Multi-Information Display
Total Page:16
File Type:pdf, Size:1020Kb
05/02/10 16:30:17 31SEP610 0069 Multi-Information Display The multi-information display in the Maintenance Messages Auto door lock conditions instrument panel displays various Trip Computer Auto door unlock conditions information and messages when the Keyless Memory SettingsTM Whenever unlocking (driver’s ignition switch is in the ON (II) HandsFree LinkTM door, or all doors) position. Some of the messages help Language Selection (Canada only) Keyless lock acknowledgment you operate your vehicle more conditions comfortably. Security relock timer Others help to keep you aware of the Headlight auto off timer periodic maintenance your vehicle Interior light dimming time needs for continued trouble-free driving. SELECT/ To customize these control settings, RESET see page . Here is a list of the messages you BUTTON 74 can see. The following pages give you more information on these messages. Driver 1 or 2 Detected INFO Door and Trunk Open BUTTON Fasten Seat Belt Release Parking Brake With the multi-information display Check Fuel Cap and the two buttons next to it, you Low Windshield Washer Fluid can also customize these vehicle Level (Canada only) control settings to your liking. Odometer Trip Meter Outside Temperature Engine Oil Life 66 05/02/10 16:30:24 31SEP610 0070 Multi-Information Display With the ignition switch in the ON (II) position, the basic display changes, as shown in the illustration, each time you press the > side of the INFO button. If you press the < side of the INFO button, the display Instruments and Controls returns to the previous message. On Canadian models, the language in the multi information display can be set to English or French. To change the language see page79 . (CANADIAN MODELS ONLY) 67 05/02/10 16:30:35 31SEP610 0071 Multi-Information Display Driver 1 or 2 Detected If you use the remote transmitter to Fasten Seat Belt unlock the driver’s door, the display shows ‘‘DRIVER 1 DETECTED’’ or ‘‘DRIVER 2 DETECTED’’ depending on which transmitter you use, and the driver’s seat and outside mirrors move to the positions stored in that transmitter (see page)101. Door and Trunk Open When you unlock and open the In addition to the seat belt reminder driver’s door with the key, the in the instrument panel, the multi- display shows ‘‘DRIVER 1 information display interrupts the DETECTED’’ or ‘‘DRIVER 2 current display and shows ‘‘FASTEN DETECTED’’, depending on which SEAT BELT’’ for about 6 seconds if remote transmitter was used last. you do not fasten your seat belt (The driver’s ‘‘ID’’ is determined by while driving. This message repeats the transmitter.) if you ignore it and do not wear your If the trunk or any door is not closed seat belt while the vehicle is moving. tightly, the display reminds you to close the open trunk or the door(s) before you start driving. 68 05/02/10 16:30:43 31SEP610 0072 Multi-Information Display Release Parking Brake Check Fuel Cap The CHECK FUEL CAP message should go off after tightening the fuel cap, turning the ignition switch off and on, then driving over 30 mph (48 km/h) for at least 45 seconds. Due to different driving conditions, it Instruments and Controls may take a few driving trips to make the message go off. If a loose or missing fuel cap was not the cause of the CHECK FUEL CAP message coming on, the message will turn off and the malfunction indicator lamp will come on. If this If you start driving without releasing If the fuel fill cap is missing or not happens, have your vehicle checked the parking brake, the multi- tightened properly, you will see by a dealer as soon as possible. information display interrupts the ‘‘CHECK FUEL CAP’’. Make sure current display and shows the fuel cap is installed and tightened ‘‘RELEASE PARKING BRAKE.’’ properly to at least 3 clicks. This message continues, and a chime sounds, until you release the parking brake, or the vehicle speed slows down to less than 0.5 mph (0.8 km/h). 69 05/02/10 16:30:53 31SEP610 0073 Multi-Information Display Low Windshield Washer Fluid Odometer Trip Meter Level ODOMETER TRIP METER The odometer shows the total This meter show the number of On Canadian models distance your vehicle has been miles (U.S.) or kilometers (Canada) If the fluid level in the windshield driven. It measures miles in U.S. driven since you last reset it. There washer reservoir gets low, the multi- models and kilometers in Canadian are two trip meters: Trip A and Trip information display shows the above models. It is illegal under U.S. B. When you first turn the ignition message. federal law and Canadian provincial switch to ON (II), Trip A is displayed. regulations to disconnect, reset, or Switch between Trip A and Trip B by alter the odometer with the intent to pressing the Select/Reset button change the number of miles or repeatedly. Each trip meter works kilometers indicated. independently, so you can keep track of two different distances. 70 05/02/10 16:31:05 31SEP610 0074 Multi-Information Display Outside Temperature 19 mph (30 km/h). When you start your trip, the sensor is not fully acclimatized, therefore it may take several minutes until the proper temperature is displayed. If the outside temperature is Instruments and Controls incorrectly displayed, you can adjust it up to±± 5°F ( 3°C) warmer or cooler. NOTE: The temperature must be SELECT/ stabilized before doing this RESET procedure. BUTTON Select the outside temperature display, then press the Select/Reset To reset a trip meter, display it, then This shows the outside Fahrenheit button for 10 seconds. The following press and hold the Select/Reset temperature in U.S. models, and sequence will appear for 1 second button until the number resets to Centigrade temperature in Canadian each:0,1,2,3,4,5,---- 5, 4, 3, 2, ‘‘0.0.’’ models. -1, 0, 1 (0, 1, 2, 3, --- 3, 2, 1, 0, 1). The temperature sensor is in the When it reaches the desired value, Both trip meters will reset if the front bumper. The temperature release the Select/Reset button. You vehicle’s battery goes dead or is reading can be affected by heat should see the new outside disconnected. reflection from the road surface, temperature displayed. engine heat, and the exhaust from In certain weather conditions, surrounding traffic. This can cause temperature readings near freezing an incorrect temperature reading (32°F, 0°C) could mean that ice is when your speed is under forming on the road surface. 71 05/02/10 16:31:17 31SEP610 0075 Multi-Information Display Engine Oil Life Maintenance Messages Have your dealer do the indicated maintenance as soon as you see this message, and have them reset the display after completing the service. If you do not perform the indicated maintenance or do not reset the display, the message changes to ‘‘SERVICE PAST DUE’’ when the engine oil life becomes 0%. These messages appear on the multi- information display each time you turn the ignition switch to ON (II). This shows the remaining life of the When the engine oil life reaches 15%, engine oil. It shows 100% after the the display shows ‘‘SERVICE DUE For details on engine oil life and engine oil is replaced and the display SOON’’ and the code for the maintenance messages, refer to page is reset. The engine oil life is maintenance items to be performed. 205 . calculated based on engine operating conditions and accumulated engine When the engine oil life reaches 5%, Also refer to page204 for important revolutions. the display shows ‘‘SERVICE DUE maintenance safety precautions. NOW’’ along with the same maintenance items. 72.