TEKKEN 4 Game PC Board Kit l To ensure safe operation of the product, be we to read this Operatim Manual before use. l Keep this Operation Manual in a safe place for quick access. NAMCO AMERICA INC Read PRECAUTIONS and INSTALLATION Sections before operating game Note: This equipment uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense. No part of this publication may be reproduced by any mechanical photographic, or electronic process, or in the form of a phonographic recording, nor may it be stored in a retrieval system, transmitted, or otherwise copied for public or private use, without permission from NAMCO AMERICA INC. INTRODUCTION Thank you for purchasing the Tekken 4 Game PC Board Kit (hereafter referred to as “the product”). This operation manual describes: 0 How to operate the product correctly and make full use of its features 0 How to conduct the following procedures safely 0 installation and connection of the product to a general-purpose game ma- chine cabinet (hereafter referred to as “the cabinet”) 0 Adjustment for operation 0 Operation 0 Inspection, cleaning and troubleshooting 0 Removal, storage and transportation 0 Disposal Inquiries concerning the product and repairs 0 For further information about the product and repairs, contact your distributor. You are hereby notified that this product (PC board) falls within the scope of national export control regulation according to the Foreign Exchange and Foreign Trade Control Law. The prod- uct must not be taken out of Japan without permission of the Minister of Economy, Trade and Industry, except in a special case specified by the Law (as of June 27,ZOOl). MAG ICGATE is a term to describe a copyright protection technology created by Sony Group. This MAGICGATE mark does not necessarily guarantee compatibility with other products bearing the “MagicGate” trademark. MAGICGATE is a trademark of Sony Corporation. The DVD-ROM supplied with the product must not be copied, modified, distributed, or used for purposes other than the operation of the product. Copyright laws pro- tect the contents of the DVD-ROM. Infringement of copyright laws may be subject to criminal penalties. Do not use the supplied DVD-ROM with other product models or other media for- mats. Doing so may result in equipment failure. JULY,2001 Dear Customers, Thank you for purchasing the TEKKEN 4 PCB kit. This notice to inform you that the Dongle in this kit is not installed in the PCB Rack assy. Please follow the following instructions tu make sure that the dongles are fitted properly to the PCB. Best regards Dongle adjustments-To be conducted by technicians only r3m *The dongle included in this kit, is limited in usage for this product only. Please DO NOT insert the dongle in other games. Inserting dongles to other products may cause defects. *Please make sure that the power is turned off before inserting the dongle. 1 . Loosen the screws (round head philip screws M3 x 6) and remove the Dongle cover. 2 . Insert the dongle in the slot located on the left side, make sure that the barcode label on the dongle is facing up, and then press the dongle in until you have confirmed that the dongle has been locked with the connector properly. 3 When finished refit the dongle cover using the screws (round head philip screws M3 x 6) that were attached to the cover. Round head philip screws M3x6 / / I. SAFETY PRECAUTIONS. Be sure to read these instructions to ensure safety- Instructions to the owner: l If you entrust another party to perform installation, connection, adjustment, operation, inspec- tion, cleaning, troubleshooting, removal, storage, transportation or disposal of the product, in- struct the concerned party to read and observe all the instructions and precautions in this opera- tion manual regarding the particular action to be taken. 0 When transferring the ownership of the product, be sure to provide this operation manual to- gether with the PC board kit. l-l Magnitudes of risk On labels and in this operation manual, safety precautions and property damage are classified as listed below in accordance with the magnitude of the particular risk. AWARNING : Failure to avoid the risk may result in death or serious injury. A CAUTION : Failure to avoid the risk may result In minor injury. Functional notes not related to safety are marked with the following label: Bm : Notes related to a function or protection of the product 1-2 Target readers of this operation manual This operation manual is written for arcade personnel. However, the sections marked “To be conducted by a technician only” in the table of contents and with the section titles are written for technicians. These tasks must be conducted by technicians only. Technician: A person engaged in machine design, manufacture, inspection or maintenance for a manufacturer of amusement equipment, or a person who has technical knowledge related to electricity, electronics or mechanical engineering at a level equal to or higherthan that of technical high school graduates, and who is engaged routinely in maintaining (repairing) amusement equip- ment. 1 I. SAFETY PRECAUTIONS - Be sure to read these instructions to ensure safety - I-3 Top-priority safety precautions 1-3-I General precautions I &VARNING 0 Do not disassemble or modify the product. Also never perform work not described in this operation manual. Failure to observe this caution can result In an electrical shock or fire, and may disallow you from receiving repair services. 0 The product is designed for indoor use only. Do not install, connect or operate the product outdoors. Installation, connection or operation of the product conducted outdoors can cause an electrical shock or fire. 0 Use only the specified parts fo replace consumable and service parts (including screws). Use of other parts can result in a fire or electrical shock. To order parts, contact your distributor. 0 Do not perform work with wet hands to prevent an electric shock. 0 Before installing, connecting, inspecting, cleaning, troubleshooting, or removing the product, turn off the power switch on the cabinet, and unplug the power cord from the service outlet to prevent an electrical shock. l-3-2 Safety precautions for installation and connection I &VARNING Connection to JAMMA STANDARD conforminq cabinet (JAMMAW PC board kit (optional) is required) 0 The power supplied from the cabinet connected to the JAMMA edge connector must comply with the following specifications. * +5V power supply - allowed voltage fluctuation *5%, current: 7 A or higher l +lZV power supply - allowed voltage fluctuation +5%, current: 2 A or higher Use of non~conforming power supply can cause a fire. Connection to JAMMAVIDEO STANDARD(JVS) conformins cabinet l The power supplied from the cabinet connected to the power cord must comply with the following specifications. l +5V power supply - allowed voltage fluctuation *5%, current: 7 A or higher l +12V power supply - allowed voltage fluctuation +5%, current: 2 A or higher Use of non-conforming power supply can cause a fire. 2 1. SAFETY PRECAUTIONS - Be sure to read these instructions to ensure safety. I-3-3 Cautions in operation I AWARNING l Should any problem occur, such as an abnormal odor or noise, turn off the power switch on the cabinet immediately to stop the machine operation. Then, unplug the power cord from the service outlet, and contact your distributor. Operating the .~IYYII.II”msrhina .uri+h . ..I. su nrnhlnmf,‘““‘...,. Id+I*,. ,,nr~rm,.+,w,YIIUUIII”...” mst,“W, “““IIPC.IICI “IIin Il~s,.ll”Yl.In,.+.ir.l lll”Yl.chmrlr “Inr .,,r.ii.,, l Make sure that the product has been installed and connected according to the directions (refer to P. 9 “5. Installation and Connection”) in this operation manual before operating. Incorrect installation or connection can cause a fire, electrical shock or malfunction. l-3-4 Cautions for disposal AWARNING 0 Never throw the product into flames. The lithium battery contained in the product can explode and cause injuries. l When discarding the product, be sure to collect, transport and dispose of the product according to the law. l When entrusting another party to collect, transport and dispose of the product, be use to use a company specializing in the particular work to be assigned. 3 CONTENTS INTRODUCTION 1. SAFETY PRECAUTIONS - Be sure to read these instructions to ensure safety -............................. 1 l-l Magnitudes of risk ......................................................................................................................................... 1 l-2 Target readers of this operation manual ........................................................................................................ 1 l-3 Top-priority safety precautions ..................................................................................................................... ,2 I-3-1 General precautions ............................................................................................................................. 2 l-3-2 Safety precautions for installation and connection ............................................................................... 2 i-3-3 Cauttonstnoperation ... ........ ..................... 1;. .... .Z.. .......;...Y ..I.. .... ................ Z.