Care and Cleaning 112020 Roller Shade Fabric FABRIC CARE AND CLEANING INSTRUCTIONS Clarity 1%, 3%, 5%, 10%* Remove dust with a vacuum or compressed air. Do not scrub. Do not use solvents or any abrasive Dawn 3%, 5%* substances which might damage the coating of the fabric. Clean with a or a soft dipped in Flare 3%, 5%* soapy water using mild detergent. Rinse with clean water. Leave the blind down until completely dry. You Stanton 1%, 4% can also very gently rub the fabric with a clean white pencil eraser to remove small stains. Stanton Natural 5% T Screen 1%, 3%, 5% Afterglow 29% Clean with a damp cloth. Astoria 10% Fabric should be spot cleaned with light soft detergent. Glimmer 15% Bleecker 6% Wipe clean with warm soapy water and a damp cloth. Broome 0% (Blackout) Luna 1%, 3%, 5%, 10%* Dusk 0% (Blackout)* Remove dust with or compressed air. Do not scrub. Do not use solvents or any abrasive substance which might damage the coating of the fabric. The front side of Dusk is treated with DURAGUARD® Fabric Protector and can therefore be spot cleaned by gently blotting with a sponge or soft brush dipped in lukewarm soapy water using a mild detergent. The foam coating on the back side should not get wet. A dry chemical sponge or clean white pencil eraser can be used to remove small stains. EclipseTM 0% (Blackout)* Fabric should be regularly dusted/vacuumed as appropriate. If commercial spot are used, they Porter 0% (Blackout) must first be tested and allowed to dry on an inconspicuous area to ensure compatibility Quincy 2% Valencia 18%* Fine Lines 30%* Light dusting with a feather duster is recommended. Spot cleaning may be done with mild detergent. Lumen 15% Pretest a small inconspicuous area before proceeding with spot cleaning. Do not saturate–this may cause noticeable spotting. Franklin 19% Regular light dusting with a feather duster is suggested. A hand-held vacuum with low suction may also Majesty 12% be used. When vacuuming, avoid pulling or stretching the fabric. Rigorous vacuuming is not recommended since this could distort the fabric. Alternatively, dirt and debris can be blown away using compressed air or a hand-held hair dryer on the cool setting. Spots can be cleaned gently blotting with a soft, damp cloth or sponge, using lukewarm water and a mild detergent. Be careful not to apply too much pressure to the fabric. Let air dry. GreenScreen Revive Regular light dusting with a feather duster is suggested. A hand-held vacuum with low suction may also 1%, 5% be used. When vacuuming, avoid pulling or stretching the fabric. Rigorous vacuuming is not recommended since this could distort the fabric. Alternatively, dirt and debris can be blown away using compressed air or a hand-held hair dryer on the cool setting. Lucca 0% (Blackout)* Clean with mild soap and water. If cleaners other than mild soap and water are desired, test in an Roscoe 0% (Blackout) inconspicuous area prior to use. Disinfectants containing bleach may be used. Avoid cleaners containing quaternary ammonium compounds and phenols. Rinse thoroughly after cleaning. Paint solvents should not be used. Monroe 0% (Blackout) Remove dust with a vacuum cleaner or compressed air. Do not scrub. Do not use solvents or any abrasive Sheridan <1% substances which might damage the coating of the fabric. For spot removal, a natural or dry cleaning sponge may be used. Panache 3% Remove dust with a light brush. Lay screen down on flat surface before cleaning and do not apply pressure. Blot up as much of the spill as possible with a soft and slightly wet, clean white sponge. Do not rub. Do not use spot cleaners containing bleach or alcohol. Do not use dry clean or machine wash screen. For best results, use pure cleaning solvents or water based cleaning products. Striate 0% (Blackout) Fabric is recommended to be regularly dusted and cleaned with a dry cloth.

*Printed fabric care and cleaning on page 2 1

Las Vegas • Chicago 800.229.5300 HDhospitality.com Printed Fabric Care and Cleaning Roller Shade Fabric

PRINTED FABRIC CARE AND CLEANING INSTRUCTIONS Clarity 1%, 3%, 5%, 10% Remove dust with a vacuum cleaner or compressed air. Do not scrub. Do not use solvents or any abrasive Dawn 3%, 5% substances which might damage the coating of the fabric. Flare 3%, 5% Luna 1%, 3%, 5%, 10% Valencia 18% Fine Lines 30% Light dusting with a feather duster is recommended.

Dusk 0% (Blackout) Fabric should be regularly dusted/vacuumed as appropriate. EclipseTM 0% (Blackout) Lucca 0% (Blackout)

2

Las Vegas • Chicago 800.229.5300 HDhospitality.com