In – indicator (generic) The two forms of any indicator depend on whether a particular hydrogen atom is present in the indicator’s molecule. In general, the lower pH form is designated HIn(aq) - In general, the higher pH form is designated In (aq) Acid – Base Indicators Other acid-base indicators: Because the chemical structure of each indicator is different, the pH at which - the indicator changes from the HIn(aq) form to the In (aq) form is different for each indicator. (See inside back cover of textbook) Common name Color of pH range of Color of In- HIn(aq) colour change (aq) Bromothymol blue Yellow 6.0-7.6 Blue Phenolphthalein Colourless 8.2-10.0 Pink A Close Look at Litmus Paper The colour changes of litmus are a little more complicated than what you have learned previously. There is a “fuzzy” region around the neutral point (pH=7) where the colour is not easily distinguished. -
Universal Indicators Experiment
Chemistry for the gifted and talented 9 Universal indicators Student worksheet: CDROM index 05SW Discussion of answers: CDROM index 05DA Technician’s notes: CDROM index 05TN Topics Indicators, universal indicators and pH. Level Able students aged 11–13. Timing The full worksheet should take a double period. There is quite a bit of flexibility in how many binary mixtures of indicators they try. Prior knowledge Acids, alkalis and indicators. Rationale This activity develops understanding of universal indicators and single indicators. The students build up their understanding by mixing two indicators. They also develop an awareness that the observed colour may be due to a mixture of colours. 10 Chemistry for the gifted and talented Use This activity is best used as an extension to work on single indicators and pH. Alternative An alternative activity with a less structured problem solving approach would be Making your own indicator Activity 1 in the RSC publication In search of solutions which can be downloaded at www.chemsoc.org/networks/learnnet/solutions.htm (accessed April 2007). Apparatus (per group) Eye protection At least four test-tubes A test-tube rack Dropping pipettes Chemicals (per group) 50-100 cm3 of pH 3 buffer solution (An alternative is 0.5 mol dm–3 ethanoic acid ) 50-100 cm3 of pH 4 buffer solution 50-100 cm3 of pH 7 buffer solution 50-100 cm3 of pH 10 buffer solution Methyl red indicator solution Methyl orange indicator solution Bromothymol blue indicator solution Phenolphthalein indicator solution (Highly flammable) Safety It is the responsibility of the class teacher to consult an employer’s risk assessment for this experiment. -
A Guide for Teaching Assistants and Students Course Outline
B 6 INTERMEDIATE ORGANIC LAB MICROSCALE m TECHNIQUES IN ORGANIC SYNTHESIS e h C A guide for teaching assistants and students Modus Operandi (1-4) tend, TAs have to inform to the instructor with a reasonable reason, who may pro- Course Outline 1. TA responsibilities. vide a “permission” email. If space is avail- General: For safety, TAs permit a maxi- able, TAs in other sections will contact the Exp. 1 (esterification - laurate) mum of fourteen students per section and student to inform them of potential time to make-up the experiment. Make-up will Exp. 2 (oxidation - cyclohexanone) they require students to wear lab goggles and closed-toed-shoes. TAs ensure that be allowed up to 2 times in entire course. Exp. 3 (ketone olefination - stilbene) students finish their experiments in a If a TA is sick, or must miss a lab, they will timely fashion (4 hrs max!). make arrangements to cover the sections Exp. 4 (hydroboration - octanol) Instruction and score: In each ex- and inform the instructor. Exp. 5 (Grignard 1,2-add. - triphenylmethanol) periment class, TAs give a brief overview 2. General procedures for students in of the theory and procedure for the daily each lab. Each class usually begins with a Exp. 6 (Diels-Alder - cyclohexene) activities, give a quiz, grade the pre-lab, and 5-10 minute quiz that emphasizes impor- in-lab parts, and assign a technique grade. tant aspects of the current experiment or Exp. 7 (Br2, dehydrohalogenation - diphenylacetylene) After each experiment, TAs will request a specifics from the past lab. The TAs will photocopy of the entire experiment (pre- Exp.