Draft ETSI EN 302 288-1 V1.1.1 (2004-03) European Standard (Telecommunications series) Electromagnetic compatibility and Radio spectrum Matters (ERM); Short Range Devices; Road Transport and Traffic Telematics (RTTT); Short range radar equipment operating in the 24 GHz range; Part 1: Technical requirements and methods of measurement 2 Draft ETSI EN 302 288-1 V1.1.1 (2004-03) Reference DEN/ERM-TG31B-002-1 Keywords radar, radio, testing, SRD, RTTT ETSI 650 Route des Lucioles F-06921 Sophia Antipolis Cedex - FRANCE Tel.: +33 4 92 94 42 00 Fax: +33 4 93 65 47 16 Siret N° 348 623 562 00017 - NAF 742 C Association à but non lucratif enregistrée à la Sous-Préfecture de Grasse (06) N° 7803/88 Important notice Individual copies of the present document can be downloaded from: http://www.etsi.org The present document may be made available in more than one electronic version or in print. In any case of existing or perceived difference in contents between such versions, the reference version is the Portable Document Format (PDF). In case of dispute, the reference shall be the printing on ETSI printers of the PDF version kept on a specific network drive within ETSI Secretariat. Users of the present document should be aware that the document may be subject to revision or change of status. Information on the current status of this and other ETSI documents is available at http://portal.etsi.org/tb/status/status.asp If you find errors in the present document, send your comment to: [email protected] Copyright Notification No part may be reproduced except as authorized by written permission. The copyright and the foregoing restriction extend to reproduction in all media. © European Telecommunications Standards Institute 2004. All rights reserved. DECTTM, PLUGTESTSTM and UMTSTM are Trade Marks of ETSI registered for the benefit of its Members. TIPHONTM and the TIPHON logo are Trade Marks currently being registered by ETSI for the benefit of its Members. 3GPPTM is a Trade Mark of ETSI registered for the benefit of its Members and of the 3GPP Organizational Partners. ETSI 3 Draft ETSI EN 302 288-1 V1.1.1 (2004-03) Contents Intellectual Property Rights................................................................................................................................6 Foreword.............................................................................................................................................................6 1 Scope ........................................................................................................................................................7 2 References ................................................................................................................................................7 3 Definitions, symbols and abbreviations ...................................................................................................8 3.1 Definitions..........................................................................................................................................................8 3.2 Symbols..............................................................................................................................................................9 3.3 Abbreviations ...................................................................................................................................................10 4 Technical requirements specifications ...................................................................................................11 4.1 Presentation of equipment for testing purposes................................................................................................11 4.1.1 Choice of model for testing ........................................................................................................................11 4.2 Mechanical and electrical design......................................................................................................................11 4.3 Auxiliary test equipment ..................................................................................................................................11 4.4 Interpretation of the measurement results ........................................................................................................11 5 Test conditions, power sources and ambient temperatures ....................................................................12 5.1 Normal and extreme test conditions .................................................................................................................12 5.2 External test power source................................................................................................................................12 5.3 Normal test conditions......................................................................................................................................12 5.3.1 Normal temperature and humidity..............................................................................................................12 5.3.2 Normal test power source ...........................................................................................................................12 5.3.2.1 Mains voltage........................................................................................................................................12 5.3.2.2 Other power sources..............................................................................................................................12 5.4 Extreme test conditions ....................................................................................................................................13 5.4.1 Extreme temperatures .................................................................................................................................13 5.4.1.1 Procedure for tests at extreme temperatures..........................................................................................13 5.4.1.2 Extreme temperature ranges..................................................................................................................13 5.4.2 Extreme test source voltages.......................................................................................................................13 5.4.2.1 Mains voltage........................................................................................................................................13 5.4.2.2 Other power sources..............................................................................................................................13 6 General conditions..................................................................................................................................13 6.1 Test fixture .......................................................................................................................................................13 6.1.1 Radio equipment operating in the 21,625 GHz to 26,625 GHz band .........................................................13 6.1.2 Calibration ..................................................................................................................................................14 6.1.3 General requirements for RF cables............................................................................................................16 6.1.4 Schielded anechoic chamber.......................................................................................................................16 7 Methods of measurement and limits for transmitter parameters ............................................................18 7.1 Methods of measurement and limits for transmitters in the 21,625 GHz to 26,625 GHz band........................18 7.1.1 Permitted range of operating frequencies ...................................................................................................18 7.1.1.1 Definition ..............................................................................................................................................18 7.1.1.2 Method of measurement........................................................................................................................18 7.1.1.3 Limits ....................................................................................................................................................19 7.1.2 Maximum radiated average power density (e.i.r.p.) ...................................................................................19 7.1.2.1 Definition ..............................................................................................................................................19 7.1.2.2 Method of measurement........................................................................................................................19 7.1.2.3 Limits ....................................................................................................................................................20 7.1.3 Maximum radiated peak power density (e.i.r.p.) ........................................................................................21 7.1.3.1 Definition ..............................................................................................................................................21 7.1.3.2 Method of measurement for 21,625 to 24,05 GHz and 24,25 to 26,625 GHz.......................................21 7.1.3.2.1 Standard procedure and setup extensions ........................................................................................22
Details
-
File Typepdf
-
Upload Time-
-
Content LanguagesEnglish
-
Upload UserAnonymous/Not logged-in
-
File Pages46 Page
-
File Size-