University of Mississippi eGrove Electronic Theses and Dissertations Graduate School 2015 Synthetic Materials with Redox-Triggers for Imaging and Drug Delivery Jungeun Bae University of Mississippi Follow this and additional works at: https://egrove.olemiss.edu/etd Part of the Chemical Engineering Commons Recommended Citation Bae, Jungeun, "Synthetic Materials with Redox-Triggers for Imaging and Drug Delivery" (2015). Electronic Theses and Dissertations. 20. https://egrove.olemiss.edu/etd/20 This Thesis is brought to you for free and open access by the Graduate School at eGrove. It has been accepted for inclusion in Electronic Theses and Dissertations by an authorized administrator of eGrove. For more information, please contact [email protected]. SYNTHETIC MATERIALS WITH REDOX-TRIGGERS FOR IMAGING AND DRUG DELIVERY A Dissertation presented in partial fulfillment of requirements for the degree of Doctor of Philosophy in the Department of Pharmaceutics and Drug Delivery The University of Mississippi by JUNGEUN BAE December 2015 Copyright © 2015 by Jungeun Bae All rights reserved. ABSTRACT Synthetic materials embedded with stimuli-responsive cleavable bonds have been extensively utilized for the development of site-targeted drug delivery system and selective imaging reporters. We developed stimuli-sensitive materials with two different redox switches including trimethyl-locked quinone propionic acid and nitrobenzyl moieties. Novel redox-sensitive polymeric nanoparticles and micelles were prepared from a synthesized monomer containing trimethyl-locked quinone propionic acid as a redox trigger. A hydrophobic cancer drug, paclitaxel, was incorporated into the redox- responsive polymeric nanoparticles and micelles prepared from the synthesize polymers. The effect of redox stress on the nanoparticles and micelles was evaluated with a chemical reductant, sodium dithionite demonstrating that the significant amount of paclitaxel was released at a simulated redox-state compared to the control. Cell viability studies revealed that the polymer was non-toxic and the nanoparticles and micelles could release paclitaxel to suppress breast cancer cell growth. In addition to the drug delivery system, a p-nitrobenzyl moiety redox trigger was utilized to develop a novel NIR fluorescent probe, p-nitrobenzyl 3,7-bis(dimethylamino)-10H-phenothiazine-10- carboxylate for the selective imaging and therapy. Conjugating methylene blue with a p- nitrobenzyl moiety enables it to quench electron transfer within the molecules. Moreover ii the redox trigger caged probe released active methylene blue by nitroreductase-mediated 1,6-elimination resulting exhibition of strong fluorescence (λmax = 680 nm) with the excitation at 580 nm. The fluorescence emission was also induced by incubation with live Escherichia coli bacteria. It was demonstrated that the NIR fluorescent probe generated singlet oxygen after nitroreductase mediated reduction with a laser irradiation at a wavelength of 634 nm. The redox trigger caged NIR fluorescent probe would be a suitable imaging sensor to detect bacteria expressing NTR. In addition, the probe also possesses potential as an MB prodrug which can be applied for the treatment of various diseases. iii DEDICATION This research work is dedicated to my loving family. iv LIST OF ABBREVIATIONS AND SYMBOLS ADEPT Antibody-directed enzyme prodrug therapy CB1954 2,4-dinitrobenzamide CFU Colony forming units CMC Critical micelle concentration DCM Dichloromethane DFMO α-difluoromethylornithine DI Deionized DLS Dynamic light scattering DMEM Dulbecco’s modified Eagle’s medium DOPE 1,2-dioleoyl-sn-glycero-3-phosphoethanolamine DPH 1,6-diphenyl-1,3,5-hexatriene E. coli Escherichia coli EPR Enhanced permeability and retention FBS Fetal bovine serum FMN Flavin mononucleotide GDEPT Gene-directed enzyme prodrug therapy GPC Gel permeation chromatography v GSH Glutathione IC50 Half maximum inhibitory concentration MB Methylene blue mPEG-PDLLA Monomethoxy poly(ethylene glycol)-block-poly(D,L-lactide) MWCO Molecular weight cut-off NAD(P)H Nicotinamide adenine dinucleotide phosphate NHS-QPA n-hydroxysuccinimidyl QPA NIR Near-infrared NMR Nuclear magnetic resonance NPs Nanoparticles NSCLC Non-small-cell-lung cancer NTR Nitroreductase OD Optical density PBS Phosphate-buffered saline PDI Polydispersity index PEG Polyethylene glycol PET Photoinduced electron transfer PLGA Poly(D,L-lactide-co-glycolid) Pluronic® Poly(ethylene glycol)-poly(propylene glycol)-poly(ethylene glycol) p-NBMB p-nitrobenzyl 3,7-bis(dimethylamino)-10H-phenothiazine-10-carboxylate PTX Paclitaxel PVA Polyvinylalcohol vi QPA Timethyl-locked quinone propionic acid RES Reticuloendothelial system RNO p-nitrosodimethylaniline RT Room temperature SEM Scanning electron microscope SD Standard deviation SRB Sulforhodamine B TEM Transmission electron microscopy THF Tetrahydrofuran TLC Thin layer chromatography UV Ultraviolet vii TABLE OF CONTENTS DEDICATION ................................................................................................................... iv LIST OF ABBREVIATIONS AND SYMBOLS ............................................................... v TABLE OF CONTENTS ................................................................................................. viii LIST OF FIGURES ........................................................................................................... xi CHAPTER 1 ....................................................................................................................... 1 1.1. Cellular redox microenvironments and therapeutic opportunities ........................... 3 1.2. Redox triggers .......................................................................................................... 4 1.2.1. Disulfide bond and glutathione ......................................................................... 4 1.2.2. Trimethyl-locked quinone propionic acid and DT-diaphorase ......................... 8 1.2.3. Nitrocompounds and Nitroreductase .............................................................. 13 1.3. Organization of the dissertation ............................................................................. 17 CHAPTER 2 ..................................................................................................................... 19 2.1. Introduction ............................................................................................................ 21 2.2. Experimental .......................................................................................................... 25 2.2.1.Materials .......................................................................................................... 25 2.2.2. Computational analysis ................................................................................... 25 2.2.3. Synthesis of monomer..................................................................................... 26 2.2.4. Synthesis of polymer....................................................................................... 31 2.2.5. Preparation of blank and PTX-loaded nanoparticles ...................................... 32 2.2.6. Characterization of blank and PTX-loaded NPs ............................................. 33 2.2.7. In vitro drug release studies ............................................................................ 35 2.2.8. Cell viability assay .......................................................................................... 36 viii 2.2.9. Statistical analysis ........................................................................................... 37 2.3. Results and Discussion .......................................................................................... 37 2.3.1. Computational analysis and polymer synthesis .............................................. 37 2.3.2. Synthesis of monomer and polymers .............................................................. 38 2.3.3. Preparation of redox-responsive NPs .............................................................. 42 2.3.4. In vitro paclitaxel release ................................................................................ 49 2.3.5. In vitro cytotoxicity ......................................................................................... 52 2.4. Conclusions ............................................................................................................ 55 CHAPTER 3 ..................................................................................................................... 57 3.1. Introduction ............................................................................................................ 60 3.2. Experimental .......................................................................................................... 63 3.2.1. Materials ......................................................................................................... 63 3.2.2. Synthesis of amphiphilic redox-sensitive polymer (polyQPA-mPEG750) .... 64 3.2.3. Characterization of polyQPA-mPEG750 ........................................................ 65 3.2.4. Preparation of polymeric micelles .................................................................. 66 3.2.4. CMC measurement ......................................................................................... 67 3.2.5. Particle size measurements and redox-responsive polymer degradation ........ 67 3.2.6. Redox-triggered QPA lactone release from polyQPA-mPEG750 micelles ... 68 3.2.7. In vitro drug release
Details
-
File Typepdf
-
Upload Time-
-
Content LanguagesEnglish
-
Upload UserAnonymous/Not logged-in
-
File Pages160 Page
-
File Size-