Guidelines for Preparation a Two-Column Paper for an Engineering Journal s1

MS Word Template for PESA 2017 Conference Papers

Author1 E.E.1 Author2 E. F.2

1 Department of Electrical Engineering, The Hong Kong Polytechnic University, Hong Kong E-mail: [email protected] 2 Department of Electronic and Information Engineering, The Hong Kong Polytechnic University, Hong Kong E-mail: [email protected]

Abstract–This document contains the content and formatting 2. Format instructions for preparing a camera-ready paper for the The top, bottom, left and right margins are 1.8 cm. The international conference on PESA-2015. The length of an abstract is approximately 100 to 250 words. Difficult space between the two columns is 0.8 cm. Paper setting is principles should not be included here so as to ensure that 21cm (width) x paper (height) 29.7cm. Header: 1.27cm. non-experts in the same or related fields can understand. Footer: 1.27cm. There is no need to put citations or equations here. 3. Equations Keywords–Power converter, resonant converter, motor Equations are to put it in the center and its indication drives, vector control (Please provide a maximum of five number at the right. When two or more equations are keywords that describe the paper best). presented, they should be aligned according to the equal (=) or the inequality sign (<, >). An example is shown I. STYLE INFORMATION below:

In general, a good layout is more understandable and eye- di V  V L  in o (1) catching. The following gives you some hints: dt L  The title should be bolded and centered. There is no dv C c  i  I  f (R) (2) need to capitalize all the letters - just the first letter dt L o

of each word. However, there is no need to qM 1  d d  =  Jd(k - 1)tanh  Jd(k - 1)coth  capitalize the prepositions and conjunctions. V T q  M k=(q-1)M +1 2 2   The names(s) of the author(s) should also be (3) 1 qM 1 centered with the surname first, followed by first  2Jd(k - )tanh d M  2 name and initials. k=(q-1)M +1 Symbols in your equation should be defined before the II. TECHNICAL INFORMATION equation appears or immediately following. Use ‘(1),’ not Papers are usually submitted in both doc and pdf formats, ‘Eq. (1)’ or ‘equation (1),’ except at the beginning of a produced by Microsoft Word® and Adobe® Acrobat® sentence: ‘Equation (1) is …’. respectively. The pdf file is to help us to understand the page and section breaks whereas the doc format is to help 4. Figures style us to typeset into the symposium proceedings. The annotation of figures must be clear and large enough in size. This is especially important when the figure is 1. Type sizes generated automatically from another software package The font to be used is 10 points Times New Roman where the size of the annotation is small after it is inserted throughout the text, both sides justified. The following into a double-column paper. The reference to a figure may shows a typical font size of our proceedings. use “Fig. 1” rather than “Figure 1” because of concise requirements. The caption appears at the centre of the line Table 1: Font size and style of the text after a figure. Location of text Size Style Title 16 pts bold Name of the Author 11 pts regular Affiliation of the Author 9 pts regular Abstract or keywords 9 pts bold List of symbols 10 pts italics Main text 10 pts regular Equations 10 pts italics Section heading 10 pts SMALL CAPITAL Subsection heading 10 pts italics Figure caption 9 pts regular Table caption 9 pts bold Table text 9 pts regular Reference 9 pts regular Fig. 1: Examples of the annotation in a figure