<p> Solar Keymark Physical Inspection</p><p>Report reference:</p><p>SKN_N0122R0</p><p>Checks and controls for solar collectors</p><p>– Initial Type Test (Reference) –</p><p>Test Date: Test Report: Drawings: Model: Collector classification Collector type  Flatplate  ETC  unglazed  PVT  ……..</p><p>– Physical inspection – Result of inspection Conformity Yes/No</p><p>Absorber . Material(s) . Thickness . Joining technique . Surface treatment / coating . Material of fluid channels . Spacing of fluid channels . Type/geometry of tubing . Dimensions (length / width) . Manufacturer . . . Glazing(s) . Material . Thickness . Structure . Manufacturer . Coating . Structure inside / outside . . .</p><p>Solar Keymark Physical Inspection, collectors Page : 1/3 Solar Keymark Physical Inspection</p><p>Report reference:</p><p>SKN_N0122R0</p><p>Result of inspection Conformity Yes/No Casing . Dimension (Length / Width / Height) . Material(s) of frame elements . Shape / Cross section of the profiles . Material of rear panel . Gaskets at hydraulic conections . Gaskets and sealing for the casing . . Insulation . Material(s) . Manufacturer(s) . Rear insulation (thickness coating) . Side insulation (thickness coating) . . Hydraulic connection . Dimensionen . Typ . . Labels and documentation . Label (check conformity) . Installer manual (check conformity) . . Others . Ventilation concept . Mounting parts . Reflectors (shape / material) . Heat transfer sheets . Heat Pipes . . . .</p><p>Solar Keymark Physical Inspection, collectors Page : 2/3 Solar Keymark Physical Inspection</p><p>Report reference:</p><p>SKN_N0122R0</p><p>Result of inspection Conformity Yes/No Major failures according to the EN12975-1 Chap 5.3.1</p><p>Comments and Remarks</p><p>Result. Conformity rating of the inspected product with the initially tested type</p><p>Degree of deviation Decision / Recommended action</p><p>No Deviations OR Deviations which have Continue certification if all other conditions are 1 been approved by the certifier upon acceptable notification of the manufacturer.</p><p>Limited number of minor deviations. Manufacturer has to inform the certifier about the Conformity is acceptable but the certifier technical modifications. Based on this assessment 2 has to be informed about the deviations it is recommended to accept these modifications. found. Continue certification.</p><p>Certification shall be declared void. To reanimate the certificate one of the following actions followed Major deviations. The product can’t be 3 by another Physical inspection is recommended: considered the same anymore. - Partial Retest to approve the design changes - Revert to the initial design</p><p>Place / Date</p><p>Test Lab</p><p>Name</p><p>Signature</p><p>Solar Keymark Physical Inspection, collectors Page : 3/3</p>