The Wall Must Be Clean (No Dust, Dirt Or Grease), Dry, Even and Primed

Application Steps

Necessary tools

Wall preparation

 The wall must be clean (no dust, dirt or grease), dry, even and primed

 Temperature should not be below 8°C

Wall covering application

1. Fill the application machine with clean water

2. Pull the wall covering through the machine and cut one strip of wall covering according to the room height +10 cm Do not leave the wall covering in the water. Cut off and do not use any strip that stays in the water before preparing the next strip

3. Place the wallcovering strip on the wall vertically immediately after pulling it through water Do not wait more than10 min before applying the product

4. Smooth it with spatula or clean roller

5. Place the adjacent strip edge to edge

6. Repeat the points 1, 2, 3, 4 and 5 with other strips until you have finished the room

7. Cut off any surplus with a knife

8. Apply a first layer of acrylic paint (250 g / m2, +/-10 %) when the product is dry (~1 day)