Vzor Dokumentu Pro Příspěvek STČ

PAPER TEMPLATE – PROCESS ENGINEERING 2012 (Times New Roman, Bold, 16, single spacing, center aligned, capital letters)

Title Name Surname (Times New Roman, Normal, 14, single spacing, centered)

Supervisor: Title Name Surname (Times New Roman, Normal, 14, single spacing, centered)

Affiliation address (university, faculty, department) and contacts (e-mail) (Times New Roman, Normal, 12, single spacing, center aligned)

Abstract (Times New Roman, Bold + Italic, 12, single spacing, left aligned) Place a short summary of your paper at the beginning. It should express briefly the purpose of the research and the main results and conclusions (Times New Roman, Italic, 12, single spacing, justified).

Keywords (Times New Roman, Bold + Italic, 12, single spacing) Place keywords separated by commas below the abstract (Times New Roman, Italic, 12, single spacing).

1. Section (Times New Roman, Bold, 12, single spacing, left aligned) The full text should be written on A4 paper size (297 x 210 mm) with all margins set to 2.5 cm. Use font Times New Roman, normal, 12 pt, single spaced and justified. Divide your article into clearly defined and numbered sections and subsections. Do not number pages. Place a gap 12 points above the section and subsection headings and 3 points below it. The paper should not exceed 20 pages in length.

1.1 Subsection (Times New Roman, Bold, 12, single spacing, left aligned) Do not skip any row above subsection headings. Please use just one level of subsections (i.e. 1.1, 1.2, etc. – no sub-subsections 1.1.1).

Table 1. –Table description (Times New Roman, Italic, 12, single spacing, justified above the table). The tables should be numbered in ascending order. I II III East 7 7 5 West 6 4 7 South 8 7 9 Sum 21 18 21

Skip one row above and below the table. Fig. 1. Figure description (Times New Roman, Italic, 12, single spacing, centred below the figure). The figures should be numbered in ascending order.

Skip one row above and below the figure. When equations will be used in the text, remember to their numbering:

D 2 S  (1) 4

Skip one row above and below the equation. Skip one row between two sections.

2. Conclusions Each work should contain summary of main conclusions. Below the conclusions, skip two lines and follow up with acknowledgement (if necessary), list of symbols and references (without numbering in headings).

Acknowledgement (Times New Roman, Bold + Italic, 12, single spacing, left aligned) Acknowledgement to supporting institutions or people may be presented here. Skip one line between Acknowledgement and Symbols.

Symbols (Times New Roman, Bold + Italic, 12, single spacing, left aligned) D shaft diameter (m) k coefficient (1) L shaft length (m) Greek letters  density (kg·m-3)

References (Times New Roman, Bold + Italic, 12, single spacing, left aligned) Please ensure that every reference cited in the text is also present in the reference list (and vice versa). Skip one line between Symbols and References.