<p>Multiview Projection Worksheet</p><p>Name:______</p><p>1. A normal edge is a line that is ______to the plane of projection.</p><p>2. In theory, the lines of sight are considered to be ______.</p><p>3. The plane of projection on which the top view is projected is called ______</p><p>4. What can the draftperson do to minimize confusion between first and third angle projection?</p><p>______</p><p>5. There are three methods to transfer depth dimensions, Name them:</p><p> a.______b.______c.______</p><p>6. There are four steps to placement of views in Mechanical drawing. Name them:</p><p>7. What is the major reason to use revolution conventions in drafting? ______</p><p>8. (True False) An experienced designer or engineer will usually look at a multiview drawing and </p><p> instantly and easily visualize the object represented.</p><p>9. A straight line always projects as a ______or as a ______.</p><p>10. The single view of an object will frequently permit a multitude of different interpretations. What is</p><p> needed to limit these interpretations? ______</p><p>11. A plane surface, parallel to a plane of projection is termed as ______.</p><p>12. Imagine view of a cylinder being cut by an inclined plane. If the this cut appears as a straight inclined</p><p> line in the front view, how will it appear in : the top view: ______</p><p> the right side: ______</p><p>13. At what point above is a line missing? ______</p><p>14. What angle is angle A typically drawn at? ______</p><p>15. What angle is angle B typically drawn at? ______</p><p>16. Define "runout" </p>