Wheel Fitment Instructions
Total Page:16
File Type:pdf, Size:1020Kb
WHEEL FITMENT INSTRUCTIONS 1. Print a copy of the drawing, 2. Check dimensions both vertically 3. Cut the drawing just outside the making sure that the “Page Scaling” and horizontally to confirm it has dotted line. is set at “none.” (or make sure been printed to scale. “Scale” is at “100%”) 4. Glue the drawing to a stiffer piece 5. Lay the template inside the wheel 6. Verify that the edge of the caliper of material such as a manila folder to as shown. does not touch the rim or the wheel make the template easier to use. spokes. A minimum clearance of Finish by cutting directly along the 2mm (0.080”) is recommended. dotted line. If there is interference, different wheels or a spacer will be necessary. Use of a wheel spacer is at the discretion of the vehicle owner. Typically a properly made spacer of 2‐3mm will not adversely affect the vehicle. Issues that must be addressed before utilizing a wheel spacer include, but are not limited to, fender clearance, proper wheel bolt or stud length, effect on vehicle handling, and centering of the wheel. Wheel fitment and the use of wheel spacers with our big brake upgrades is the responsibility of the customer. If you have any questions, please e‐mail [email protected] or call +1 310‐933‐1100. PROFILE OF STOCK DISC R7.5 8.0 31.4 7.44 31.9 188.93 1.49 167.1 37.95 160.7 119.1 7.0 Note hat thickness is 114.3 0.8mm thicker than stock 56 template. as use to line dashed along Cut 2. FACTORY WHEEL REGISTER C L STOPTECH NOTES: BRAKE KIT OUTLINE HONDA CIVIC EX '96-'05 HONDA CIVIC LX SEDAN W/ REAR DISC '94-95 This outline is the net dimension HONDA CIVIC LX SEDAN W/ ABS AND A/T '96-'00 HONDA CIVIC LX '04-'05 of the brake system. STOPTECH HONDA CIVIC GX SEDAN '01-'05 recommends adding 2mm of HONDA CIVIC Si '99-'01 clearance to these dimensions. FRONT 328x28 - ST40M 98-427-2430-02 04/19/12 1. Verify accuracy of printout by matching a dimension in both length and width. One dimension in each direction is shown in both inch and mm. All other dimensions are mm..