Rashguard Datasheet.Indd
Total Page:16
File Type:pdf, Size:1020Kb
1-9-9701 CLEAR W/R PEELABLE COATING PRODUCT DESCRIPTION PRODUCT CHEMISTRY: Acrylic Polymer GENERAL DESCRIPTION: A single component, spray applied, peelable, water based coating for temporary protection against incidental damage during fabrication and shipment. TYPICAL USES: Ideal for temporary protection of coated surfaces and non-ferrous metal substrates. SPECIFICATION DATA COLOR: Clear VOC: 0.30 lbs/gal (26 g/L) FINENESS OF GRIND: Smooth WEIGHT/GALLON: 8.20 +/- .20 FINISH: Flat 1-10 @ 60° Gloss FLASH POINT: 214° F (101° C) VISCOSITY: 65 - 80 KU’s SOLIDS BY WEIGHT: 45% +/-2% REDUCTION SOLVENT: Water (10 % Maximum) SOLIDS BY VOLUME: 41% +/-2% CLEAN-UP SOLVENT: Water/Acetone REDUCED VISCOSITY: N/A THEORETICAL COVERAGE @ 1 MIL DFT With 100% APPLICATION EFFICIENCY: 654 sq.ft./gal PERFORMANCE DATA Please contact our Technical Department for additional information. DIRECTIONS FOR USE MIXING: Use a commercially available mechanical mixer to properly agitate the coating until thoroughly mixed. THINNING: Thinning as needed with water up to 10%. CLEAN-UP: Use water and/or acetone to clean spray equipment and tools. APPLICATION: Airless Spray is preferred. DRY TIME @ 77°F (25°C) & 50% RH: PEEL TIME: Overnight SET TO TOUCH: 5 Minutes DRY HARD: Overnight TACK FREE: 10 - 20 Minutes RECOAT TIME: Overnight The above table provides guidelines only. Always consult our Technical Department for appropriate recoat WARNING: windows since the maximum aged recoat time of this product may be significantly shortened or lengthened by a variety of conditions, including, but not limited to humidity, surface temperature, and the use of additives or thinners. The use of accelerators or force curing may shorten the aged recoat of individual coatings. SHIPPING / HANDLING SHELF LIFE: 1 Year Minimum (Unopened) FREIGHT CLASSIFICATION: Non-Hazardous FLASH POINT: 214° F (101° C) RASH-GUARD | 1785 NW Maynard Rd. Cary, NC 27513 | Phone 919.380.0898 | Fax 919.380.0829 Issue Date: 3/5/2019 Version: 1 page 1 1-9-9701 CLEAR W/R PEELABLE COATING GENERAL SURFACE PREPARATION Surfaces must be dry, clean, free of oil, grease, form release agents, curing compounds, laitance, other foreign matter and be structurally sound. Our product was designed to provide excellent protection over less than ideal surface preparation. Use masking material to protect adjoining surfaces from overspray. Mask off areas such as deep joint seams and channels that may create a mechanical keyway into which the coating will lock. WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE. Wear a NIOSH-approved respirator to control lead exposure. Clean up carefully with a HEPA vacuum and a wet mop. Before you start, find out how to protect yourself and your family by contacting the National Lead Information Hotline at 1-800-424-LEAD or log on to www.epa.gov/lead. PRECAUTIONS HAZARDS: MAY CAUSE SKIN AND EYE IRRITATION. MAY CAUSE RESPIRATORY IRRITATION. MAY CAUSE DROWSINESS OR DIZZINESS. PRECAUTIONS: AVOID BREATHING DUST/FUMES/GAS/MIST/VAPOURS SPRAY. WASH THOROUGHLY AFTER HANDLING. USE ONLY OUTDOORS OR IN A WELL-VENTILATED AREA. WEAR PROTECTIVE GLOVES/PROTECTIVE CLOTHING/ EYE PROTECTION/FACE PROTECTION. TAKE OFF CONTAMINATED CLOTHING AND WASH BEFORE REUSE. IF ON SKIN: WASH WITH SOAP AND WATER. IF INHALED: REMOVE VICTIM TO FRESH AIR AND KEEPA AT REST IN A POSITION COMFORTABLE FOR BREATHING. IF IN EYES: RINSE CONTINUOUSLY WITH WATER FOR SEVERAL MINUTES. REMOCE CONTACT LENSES IF PRESENT AND EASY TO DO - CONTINUE RINSING. IF SKIN OR EYE IRRITATION OCCURS: GET MEDICAL ADVICE/ATTENTION. IN CASE OF FIRE: USE WATER SPRAY OR A MULTIPURPOSE DRY CHEMICAL EXTINGUISHER FOR EXTINCTION CLASS B, AND C FIRES. STORE IN WELL VENTILATED PLACE AND KEEP COOL. DISPOSE OF CONTENTS/CONTAINER IN ACCORDANCE WITH STATE AND LOCAL REGULATIONS. DISCLAIMER: WHILE THE DESCRIPTIONS, DESIGNS, DATA AND INFORMATION CONTAINED HEREIN ARE PRESENTED IN GOOD FAITH AND BELIEVED TO BE ACCURATE, IT IS PROVIDED FOR YOUR GUIDANCE ONLY. BECAUSE MANY FACTORS MAY AFFECT PROCESSING OR APPLICATION/USE, WE RECOMMEND THAT YOU MAKE TESTS TO DETERMINE THE PURPOSE PRIOR TO USE. NO WARRANTIES OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, ARE MADE REGARDING PRODUCTS DESCRIBED OR DESIGNS, DATA OR INFORMATION SET FORTH, OR THAT THE PRODUCTS, DESIGNS, DATA OR INFORMATION MAY BE USED WITHOUT INFRINGING THE INTELLECTUAL PROPERTY RIGHTS OF OTHERS. IN NO CASE SHALL THE DESCRIPTIONS, INFORMATION, DATA OR DESIGNS PROVIDED BE CONSIDERED A PART OF OUR TERMS AND CONDITIONS OF SALE. FURTHER, YOU EXPRESSLY UNDERSTAND AND AGREE THAT THE DESCRIPTIONS, DESIGNS, DATA AND INFORMATION FURNISHED BY OUR COMPANY HEREUNDER ARE GIVEN GRATIS AND WE ASSUME NO OBLIGATION OR LIABILITY FOR THE DESCRIPTION, DESIGNS, DATA AND INFORMATION GIVEN OR RESULTS OBTAINED, ALL SUCH BEING GIVEN AND ACCEPTED AT YOUR RISK. RASH-GUARD | 1785 NW Maynard Rd. Cary, NC 27513 | Phone 919.380.0898 | Fax 919.380.0829 Issue Date: 3/5/2019 Version: 1 page 2.