SHOW US WHAT YOU’RE MAKING

spotlightstores #imadethis #getcreative

TAKE + MAKE PARTY LUCET & WORLD KNIT IN PUBLIC DAY PROJECT HEAD BAND Using double throughout, make two lengths of cord 18.18.29 in Orange and one length in Pink 45cm long. Sew the 3 lengths together with the wool needle and one of the yarn EASY colours sew the pieces together as a flat (see photo). To make the bow, make two lengths of Pink and one length of Orange 24cm long, sew together then tie ends together WHAT YOU’LL NEED creating a circle. Make one cord of Orange long enough to • 1 Fun Pack 100% Acryic Yarn 250gm go around the bow twice, tie on then sew the bow to the side of the headband at a 45o angle. Plait the remaining • Wooden Lucet ends together for the band as shown on photo. • Hook-optional • Scissors, wool needle

HOW TO USE THE LUCET Holding the Lucet in one hand thread the yarn through the middle hole from the back and hold in position in the front with the left thumb. Bring the yarn at the back of the Lucet from the back right, around the right prong, through the middle, around the back of the left prong and back to the middle. Wrap the yarn around the right prong again from the middle, around the back completely around the right prong finishing at the back and secure with the left fingers. There will now be 2 wraps of yarn around the right prong and one around the left. Lift the lower thread on the right prong up and over the prong using the crochet hook if required, flip the Lucet one half turn to the left and adjust and tighten the knot to sit comfortably. Wrap the yarn around the right prong completely from the middle to the CHAIN SCARF back, around the prong finishing at the back. Lift the lower Using double yarn make 8 lengths of 20cm in varying thread on the right prong up and over the prong, flip the colours. Join the first length by knotting then in Lucet one half turn to the left and adjust and tighten the the loose ends. Thread the second through the loop of the knot to sit comfortably. Continue until the work reaches the first and secure as first chain. Continue until all the lengths required length, cut the yarn, take the loops off the Lucet are used and close the circle by joining the last loop with the and thread the yarn through the loops and tighten. first and fasten off loose ends.

SHOE Using one yarn only, make 2 lengths of cord 50 cm long then fasten off. Thread through shoe eyelets, fasten off loose ends with the wool needle and tie.

The information on this project sheet is presented in good faith, but no warranty is given, nor results guaranteed. Quantities and selections may vary at each store. Copyright Spotlight 2018.