University of Massachusetts Amherst ScholarWorks@UMass Amherst Chemistry Department Faculty Publication Series Chemistry 2016 Carbon Nanotubes and Graphene as Additives in 3D Printing Lara A. Al-Hariri University of Massachusetts Amherst Branden Leonhardt Florida State University Mesopotamia Nowotarski Florida State University James Magi Florida State University Kaelynn Chambliss Florida State University See next page for additional authors Follow this and additional works at: https://scholarworks.umass.edu/chem_faculty_pubs Part of the Chemistry Commons, and the Education Commons Recommended Citation Al-Hariri, Lara A.; Leonhardt, Branden; Nowotarski, Mesopotamia; Magi, James; Chambliss, Kaelynn; Venzel, Thaís; Delekar, Sagar; and Acquah, Steve, "Carbon Nanotubes and Graphene as Additives in 3D Printing" (2016). Carbon Nanotubes - Current Progress of their Polymer Composites. 1448. https://doi.org/10.5772/63419 This Article is brought to you for free and open access by the Chemistry at ScholarWorks@UMass Amherst. It has been accepted for inclusion in Chemistry Department Faculty Publication Series by an authorized administrator of ScholarWorks@UMass Amherst. For more information, please contact
[email protected]. Authors Lara A. Al-Hariri, Branden Leonhardt, Mesopotamia Nowotarski, James Magi, Kaelynn Chambliss, Thaís Venzel, Sagar Delekar, and Steve Acquah This article is available at ScholarWorks@UMass Amherst: https://scholarworks.umass.edu/chem_faculty_pubs/1448 PUBLISHED BY World's largest Science, Technology & Medicine