Toyota Previa, Tercel 4-Door, T-100 & Tacoma Trucks Tool
Total Page:16
File Type:pdf, Size:1020Kb
Toyota Previa, Tercel 4-Door, T-100 & Tacoma Trucks Tool TT1014 The TT1014 is a double-ended tool that unlocks all Toyota Previa models, all 4-door Tercel models made after 1990, all T-100 and Tacoma pick-up trucks, as well as the Toyota Sienna. See the illustrations below to identify which end is used on which vehicle. There is an index mark on the shaft of the tool which is used only for the Toyota Previa. The tool is designed to be operated by feel. An inspection light is not needed to open either vehicle. Toyota Previa Toyota Four-Door Tercel & T-100 Pick-up Truck Step 1 - Begin by wedging open the window on either front door Step 1 - Begin by wedging open the window of the front door near near the center. Place the tool on the weatherstrip with the Previa the rear. Insert the tool with the tip towards the rear of the vehicle. end near the center of the window and the index mark even with the Lower the tool about 14 inches into the door. rear edge of the window. Step 2 - Work the tip of the tool towards the rear of the vehicle on Step 2 - Carefully note the position of the end of the tool on the the inboard side of the window track. When the tool is as far to weatherstrip. The shaft of the tool will be inserted into the door at the rear as it will go, pull up on the tool while keeping the tip of the this point. You may want to place a small piece of tape on the win- tool pointed to the rear. This will place the tip of the tool below a dow or weatherstrip at this point to make sure that the tool is bell crank, which is connected to the inside lock control. As you inserted at the proper point. pull up on the tool, the lock linkage will be lifted from below. Step 3 - Insert the tool into the door at the point you measured, NOTE - If the vehicle does not unlock, reposition the tool making until it is approximately six inches into the door. At this point, certain that the tip is pointed directly to the rear and that the tool is rotate the tip of the tool to the inside of the van and pull up until the on the inboard side of the window track. tool stops. NOTE - Make sure that the tool is pulled as far up as it NOTE - On the T-100 pick-up truck, the shaft of the tool must be will go. There may be some resistance against the tool for about angled slightly forward in order to reach the linkage. On the Tercel one inch before it comes to a complete stop. and the Tacoma, the tool must be held as close to vertical as possible. Step 4 - The tip of the tool will now be resting against the bell crank, which connects the horizontal and diagonal portions of the linkage. Twist the tip of the tool toward the rear of the van, then push down on the shaft of the tool to unlock the van. NOTE - If the van does not unlock, make sure that you have insert- ed the tool at the correct point and that you have pulled it as far up as it will go. DO NOT FORCE THE TOOL. Tercel & T-100 End Previa End 800.654.0637 • Fax 859.885.1731 [email protected] • www.lockmasters.com TT1014INSTPDF 2101 John C.Watts Dr., Nicholasville, KY 40356 Copyright © 2008 Lockmasters Inc. 7/08.