Instruction Manual ©2009 Ken-Tool Part No. 33195-98 33195 – Nineteen-Five™ Mount/Demount Tool Set Follow Tire and Wheel MOUNTING INSTRUCTIONS Manufacturer’s Instructions 1 2 3 Always use plenty of bead When mounting the top bead, place the bead holder (use #31710 for lubrication on the tire and wheel. steel rims; #33196 (shown) for aluminum rims) on the rim and slide to one side, as a stop against the bead. Manuallyyp push lower bead over rim and into position for mounting. Using the bent end of the ALWAYS MOUNT WITH Nineteen-Five tire iron, with stop resting against the rim, pry the WHEEL HUB SIDE UP! bottom bead over the rim. Repeat progressively around tire, working with small sections, until See Video Demo at www.kentool.com the bea d is comp le te ly over the rim. 4 5 6 Stand on the tire and use the Repeat this step, taking small The curved end of the tool easily curved end of the tool to pry a sections of the bead, until the gets under the stretched bead for section of the top bead over the last section is pried over the rim “that last bite”. rim. and the tire is mounted. Press the sidewall of the tire down, as you work your way around, to force the top bead into the drop center of the wheel. Curved End Bent End (C)2007 Ken-Tool 768 E. North Street, Akron, Ohio 44305; Phone: 888-536-8665, Fax: 330-535-1345 Website: www.kentool.com E-Mail:
[email protected] 1 Instruction Manual ©2009 Ken-Tool Part No.