Nonlinear Tunneling of Surface Plasmon Polaritons in Periodic Structures Containing Left-Handed Metamaterial Layers

Nonlinear Tunneling of Surface Plasmon Polaritons in Periodic Structures Containing Left-Handed Metamaterial Layers

Hindawi Publishing Corporation Advances in Condensed Matter Physics Volume 2015, Article ID 343864, 5 pages http://dx.doi.org/10.1155/2015/343864 Research Article Nonlinear Tunneling of Surface Plasmon Polaritons in Periodic Structures Containing Left-Handed Metamaterial Layers Munazza Zulfiqar Ali Physics Department, Punjab University, Quaid-i-Azam Campus, Lahore 54590, Pakistan Correspondence should be addressed to Munazza Zulfiqar Ali; [email protected] Received 3 September 2015; Accepted 30 November 2015 Academic Editor: Rosa Lukaszew Copyright © 2015 Munazza Zulfiqar Ali. This is an open access article distributed under the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited. The transmission of surface plasmon polaritons through a one-dimensional periodic structure is considered theoretically by using the transfer matrix approach. The periodic structure is assumed to have alternate left-handed metamaterial and dielectric layers. Both transverse electric and transverse magnetic modes of surface plasmon polaritons exist in this structure. It is found that, for nonlinear wave propagation, tunneling structures are formed to transform nontransmitting frequencies into transmitting frequencies and hence transmission bistability is observed. It is further observed that the structure shows sensitivity with respect to the polarization of the electromagnetic field for this phenomenon. 1. Introduction (TE) and transvers magnetic (TM) modes can exist here. The existence and tunneling of SPPs in different type of periodic As soon as metamaterials touched the optical regime, they structures is also being studied [5, 25]. Models are under havestartedtointerferewiththefieldofplasmonics. consideration to transfer these states along specific structures Plasmonics is concerned with the unique properties and [26, 27]. Future photonics exploiting the properties of surface applications of surface plasmon polaritons (SPPs), that is, plasmon polaritons will require nonlinear components such electromagnetic excitations that exist at interface between as switching devices. Optical switches are based on optical two media and decay exponentially away from the interface. bistability and play an important role in nonlinear optics. Conventionally SPPs are studied at the interface between Different theoretical models in micro- and nanoscales for metal and dielectric due to strong coupling between light and bistable behavior of propagating waves have been studied free electrons of metal [1–7]. The main interest in SPPs arises previously [28, 29]. Now new avenues are being explored due to its unique properties such as its ability to overcome by combining optically nonlinear materials with plasmonic the diffraction limit at the nanometer scale, subwavelength materials[30,31],andstillthisisanareathatneedsmore confinement, and strong field enhancement. The fundamen- attention. tal and applied research in this field has grown tremendously Here we are concerned with the nonlinear tunneling because of its promising applications in optics, data storage, phenomenon of SPPs in a periodic structure composed of sensors, and so forth [8–12]. Recent studies have revealed the alternate left-handed metamaterial and dielectric layers. Both existence of SPPs at the interface between dielectric and left- the TE and TM modes are studied here. By using the transfer handed metamaterials (LHM) [13–17]. Left-handed metama- matrix approach [32, 33], the transmission coefficient of terials are artificial composites having simultaneous negative thestructureiscalculatedandelectricfieldprofileswithin value of electric permittivity and magnetic permeability in a thestructureareplotted.Itisobservedthatifoneofthe certainfrequencyrange[18–22].Thesestructureshavebeen layers of the periodic structure is considered to be nonlinear, experimentally realized in microwave and infrared range the decaying states become the tunneling states and the [23, 24]. The main advantage of studying SPPs at the LHM- phenomenon of optical bistability can be observed. This phe- dielectric interface is the fact that both the transverse electric nomenon is broadly used in optical storage, optotransistors, 2 Advances in Condensed Matter Physics y Wearelookingforsolutionsthatarelocalizedattheinterfaces and decay away from the interfaces, so = +, (3) x z where Figure 1: The schematic diagram of the structure under consider- 2 2 = (2 −2 )=1,2. ation; shaded layers represent the LH layers whereas white layers 2 (4) represent RH layers. In the above expressions and areassumedtoberealand resonators, and all optical switches. This phenomenon has positive. recently been studied in a special configuration for surface The condition for the existence of SPP can be written as plasmons polaritons [34]. follows [33]: For TM mode, 2. Mathematical Model 1 + 2 =0. We consider a periodic structure containing alternate left- (5a) handed metamaterial (LHM) and dielectric layers (these 1 2 are termed here as right-handed material (RHM) layers) as schematically shown in Figure 1. The left-handed meta- For TE mode, materials are inherently lossy and dispersive. The electric 1 2 permittivity “ ”andmagneticpermeability“ ”oftheleft- + =0. (5b) handed metamaterial can be described by the Drude model 1 2 [21, 22]. The structure parameters are defined as follows: For LHM layer, Using (4) and (5a) and (5b), one has the following: 2 For TM mode, =1− pe , 1 2 + (2/2) (1 − / ) (1a) 2 2 1 1 1 2 2 1 2 = = SSP (1 − 2/2) =1− pm . 1 2 1 2 + (6a) (2/2) ( / −1) = 2 2 2 1 1 2 . 2 2 For RHM layer, (2/1 −1) 2,nl =2 +, (1b) For TE mode, 2 =1. (2/2) (1 − / ) 2 2 1 1 2 1 1 2 = = In the above expressions, is the frequency of incident SSP (1 − 2/2) 1 2 radiation, pe and pm are the plasma electric and plasma (6b) magnetic frequencies, is the damping coefficient, is the 2 2 ( / )22 (12/21 −1) nonlinear Kerr coefficient, and is the intensity of incident = . (2/2 −1) radiation. 2 1 The electric and magnetic fields in the given geometry (Figure 1) can be written as follows: The value of normal component is obtained by substitut- For TM mode, ing from (6a) and (6b) into (4). Since the permittivity of the dielectric layer is considered ⃗ = (0, ,0)exp ( − ) , to exhibit Kerr type nonlinearity, the program used for (2a) the computational work calculates the value of nonlinear ⃗ =(,0,) exp ( − ) . permittivity inside the dielectric layer by using expression given in (1b). In the transfer matrix approach the tangential For TE mode, components of the electric and magnetic fields across the interface are related as ⃗ =(0, ) exp ( − ) , 11 12 (2b) ( ) =( )( ) , (7) = (0, ,0) (⃗ − ) . exp =0 21 22 = Advances in Condensed Matter Physics 3 1 1 0.8 0.8 0.6 0.6 T T 0.4 0.4 0.2 0.2 0 0 0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 0 0.1 0.2 0.3 0.4 0.5 0.6 0.7 W W (a) (b) Figure 2: The transmission coefficient versus the frequency plots for (a) TM mode and (b) TEmode. where analysis. Absorption only reduces transmission coefficient, so qualitatively same results are expected in the absorbing for TM mode, structures. From Figures 2(a) and 2(b), it is obvious that initially, for both TE and TM modes, there is no transmission = = ( ), 11 22 cos across the structure, but, for certain frequency regions, the transmission coefficient becomes nearly unity. As these states − = ( ), decay exponentially away from the interface, within the 12 sin (8a) layers, the modes are decaying modes. The existence of the propagating region can be explained by the tight binding 21 = sin ( ); model of the solid state physics [35]. The phenomenon is similar in nature to the origin of propagation modes in a periodic structure consisting of single negative material layers for TE mode, [31] with the difference that, in the present case, the fields get localized at each interface of the periodic structure along the 11 =22 = cos ( ), -axis. For the nonlinear wave propagation, particular nonprop- − agating frequencies (i.e., 0.28 for the TM mode and 0.36 12 = sin ( ), (8b) for the TE mode) near the edge of the propagating regions are chosen. The transmissivity versus the intensity curves at these particular frequencies for the nonlinear case are = ( ). 21 sin shown in Figures 3(a) and 3(b). The dimensionless Kerr coefficient istakentohavethevalueof+1.Thephenomenon of transmission bistability is seen here but a comparison In this approach, working through layer by layer the electric of part (a) and part (b) reveals the fact that although the field at the transmitted end is calculated for an assumed electric and magnetic plasma frequencies are chosen to be incident electric field and the transmission coefficient the same, the structure shows sensitivity with respect to of the structure is calculated by using the expression = 2 2 the polarization of the electromagnetic field. The horizontal || /|| . scales of these two figures show that the intensity at which bistability phenomenon is observed for the TM mode is 3. Results and Discussions two orders of magnitude smaller than that value for the TE mode. Further it is observed that multiple bistability Initially we have taken =0in (1b) and plotted the is observed for the TM mode whereas the phenomenon transmissivity versus frequency plot for both TM and TE occurs only once for a considerable scale of intensity for modes for linear wave propagation in Figure 2. The periodic the TE mode. The electric field profiles inside the structure structure under consideration consists of 20 layers. As usual at intensities corresponding to maximum transmission are we are working here with dimensionless units, frequencies shown in Figures 4(a) and 4(b). These profiles show that the are normalized using =/,where is dimensional light is tunneling through the structure to get out of it. For the frequency, is the width of the period, and is the velocity TM mode, the profile corresponds to two solitons formation of light. So the choice of working frequency depends on the at the second transmission peak of the bistability curve and dimensions of the structure under consideration.

View Full Text

Details

  • File Type
    pdf
  • Upload Time
    -
  • Content Languages
    English
  • Upload User
    Anonymous/Not logged-in
  • File Pages
    6 Page
  • File Size
    -

Download

Channel Download Status
Express Download Enable

Copyright

We respect the copyrights and intellectual property rights of all users. All uploaded documents are either original works of the uploader or authorized works of the rightful owners.

  • Not to be reproduced or distributed without explicit permission.
  • Not used for commercial purposes outside of approved use cases.
  • Not used to infringe on the rights of the original creators.
  • If you believe any content infringes your copyright, please contact us immediately.

Support

For help with questions, suggestions, or problems, please contact us