HUAWEI E220 HSDPA USB Modem Safety Infomation
Total Page:16
File Type:pdf, Size:1020Kb
Ÿ Keep your wireless device in normal HUAWEI E220 HSDPA temperature. Your wireless device can USB Modem Safety only operate between -5ºC and +55 ºC. Ÿ Use approved accessories only. Do not Information connect your wireless device to any incompatible products. Please read the safety information carefully to ensure the correct and safe use of your wireless Obey Laws and Regulations device. Do not operate your wireless device where it General Recommendations may be unsafe to do so or where you are for Use required not to do so. To deactivate your wireless device, close all Always handle your wireless device with care applications using the wireless device first and and keep it in a clean and dust-free place. Do then remove the wireless device from your PC. not expose your wireless device to open flames or lit tobacco products. Obey all local laws, regulations, rules, orders, signs and notices while using the wireless Ÿ Always keep your wireless device dry. device. Signs about the use of mobile phones Ÿ Do not drop, throw or try to bend your should also be obeyed as referring to other wireless device. wireless equipment including wireless devices. Ÿ Do not paint or scratch your wireless Deactivate in Explosive Areas device. Ÿ Do not attempt to disassemble your Deactivate your wireless device where the air is wireless device. Doing so will void potentially explosive. It is rare, but your PC warranty. Only authorized personnel are could generate sparks. allowed to do so. Deactivate in Blasting Areas Ÿ This product requires a minimum distance Deactivate your wireless device where blasting of 1.5 cm from the body when in is in progress. Remote-controlled RF devices operation. are often used at construction sites to set off blasting. 1 Deactivate in Aircrafts Immunity to Interference Deactivate your wireless device before Your wireless device is immune to interferences boarding or in any aircraft. Wireless devices caused by audible signals. can cause interference in aircrafts. Cleaning and Maintenance Deactivate at Hospitals Ÿ Before you clean or maintain the wireless Obey regulations or rules at hospitals. device, close all applications using Deactivate your wireless device near medical wireless device and remove your wireless equipment. Wireless devices can cause device from your PC. interference to cardiac pacemakers, implanted defibrillators or other medical equipment. Ÿ Clean your wireless device with a piece of soft antistatic cloth. Deactivate near Hearing Ÿ If the wireless device or any of its Devices accessories does not work, turn to an authorized service center for help. Deactivate your wireless device near hearing devices. People with hearing aids may Environmental Protection experience interfering noises near wireless devices. Observe the local regulations regarding the disposal of your packaging materials, old Recommendations for wireless device and its accessories. Please Children promote their recycling. Do NOT allow children to play with your SIM/USIM Cards wireless device. They could hurt themselves or While inserting or removing the SIM card, others, or could accidentally damage the protect yourself against electrostatic discharge wireless device. Your wireless device contains (ESD). Do not touch the connector of the SIM small parts with sharp edges that may cause an card. As a precaution, always make sure that injury or a choking hazard. the wireless device is already in your hand Deactivate While Driving before you insert or remove the SIM card. Do not use the wireless device while driving. 2 Restart on ESDs be suitably mounted so that it is at least 1.5 cm away from the body. Mounting accessories (for Software will attempt to re-initialize a example, belt clips) cannot be made of metal. connection once a substantial electrostatic Do not put the wireless device in your pocket. discharge causes the device to reset. If the * The general public RF exposure limits software is not operational after an ESD, restart the modem software application. referenced in the R&TTE Directive are consistent with the published Guidelines of the Agency/Regulatory International Commission on Non-Ionizing Radiation Protection (ICNIRP) 1998. ICNIRP Information is a formally recognized non-governmental The wireless device is approved for use in organization in Non-Ionising Radiation many regions of the world. In these regions, the Protection for the World Health Organisation device meets all radio frequency exposure (WHO), the International Labour Organisation requirements. The following approvals and (ILO) and the European Union (EU). For more notices apply in specific regions as noted. information, visit the ICNIRP website at www.icnirp.de. CE Approval (European Certification Information Union) (SAR) The wireless device is approved to be used in the member states of the EU. Huawei declares THIS DEVICE MEETS THE that the wireless device is in compliance with GOVERNMENT'S REQUIREMENTS FOR the essential requirements and other relevant EXPOSURE TO RADIO FREQUENCY provisions of the Radio and ELECTROMAGNETIC FIELD. Telecommunications Terminal Equipment Your wireless device is a low-power radio Directive 1999/5/EC (R&TTE Directive). transmitter and receiver. When it is running, it emits low levels of radio frequency energy Radio Frequency Exposure (also known as radio waves or radio frequency To ensure compliance at all times with the fields). R&TTE Directive* 1999/5/EC, the wireless Governments around the world have adopted device can be held in the hand but still requires comprehensive international safety guidelines, a minimum distance of 1.5 cm from the body developed by scientific organizations, e.g. when in operation. For body-worn use, it must 3 ICNIRP (International Commission on exposure. Non-Ionizing Radiation Protection) and IEEE The SAR limit adopted by the 1999/519/EC is (Institute of Electrical and Electronics 2.0 watts/kilogram (W/kg) averaged over ten Engineers Inc.), through periodic and thorough gram of tissue. The highest SAR value for this evaluation of scientific studies. These device type when tested is 1.20 W/kg. guidelines establish permitted levels of radio wave exposure for the public. The levels [EN 50361 scope states “This basic standard include a safety margin designed to assure the applies to any electromagnetic field (EM) safety of all persons, regardless of age and transmitting devices intended to be used with health, and to account for any variations in the radiating part of the equipment in close measurements. proximity to the human ear including mobile phones, cordless phones, etc. The frequency Specific Absorption Rate (SAR) is the unit of range is 300 MHz to 3 GHz. Therefore, the measurement for the amount of radio frequency above text does not address primary use of the energy absorbed by the body when using a wireless device product.] wireless device. The SAR value is determined at the highest certified power level in Federal Communications Commission laboratory conditions, but the actual SAR level Notice (United States): Before a wireless of the wireless device while operating can be device model is available for sale to the public, well below the value. This is because the it must be tested and certified to the FCC that it wireless device is designed to use the minimum does not exceed the limit established by the power required to reach the network. government-adopted requirement for safe exposure. All models of Huawei’s wireless device are designed to meet radio frequency exposure The SAR limit adopted by the USA and Canada guidelines such as European Council is 1.6 watts/kilogram (W/kg) averaged over one Recommendation and Federal Communications gram of tissue. The highest SAR value reported Commission Notice (United States). to the FCC and IC for this device type when tested for use is 0.59W/kg. [There is no European Council Recommendation: Before reference to the specific reference standard or a wireless device model is available for sale to its applicability to the intended use of the the public, it must be tested according to the product] technical standard-EN 50361 and not exceed the limit established by the European Council Recommendation: 1999/519/EC for safe 4 FCC Statement harmful interference, and (2) this device must accept any interference received, including This equipment has been tested and found to interference that may cause undesired comply with the limits for a Class B digital operation. device, pursuant to Part 15 of the FCC Rules. Warning: Changes or modifications made to These limits are designed to provide reasonable protection against harmful interference in a this equipment not expressly approved by residential installation. This equipment HUAWEI may void the FCC authorization to generates, uses and can radiate radio frequency operate this equipment. energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Ÿ Reorient or relocate the receiving antenna. Ÿ Increase the separation between the equipment and receiver. Ÿ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Ÿ Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: (1) this device may not cause Ver: V1.10 BOM:31400188 5 .