Data on Physicochemical Quality of Drinking Water in the Rural Area in Divandarreh County, Kurdistan, Iran, Data in Brief (2018)
Total Page:16
File Type:pdf, Size:1020Kb
Data in Brief ∎ (∎∎∎∎) ∎∎∎–∎∎∎ 1 Contents lists available at ScienceDirect 2 3 4 Data in Brief 5 6 7 journal homepage: www.elsevier.com/locate/dib 8 9 Data Article 10 11 12Q1 Data on physicochemical quality of drinking 13 water in the rural area in Divandarreh county, 14 15 Kurdistan, Iran 16 a b a b 17 Afshin Maleki , Bahram kamarehie , Reza Rezaei , Ali Jafari , 18 Yahya Zandsalami a, Pegah Bahmani a, Esmail Ghahramani a,n, 19 Mohammad Amin Karami b,n 20 21 a Environmental Health Research Center, Kurdistan University of Medical Sciences, Sanandaj, Iran b 22 Department of Environmental Health Engineering, Faculty of Health and Nutrition, Lorestan University 23 of Medical Sciences, Khorramabad, Iran 24 25 article info abstract 26 27 28 Article history: Good quality of drinking water is very important in the main- Received 29 December 2017 tenance of human health. The gathered data from the present work 29 Received in revised form was used to evaluate the quality of drinking water resources in the 30 17 June 2018 rural villages of Divandarreh, Iran. Physicochemical quality of water Accepted 19 June 2018 31 was determined by a collection of 35 random samples during dry 32 and rainy seasons in 2015. The APHA approach was used to deter- 33 Keywords: mine the physicochemical parameters of the samples. The results Divandarreh 34 showed that the average concentration of Ca, Mg, Na, K, Cl, SO4,TDS Physicochemical quality 35 and TH during dry season was 85.64 mg/l, 13.41 mg/l, 34.11 mg/l, Drinking water 2.8 mg/l, 9.9 mg/l, 45.7 mg/l, 326.06 mg/l and 269.61 mg/l, respec- 36 Rural area 37 tively. Also, the average concentration of the parameters during 38 rainy season was 77.3 mg/l, 18.27 mg/l, 30.3 mg/l, 1.9 mg/l, 12.54 mg/ 39 l, 39 mg/l, 269.1 mg/l and 316.17 mg/l, respectively. & 2018 The Authors. Published by Elsevier Inc. This is an open access 40 article under the CC BY license 41 (http://creativecommons.org/licenses/by/4.0/). 42 43 44 45 46 47 48 49 50 n Corresponding authors. 51 E-mail addresses: [email protected] (E. Ghahramani), [email protected] (M.A. Karami). 52 https://doi.org/10.1016/j.dib.2018.06.058 53 2352-3409/& 2018 The Authors. Published by Elsevier Inc. This is an open access article under the CC BY license 54 (http://creativecommons.org/licenses/by/4.0/). Please cite this article as: A. Maleki, et al., Data on physicochemical quality of drinking water in the rural area in Divandarreh county, Kurdistan, Iran, Data in Brief (2018), https://doi.org/10.1016/j. dib.2018.06.058i 2 A. Maleki et al. / Data in Brief ∎ (∎∎∎∎) ∎∎∎–∎∎∎ 55 Specifications Table 56 57 Subject area Chemistry 58 More specific Drinking water quality 59 subject area 60 Type of data Tables and map 61 How data was Analyses of temporary hardness, calcium, magnesium were conducted using 62 acquired titration method. The electrical conductivity and pH of samples were deter- 63 mined with (Jenway 470 Conductivity meter) and pH meter (model Jenway 64 350), respectively. Measurement of sulfate anions and cations was done by 65 spectrophotometry (DR 5000; Hach) in water. 66 Data format Analyzed 67 Experimental The water samples stored at room temperature and were analyzed according 68 factors to the APHA approach. 69 Experimental The levels of physical and chemical parameters were determined. 70 features 71 Data source Divandarreh, Kurdistan province, Iran 72 location 73 Data accessibility Data are included in this article 74 75 76 Value of the data 77 78 Based on the obtained data proper measure can be taken in order to deliver appropriate water 79 quality to consumers. 80 The collected data can be used for the preparation of research map in the field of water treatment 81 by another researcher. 82 The collected data can be useful for the codification of local standards along with other 83 researcher's data. 84 85 86 87 1. Data 88 fi 89 The speci ed parameters in the experiments are included calcium ion, magnesium ion, sodium 90 ion, chloride ion, sulfate ion, temperature, total alkalinity, electrical conductivity (EC), total dissolved 91 solids (TDS) and pH analyzed according to standard methods for the examination of water and 92 wastewater [1]. Water stability was evaluated based on RSI, LSI, PSI, AI and LS. The sampling points 93 and study area was shown in Fig. 1. The chemical and physical characteristics of intended water 94 samples are presented in Tables 2 and 3. Table 4 shows the equations and indicators for categorizing 95 Q2 the water stability. Calculation of water quality indices is shown in Table 5. Table 6 illustrates the 96 stability indices in water resource. The condition of water stability in the water resources is shown in 97 Table 7 (Table 1). 98 99 100 2. Experimental design, materials and methods 101 102 2.1. Description of study area 103 104 Divandarreh, one of the cities of Kurdistan province, located at west of Iran 105 (35°540N, 47°010E). The city area is about 4203 km2 (approximately 15% of Kurdistan province 106 area). The highest and lowest temperatures of air are 32 °CandÀ20 °C, respectively. 107 108 Please cite this article as: A. Maleki, et al., Data on physicochemical quality of drinking water in the rural area in Divandarreh county, Kurdistan, Iran, Data in Brief (2018), https://doi.org/10.1016/j. dib.2018.06.058i Download English Version: https://daneshyari.com/en/article/6596760 Download Persian Version: https://daneshyari.com/article/6596760 Daneshyari.com.