Wireless Barcode Scanner Manual

Wireless barcode scanner manual General instructions: Scanning gun without external power switch, simply press the Scan button to start the lamp is lit. After startup, if you do not press the Scan key case, over a period of time after the scan gun again automatically goes into sleep mode (power saving mode), the lamp goes out, the factory-set default enter the sleep time to 20 seconds. The user can modify the sleep time. Quickly into sleep mode (power saving mode): long press the scan button, scanning gun does not scan any barcode, long probably about four seconds, scanning gun into sleep mode (power saving mode), the light goes out. This fast sleep mode, the user is not allowed to modify. Normal scanning gun start will ring sound: the pitter - beep - drops. If you start to appear: drip - drip toot - drip drip...... (5 sound blew about 2 seconds) for the gun battery voltage low warning, low battery prompt, this case should be timely scan gun charge. USB plug receiver. Receiver inside a light is dark lights. When the receiver is powered on, the indicator light long bright 10 seconds, 10 seconds later twinkling. Scanning gun and receiver connection instructions: Plug in the host or device (your computer's USB port) is energized, the receiver will automatically enter the the channel matching set mode, this mode effective time of 10 seconds (10 seconds long bright light) after 10 seconds into the normal reception mode (indicator Twinkle, twinkle). The effective time setting mode 10 seconds have not set up as set fails, scanning gun on the crawl receiver. If you have previously used successfully paired, 10 seconds after a normal connection to use. Whether scanning gun receiver did not match the success of 10 seconds after the receiver lights are flashed on and off. Channel settings: ① plug the receiver into a computer USB port. ② , sweep ", channel settings (CHSET (%% TDSET)) bar code scanning gun. ③ , gun sweep "set parameters" two yards (the number of parameters for the two, an effective range of 01 to 20). The entire set with must be completed within 10 seconds, 10 seconds is set incorrectly, the scan gun buzzer will prompt an error tone. After the success of the channel settings, wireless gun can be connected using the generally exceptional circumstances "user ID set" and "Fourth, the sleep time is set" no longer need to set. User ID setting: [set this premise is successful channel settings to set.] ① , with a scan gun scanning "Second, the user ID is set under (IDSET (%% ID-SET)) bar code. ② , then sweep the two barcode ", set parameters", (the number of parameters for the two, with an effective range of 00 to 99). ③ If users want to display ID scan "user ID settings" (ID (% % ID-XS)) to display before in the bar code ID. If you do not want to show ID scan under "Second, the user ID is set (ID Hide (%% ID-YC)) can be hidden in the barcode before ID. The default user ID is hidden. Sleep time setting: (1) using a scanning gun Scan sleep time set under (SET (%% TIMSET)) bar code. ② , then sweep "sleep time set under a bar code, such as (30 seconds (%% TIM01)) and. Normal mode settings: This mode works: scanning gun sweep a code to instantly upload code to the receiver connected devices (such as computers). This mode scanning gun can be used to receive a successful connection. ① scanning gun sweep under the "normal mode" (%% PT-SET). The inventory mode settings: This mode works: scanning gun sweep one yards, not immediately uploaded to the device (such as a computer), but the first to be saved in the scan gun inside the user Saowan to sweep the code, and then uploaded to the device ( such as a computer). This mode, the scan code when not connected to the receiver, but when uploading data must be connected with receiver.