QUADRA FIRE PIT | Installation Manual D r e a m C a s t OUTDOOR FIRE PIT BURNER Design and Production Ltd. DANGER - IF YOU SMELL GAS STANDARDS: ⚠ CSA 2.41-2014, ANSI Z21.97-2014 1. Shut off gas to the appliance. CERTIFIED FOR USA & CANADA 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your OUTDOOR DECORATIVE gas supplier or fire department. GAS APPLIANCES ⚠ WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. ⚠DANGER CARBON MONOXIDE HAZARD This appliance can produce carbon monoxide which has no odor. Using it in an enclosed space can kill you. Never use this appliance in an enclosed space such as a camper, tent, car or home. We recommend that our fire pits ⚠ WARNING: be installed and serviced by pro - Improper installation, adjustment, alteration, service or maintenance can fessionals that are certified in the cause injury or property damage. Read the installation, operating and mainte - U.S. by NFI nance instructions thoroughly before installing or servicing this equipment. (National Fireplace Institute) ⚠ WARNING: FOR OUTDOOR USE ONLY! INSTALLER: Leave this manual with the appliance. CONSUMER: Retain this manual for future reference SAFETY INFORMATION QUADRA FIRE PIT | Installation Manual ⚠ WARNINGS: WARNING: Any modification to this appliance or its con - trols can be dangerous. 1. Turn the appliance off and let cool IMPORTANT: This appliance should 1. This appliance, as supplied, is only for use with the before servicing, installing, repairing or be inspected before use and at type of gas indicated on the rating plate. covering. Any guard or other protective least once annually by a qualified device removed for servicing the appli - service person. 2. When this appliance is connected to a fixed piping ance must be replaced prior to operat - More frequent cleaning may system, the installation must cconform with local codes or, in ing the appliance. Only a qualified be required as necessary. It the absence of local codes, with the National Fuel Gas Code, service person should install, service, is imperative that the control ANSI ZZ223.1/NFPA 54; National Fuel Gas Code, National or repair the appliance. Gas and Propane Installation Code, CSA B149.1; or Propane compartment, burners and Storage and Handling Code, CSA B149.2, as applicable.. circulating air passageways of the appliance be kept clean 3. Keep the appliance area clear and free from LOCAL CODES combustible materials, gasoline and other flammable Install and use your Outdoor Fire Pit DANGER: Carbon monoxide vapors and liquids with care. Follow local codes. In the ab - poisoning can lead to death! sence of local codes, use the latest 4. Do not burn solid fuel in this appliance. Do not use edition of The National Fuel Gas Code CARBON MONOXIDE POISONING: this appliance to cook food or to burn paper or other ANSI Z223.1/NFPA 54 available from: Early signs of carbon monoxide objects. poisoning resemble the flu, with American National Standards Institute Inc. symptoms including headache, dizzi - 5. Children and adults should be alerted to the 1430 Broadway New York NY 10018 hazards of high surface temperatures and should ness, or nausea. If you experience these stay away to avoid burns or clothing ignition. National Fire Protection Association,Inc. signs, the Fire Pit may not be working Batterymarch Park Quincy MA 02269. properly. Get fresh air at once! Have the 6. Clothing or other flammable materials should not Fire Pit serviced. Some people are more be hung from the appliance, or placed on or near Make certain you read and understand affected by carbon monoxide than oth - the appliance. all warnings. Keep this manual for refer - ers,including pregnant women, people ence. with heart or lung disease or anemia, 7. Young children should be carefully supervised those under the influence of alcohol, and when they are in the area of the appliance. those at high altitudes. 8. Do not use the appliance if any part has been under water. NATURAL GAS AND PROPANE: Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and To assist in detecting leaks, an odorant any gas control which has has been added to natural gas and been under water. propane. However, this odorant can fade, and gas may be present even though no 9. Inspect the appliance before each use odor exists. pg. 2 POSITIONING GAS SUPPLY QUADRA FIRE PIT | Installation Manual See page 8 of this manual for Gas Installation Requirements 15” The Quadra has an open base through which you can bring a gas or propane line. See Fig. 1. Please make sure that the gas line is located only within this area. This will 48” ensure that the final position of the unit will not be compromised. We recommend that gas risers be kept as low to grade as possible and no higher than 6” at their highest points. ATTENTION: 14” Gas line must be installed by a 36” licensed contractor in compliance 30” with local codes. FIG 1. PLAN AND VERTICAL SECTION pg.3 PLACEMENT AND ASSEMBLY QUADRA FIRE PIT | Installation Manual ATTENTION: Fragile! Concrete may chip or scratch if collided with other hard materials such as stone, metal, or other concrete. HANDLE WITH CARE! CAUTION: 1. Please refer to ‘Clearances to Combustibles’ guide on page 6 of this guide for placement. HEAVY: Use care when lifting and placing to avoid injury 2. Ensure that the final location for the fire pit is as flat and level as possible. Also provide and damage to property and adequate drainage beneath the opening in the base of the fire pit body. the fire pit itself. 3. Completely unpack the fire pit. Fire pits will require 2 or more 4. Carefully lift the fire pit base and place it in its final position. If there is a gas riser, fire pit people to lift. base should be placed so that the stub is enclosed within the fire pit body (3). 5. If the fire pit base does not sit level, shim appropriately so that it is level and evenly sup - ported. 6. Connect to Natural Gas or Propane Source as per page 9 of this manual. 7. Place the concrete top on the body, place the ventilation pan and assemble Burner as per instructions on page 7. 8. Check for leaks and test burner (see page 9 and 12). 9. Cover with Decorative Topping media as per instructions onpage 8. pg.4 COMPONENTS QUADRA FIRE PIT | Installation Manual 1.Burner1.Burner 2. VVentilationentilation PPanan 3. CConcreteoncrete TTopop 4. CConcreteoncrete Base 5. FlangeFlange FIG. 2. Firepitl - Exploded pg.5 CLEARANCE TO COMBUSTIBLES QUADRA FIRE PIT | Installation Manual FIG 3. MINIMUM CLEARNACES TO COMBUSTIBLES pg.6 BURNER ASSEMBLY QUADRA FIRE PIT | Installation Manual WARNING: TO ASSEMBLE THE BURNER Quadra Fire Pit Includes: Failure to position parts in - Key Way valve & connectors accordance with these diagrams 1. Connect the Burner Assembly to the gas/propane supply - Burner and instructions and/or failure to using the supplied flex connector and following the - Steel ventilation Pan use parts specifically approved instructions on page 9. - Lava rock for use with this appliance may result in property damage or 2. Carefully leak test all connections following the procedure personal injury. on page 8. 3. Fill the burner pan evenly with burner media fully covering IMPORTANT: Media affects burner ring. Media should be level with the top rim of the pan. flame pattern greatly. It is pos - CAUTION: sible to create an unusual Do not remove the metal data 4. Follow the Initial Lighting Instructions on page 12. flame pattern that could dam - plates attached to the Outdoor Make sure that the flame carries to all parts of the age your concrete firepit. Fire Pit Burner. These plates burner. Turn OFF the appliance and let it cool before Concrete damage from an contain important information. proceeding to the next step. open flame fire feature is not covered under any warranty. 5. Place and evenly distribute decorative topping (crushed glass or lava rock) on top of burner media. An uneven or ex - NOTICE: cessively thick layer of topping can result in an uneven flame. Installation and repair should be done by a qualified service 6. Do not use any media not supplied by the manufacturer person. The appliance should be inspected before use and at least once annually by a qualified service person. More frequent cleaning may be required as necessary. It is imperative that control compartment, burner and circulating air passageways of the appliance be kept clean. Typical Flame Pattern: pg.7 MEDIA SECTION QUADRA FIRE PIT | Installation Manual Burner without Media Lava Only Application Glass Media Application Apply lava rock ONLY deep enough to cover ring Fill Pan with glass. Cover Burner with 1/8 and pan less than 2” above fire ring. to ¼” of glass. Do not over fill with glass. CONNECTING TO GAS SUPPLY ⚠ WARNING: A qualified service person must connect the appliance to the gas supply. Follow all local codes. CAUTION: Use only new black iron or steel pipe.Internally tinned copper tubing may be used in certain areas. Use pipe of 1/2” diam - eter or greater to allow proper gas volume to Outdoor Fire Pit Burner. If pipe is too small, undue loss ofpressure will occur. INSTALLATION ITEMS NEEDED: • piping (check local codes) Before installing the Outdoor • sealant Fire Pit, make sure you have all items • manual shutoff valve listed bellow: • adjustable (crescent) wrench or pliers • sediment trap • tee joints • pipe wrench pg.8 CONNECTING TO GAS SUPPLY QUADRA FIRE PIT | Installation Manual CHECKING GAS CONNECTION INSTALLATION REQUIREMENTS ⚠WARNING: Test all gas piping and connec - Installation must include a manual shut - tions for leaks after installing or servicing.