Apple (AppleTalk) Network Quick Install Card Xerox Document Centre 240/255/265 LP/ST

Before You Start a) Press the Connectivity and Network b) At the screen, press the Printer Setup button. If your printer is equipped with a Name button and enter the name you interface, use the Token Ring Quick Install b) At the next screen, press the Network want for the printer (this is the name Card supplied in this Quick Install Card set to Setup button. that will appear in the Chooser on your set the Ring Speed and Source Routing settings workstations) using the touch panel for your environment. c) At the next screen, press the keys. Then press Save. AppleTalk button. Record the following information c) You will be returned to the previous d) At the next screen, press the Protocol screen. Press the Zone Name button, and Media button. AppleTalk Name ______enter the desired text for this item e) At the next screen, press the Enable using the touch panel keys, then press Save (the printer default is * which AppleTalk Zone ______button to enable the AppleTalk means the printer will appear in ALL protocol. Go to the printer and... zones). f) Press Save. Press the Exit Tools button. Connect your Document Centre 240/255/ d) 1. Assign a Name and Zone to your printer. 265 to the network with the appropriate 4. cabling. a) You will be returned to the previous 2. Enter the Tools pathway screen. Press the Name and Zone button. a) Press the Access ( )button. b) On the keypad enter 1111 or the current password. Press the Enter button when finished. If your printer is an ST model press the Go to Tools button, otherwise skip to the next step. c) The Touch Screen will be used for the remainder of the data entry. 3. Enable the AppleTalk protocol.

For assistance, contact your local Xerox Customer Support Center: USA: 1-800-821-2797 Canada: 1-800-939-3769 Page 1 Apple Macintosh (AppleTalk) Network Quick Install Card Xerox Document Centre 240/255/265 LP/ST

Go to the workstation and... 5. Wait a MINIMUM of 7 minutes for the printer to reset. 1. Use the CentreWare Network Services CD-ROM (CD-ROM 2) to install print driv- a) Obtain a Configuration Report page ers and the Macintosh Naming Utility on from your printer. the workstation. Details for this are found b) Review the AppleTalk Settings: area in the document supplied with your printer of the Configuration Report page entitled Getting Started with Print and and verify that AppleTalk is enabled, Fax Services. the AppleTalk Name is correct, the 2. Send a test job to the printer from an AppleTalk Zone is correct (if used). application program. c) From the documentation package 3. Check your test job for quality and use the supplied with your printer, retrieve the problem solving section of the Document CentreWare Network Services CD- Centre 240/255/265 Reference Guide for ROM (CD-ROM 2) and the document resolving print defects. entitled Getting Started with Print If your job did not print see the and Fax Services. Proceed to the 4. Troubleshooting section of the Network next section of this procedure called Installation and Troubleshooting Guide. Go to a Workstation and...

Page 2