List 1List 1 Approved Steelmakers and Manufacturers of Rolled Steel Plates, Strip, Sections & Bars This list identifies works approved by Lloyd’s Register Group Limited (LR) for steelmaking and the manufacture of rolled steel plate, strip, sections and bars in accordance with the requirements of LR's Rules for the Manufacture, Testing and Certification of Materials, Chapter 3. The information listed for each works is a summary of the product, generic grade and maximum thickness, or in the case of round bars, diameter approved. It is important to note that this list does not provide full details of the grades approved by LR as required by the Rules. The combinations of deoxidation practice (e.g. killed, semi-killed), micro-alloying and grain refining additions (e.g. Al, Al + Nb Al + Nb + V, etc.), in association with specific rolling procedures ( e.g. N or TM, etc.), are not included. These parameters may vary within each grade by manufacturer and could influence the fabrication procedures that can be applied. The list also includes firms approved for the manufacture of fabricated steel sections. Where required this information should be obtained from the current certificate of approval issued to the manufacturer by LR. Works designated "MQS Approved" are also approved under the Materials Quality Scheme in accordance with LR's Rules for the Manufacture, Testing and Certification of Materials, Chapter 1 Section 2. Approval only covers the manufacturing location listed, it does not extend to other works owned by the same company. The local LR surveying office is also listed. Abbreviations: B.O.S. Basic Oxygen Steelmaking Con Cast Continuous Casting E.A.F. Electric Arc Furnace O.H. Open Hearth Lloyd's Register Group Limited, its affiliates and subsidiaries and their respective officers, employees or agents are, individually and collectively, referred to in this clause as 'Lloyd's Register'. Lloyd's Register assumes no responsibility and shall not be liable to any person for any loss, damage or expense caused by reliance on the information or advice in this document or howsoever provided, unless that person has signed a contract with the relevant Lloyd's Register entity for the provision of this information or advice and in that case any responsibility or liability is exclusively on the terms and conditions set out in that contract. As at 13 May 2014 This is a copy of an electronic document. In the event of any conflict or ambiguity between the copy and the electronic document, © Lloyd’s Register Group Limited 2014. All rights reserved. which is retained and published by Lloyd's Register, the original electronic and certified version shall always prevail. List 1List 1 Approved Steelmakers and Manufacturers of Rolled Steel Plates, Strip, Sections & Bars Name and Address LR OfficeLR Office ProductProductProduct CategoryCategoryCategory GradeGradeGrade Max Thickness/Diameter (mm) ArgentinaArgentinaArgentina ACEROS ANGELETTI S.A. Buenos Aires Steelmaking E.A.F. / Ingot carbon, carbon-manganese 30 Semi-Finished Ingots (tonnes) carbon, carbon-manganese 30 Burzaco Av. Hipolito Yrigoyen 16102/96 (1852)-Burzaco Pcia. de Buenos Aires Tel No: +54 11 4299 0110 Fax no: +54 11 4299 0110 Email:[email protected] Web: www.acerosangeletti.com.ar Certificate No. MD00/3676/ 0002/ 1 Expiry date 22/02/2015 AustraliaAustraliaAustralia BLUESCOPE STEEL (AIS) PTY. LTD. Sydney Steelmaking B.O.S. / Con Cast As below Plates Normal Strength A, B, D, E 51 Higher Strength AH27S, AH32, AH36, DH27S, DH32, DH36, 51 EH27S, EH32, EH36 Hot Rolled Coil Normal Strength A, B, D, E 13 Higher Strength AH27S, AH32, AH36, DH27S, DH32, DH36, 6 EH27S, EH32, EH36 Port Kembla Steelworks P.O. Box 1854 Wollongong NSW 2500 Tel: +61 2 42754666 Fax: +61 2 42753045 Email: mailto:[email protected] Plates with specified through thickness properties notation Z35 may be added. Normalizing heat treatments carried out by sub-contractor, Bisalloy. Certificate # MD00/1929/0008/1 Expiry date: 20/07/2015 AustriaAustriaAustria BREITENFELD EDELSTAHL AG Vienna Steelmaking E.A.F./V.O.D./Ingot As below Semi-Finished Ingots (tonnes) carbon, carbon-manganese, alloy, austenitic 120 stainless, duplex stainless Breitenfeldstrasse 22 A-8662 Mitterdorf im Mürztal Tel: +43 (0)3858 6161 231 Fax +43 (0)3858 6161 248 Email mailto:[email protected] Web: http://www.breitenfeld.at Certificate # MD00/3255/0004/1 Expiry Date: 07/06/2015 Including VD/VOD BÖHLER EDELSTAHL GmbH Vienna Steelmaking E.A.F./Ingot/Con Cast As below Bars Structural carbon, carbon-manganese, alloy, austenitic 220 stainless, duplex stainless Mariazellerstraße 25 Postfach 96 A-8605 Kapfenberg Tel: +43 3862 20 37063 Fax: +43 3862 20 37559 Email: mailto:[email protected] Web:http://www.bohler-edelstahl.com Certificate #: MD00/0200/0007/1 Expiry date: 22/01/2015 BÖHLER YBBSTAL PROFIL GmbH Vienna Sections Normal Strength A, B, D, E 20 Higher Strength AH32, AH36, DH32, DH36, EH32, EH36 20 Bars Normal Strength A, B, D, E 20 Higher Strength AH32, AH36, DH32, DH36, EH32, EH36 20 Structural carbon, carbon-manganese, alloy, austenitic 20 stainless, duplex stainless Waidhofnerstraße 8 3333 Böhlerwerk Tel: +43 7448 7007 504 Fax: +43 7448 7007 250 Email: mailto:[email protected] Web:http://www.bohler-profil.com High alloy bars and sections may be accepted for approved applications. Certificate #: MD00/0202/0006/1 Expiry date: 28/01/2015 SONDERSTAHLWERK BREITENFELD GmbH Vienna Steelmaking VAR/INGOT As below 38 Semi-Finished Ingots (tonnes) carbon, carbon-manganese, alloy, austenitic 38 stainless, duplex stainless ESR Ingots carbon, carbon-manganese, alloy, austenitic 38 stainless, duplex Breitenfeldgasse 23 A-8661 Wartberg Tel +43 (0)3858 6161 231 Fax +43 (0)3858 6161 248 Email [email protected] Web http://www.breitenfeld.at Certificate # MD00/3256/0004/1 Expiry date: 06/06/2015 Including remelting of Ni materials Page 2 As at 13 May 2014 This is a copy of an electronic document. In the event of any conflict or ambiguity between the copy and the electronic document, © Lloyd’s Register Group Limited 2014. All rights reserved. which is retained and published by Lloyd's Register, the original electronic and certified version shall always prevail. List 1List 1 Approved Steelmakers and Manufacturers of Rolled Steel Plates, Strip, Sections & Bars Name and Address LR OfficeLR Office ProductProductProduct CategoryCategoryCategory GradeGradeGrade Max Thickness/Diameter (mm) STAHL JUDENBURG GmbH Vienna Bars Normal Strength A 120 Structural carbon, carbon-manganese 120 Machinery carbon, carbon-manganese, carbon-manganese 120 Gußstahlwerkstrasse 21 A-8750 Judenburg Tel: +43 3572 701-358 Fax: +43 3572 701-248 Email: mailto:[email protected] Web: http://www.stahl-judenburg.com Certificate #: MD00/1643/0006/1 Expiry date: 29/01/2015 VOESTALPINE GROBBLECH GmbH Vienna Steelmaking B.O.S. / Con Cast As below Plates Normal Strength A, B, D, E 140 Higher Strength AH42, DH42, EH42 55 AH40, DH40, EH40, FH40 100 AH32, AH36, DH32, DH36, EH32, EH36, FH32, 140 FH36 Boiler & Pressure Vessel 360AR 40 410AR 50 360FG, 410FG, 460FG, 490FG, 510FG 140 Ferritic Low Temperature 1.5Ni, 3.5Ni, 5Ni, 9Ni 50 LTAH32, LTAH36, LTDH32, LTDH36, LTEH32, 140 LTEH36, LTFH32, LTFH36 Clad D/304L 50 P.O Box 3 Voest.- Alpine - Str. 3 A-4020 Linz Tel: +43 50304 15 9091 Fax: +43 50304 55 9091 Email: mailto:[email protected] Web: www.voestalpine.com Certifcate No. MD00/1614/0008/1 Expiry date: 30/07/2014 Approval includes the supply of z25 and z35 grades. Approval includes pressed heads. VOESTALPINE STAHL DONAWITZ GmbH & Co Vienna Steelmaking B.O.S. / Con Cast carbon, carbon-manganese, alloy KGKGKG Semi-Finished Blooms/Billets carbon, carbon-manganese, alloy 285 Kerpelystraße 199 A 8700 Leoben Tel: +43 50304 25-4659 Fax: +43 50304 65-2464 Email: mailto:[email protected] Web:http://www.voestalpine.com/stahldonawitz Certificate #: MD00/2976/0004/1 Expiry date: 21/04/2015 Belarus, Republic of OJSC "Byelorussian Steel Works-Management St. Petersburg Steelmaking E.A.F./V.O.D./Con Cast As below Company of Semi-Finished Rolled Billets Carbon, Carbon-Manganese 140 Billets carbon, carbon-manganese, Normal Strength 300 "Byelorussian Metallurgical Company" holding" (OJSC "BSW -management company of "BMC" holding") 37, Promyshlennaya Str. BY- 247210 Zhlobin, Gomel Region, Tel No: +375 2334 56180 Fax no: +375 2334 56317 Mob +375 291105030 Email : mailo:[email protected] Web: xxxxxxxxxxxxxxxx Certificate No: MD00/4297/0001/1 Expiry date 05/03/2017 Page 3 As at 13 May 2014 This is a copy of an electronic document. In the event of any conflict or ambiguity between the copy and the electronic document, © Lloyd’s Register Group Limited 2014. All rights reserved. which is retained and published by Lloyd's Register, the original electronic and certified version shall always prevail. List 1List 1 Approved Steelmakers and Manufacturers of Rolled Steel Plates, Strip, Sections & Bars Name and Address LR OfficeLR Office ProductProductProduct CategoryCategoryCategory GradeGradeGrade Max Thickness/Diameter (mm) BelgiumBelgiumBelgium APERAM Genk Antwerp Steelmaking E.A.F./A.O.D./Con Cast austenitic stainless B.O.S/V.O.D./Con Cast austenitic stainless Semi-Finished Slabs austenitic stainless 200 Plates Austenitic Stainless 304L, 304LN, 316L, 316LN, 317L, 317LN, 321, 14 347 Swinnenwijerweg 5 Genk - Zuid, Zone 6A B-3600 Genk Tel: +32 89 30 25 68 Fax: +32 89 30 25 53 Email: [email protected] Certificate #: MD00/3423/0003/1 Expiry date: 29/01/2014 ESB sprlESB sprl Antwerp Steelmaking E.A.F. / Con Cast As below Semi-Finished Blooms carbon, carbon-manganese, alloy, Ferritic 600 Stainless Steel* ENGINEERING STEEL BELGIUM Rue de l'Environnement, 8 B - 4100 Seraing Tel No: +32 4 33 885 60 Fax No: +32 4 33 809 00 Email : [email protected] Web : www.esb.be Certificate No: MD00/3858/0002/1 Expiry date: 09/11/2016 Materials Suitable for Steel Forgings, Pipe and Tube, Ingots up to 800mm diameter and Blooms up to 600 mm diameter INDUSTEEL BELGIUM SA Antwerp Steelmaking E.A.F.