Scion/Subaru/Toyota Multi-Kit2000-2017
Total Page：16
File Type：pdf, Size：1020Kb
95-8202 INSTALLATION INSTRUCTIONS Scion/Subaru/Toyota Multi-kit 2000-2017 TABLE OF CONTENTS See Page 2 KIT FEATURES • ISO DDIN radio provision WIRING & ANTENNA CONNECTIONS (sold separately) Wiring Harness: Please visit metraonline.com for wiring harness options Antenna Adapter: Please visit metraonline.com for antenna adapter options KIT COMPONENTS • A) ISO DDIN trim plate brackets A TOOLS REQUIRED • Cutting tool • Phillips screwdriver • Socket set • Dremel/grinder tool CAUTION! All accessories, switches, climate controls panels, and especially air bag indicator lights must be connected before cycling the ignition. Also, do not remove the factory radio APPLICATIONS with the key in the on position, or while the See inside front cover vehicle is running. The World’s best kits.® MetraOnline.com © COPYRIGHT 2019 METRA ELECTRONICS CORPORATION REV. 12/5/19 INST95-8202 APPLICATIONS TABLE OF CONTENTS Toyota Dash Disassembly – Scion xB 2004-2006 ................................................................. 14 Rav-4 2001-2005 – Toyota Rav4 2001-2005..............................................................3 – Scion xB 2008-2015 .................................................................. 14 MR2 Spyder 2000-2005 Celica 2000-2005 – Toyota MR2 Spyder 2000-2005 .................................................3 – Scion tC 2005-2010 ....................................................................15 Echo 2000-2005 – Toyota Celica 2000-2005 ...........................................................4 – Scion tC 2011-2016 ......................................................................15 Highlander (without factory navigation) 2001-2007 Matrix 2005-2008 – Toyota Echo 2000-2005 .............................................................4 – Scion xD 2008-2014 .................................................................. 16 Matrix (with factory navigation) 2009-2010 – Toyota Highlander 2001-2007 (without factory navigation) .......5 – Subaru BRZ 2013-2015 ...............................................................17 4 Runner (excluding limited) 2003-2009 – Toyota Matrix 2005-2008...........................................................5 – Subaru Forester 2009-2013 (with SD based navigation) ...............17 Tundra 2003-2006 Sequoia 2003-2007 – Toyota Matrix 2009-2010 (with factory navigation) ....................6 Kit Preparation ...........................................................................18 FJ Cruiser 2007-2014 – Toyota 4 Runner 2003-2009 (excluding limited) .................... 6-7 Yaris (without power package) 2007-2011 Kit Assembly Yaris 2012-2017 – Toyota Tundra 2003-2006 .......................................................7-8 –ISO DDIN radio provision ............................................................ 19 Scion – Toyota Sequoia 2003-2007 ........................................................8 FR-S 2013-2016 – Toyota FJ Cruiser 2007-2014 .......................................................9 iQ 2012-2015 tC 2005-2016 – Toyota Yaris 2007-2011 (without power package) ...................... 10 xA 2004-2006 – Toyota Yaris 2012-2017 ..............................................................11 xB 2004-2015 – Scion FR-S 2013-2016 .................................................................11 xD 2008-2014 – Scion iQ 2012-2015 .....................................................................12 Subaru BRZ 2013-2015 – Scion xA 2004-2006 ..................................................................13 Forester (with SD based navigation) 2009-2013 2 1.800.221.0932 | MetraOnline.com DASH DISASSEMBLY Toyota Rav-4 2001-2005 Toyota MR2 Spyder 2000-2005 1. Unclip and remove side panel from 1. Unsnap the lower trim piece from both sides of radio and climate controls. each side of the dash console (Figure A) and remove (2) Phillips screws 2. Remove (4) Phillips screws securing the exposed in each cavity. Remove radio/climate control trim panel. (Figure B) the upper trim piece from each side of the console. (Figure A) 3. Remove (4) 10mm bolts securing the radio. (Figure C) 2. Remove the climate control knobs and (2) Phillips screws exposed. 4. Unplug and remove radio. Remove the climate control trim 5. Remove factory brackets from radio. Retain (Figure B) bezel. (Figure A) brackets for use during kit assembly. 3. Remove the ashtray and (1) 10mm bolt exposed. Unclip the ashtray Continue to Kit Preparation trim bezel and remove. (Figure A) 4. Unclip the radio trim bezel, (Figure A) remove (4) Phillips screws securing the radio and disconnect the wiring. 5. Remove factory brackets from radio. Retain brackets for use during kit assembly. (Figure A) (Figure C) Continue to Kit Preparation REV. 12/5/2019 INST95-8202 3 DASH DISASSEMBLY (CONT) Toyota Celica 2000-2005 Toyota Echo 2000-2005 1. Unclip and remove the gear shifter trim 4. Remove (4) 10mm screws securing the 1. Remove the climate control knobs and 2. Remove the ashtray. Unclip and remove bezel and remove (2) Phillips screws factory radio and disconnect the wiring. (2) Phillips screws exposed. Unclip and the radio trim bezel. Remove (2) Phillips exposed below the climate controls. remove the climate control trim bezel. 5. Remove factory brackets from radio. screws from the bottom of the radio (Figure A) Depress the side clips securing the climate brackets and disconnect the wiring. Retain brackets for use during kit control panel and move the panel to 2. Pull off climate control knobs and remove assembly. 3. Remove factory brackets from radio. (2) Phillips screws exposed. (Figure A) access (2) Phillips screws from the top of the factory radio brackets. (Figure A) Retain brackets for use during kit 3. Unclip the climate control/factory radio Continue to Kit Preparation assembly. trim bezel and remove. (Figure A) Continue to Kit Preparation (Figure A) (Figure A) 4 1.800.221.0932 | MetraOnline.com DASH DISASSEMBLY (CONT) Toyota Highlander 2001-2007 Toyota Matrix 2005-2008 (without factory navigation) 1. Unclip the bottom edge of the radio trim 1. Pull and remove dash panel from radio panel then lift up and out to remove. and climate controls. Tip: There are 8 (Figure A) clips. (Figure A) 2. Remove (4) 10mm bolts securing 2. Remove (6) 10mm bolts from radio and the factory radio. (Figure B) climate controls assembly. (Figure B) (Figure A) 3. Remove assembly and disconnect the Continue to Kit Preparation wiring. 4. Remove (8) Phillips bolts and (4) Phillips (Figure A) screws to separate brackets from assembly. Retain brackets for use during kit assembly. (Figure C) Continue to Kit Preparation (Figure B) TUNE SEEK TRACK AM FM 1 FM 2 DISK SCAN (Figure B) (Figure C) REV. 12/5/2019 INST95-8202 5 DASH DISASSEMBLY (CONT) Toyota Matrix 2009-2010 Toyota 4-Runner 2003-2009 (with factory navigation) (excluding limited) 1. Unclip and remove the radio trim panel PASSENGER 1. Unsnap and remove trim from including the A/C vent. (Figure A) SECURITY around shifter. 2. Remove (4) 10mm bolts securing the 2. Unsnap and remove trim covers from factory radio. Unplug and remove the around center console pocket edge at radio. (Figure B) front and rear of console. 3. Unsnap and remove center console (Figure A) Continue to Kit Preparation cover. (Figure A) 2 3 1 0 4 5 A/C 4. Unsnap trim ring from around ignition (Figure A) key cylinder. 5. Remove (1) 10mm bolt from bottom right of panel below steering column. Unsnap panel and pull away to gain access behind panel. (Figure B) 6. Remove (1) 10mm bolt on bottom left 2 3 1 of center panel behind panel below 0 4 5 A/C steering column. (Figure B) (Figure B) Continued on next page (Figure B) 6 1.800.221.0932 | MetraOnline.com DASH DISASSEMBLY (CONT) Toyota 4-Runner 2003-2009 (Cont) Toyota Tundra 2003-2006 (excluding limited) 1. Remove the (3) climate control 7. Remove (1) 10mm bolt beneath climate knobs by pulling straight outward. control behind pocket door. Unsnap and (Figure A) remove climate control. (Figure C) 2. Remove (3) Phillips screws from 8. Remove (2) 10mm bolts beneath radio behind knobs. (Figure A) behind climate controls. 3. Position vents facing upward and 9. Unsnap and remove entire center panel remove (1) Phillips screw from (Figure B) (Figure A) around radio. (Figure D) each A/C vent. (Figure B) 10. Remove (2) 10mm bolts securing radio. Continued on next page 11. Unplug and remove radio. 12. Remove factory brackets from radio. Retain brackets for use during kit assembly. Continue to Kit Preparation (Figure C) (Figure B) REV. 12/5/2019 INST95-8202 7 DASH DISASSEMBLY (CONT) Toyota Tundra 2003-2006 (Cont) Toyota Sequoia 2003-2007 4. Unclip and remove entire trim 1. Position vents facing upward and remove (1) panel. (Figure C) Phillips screw from each A/C vent. (Figure A) 5. Remove (4) 10mm bolts to 2. Unclip and remove entire radio trim panel remove radio. (Figure D) including climate controls. (Figure B) 6. Unplug and remove radio. 3. Remove (4) 10mm bolts to remove radio. 7. Remove factory brackets from (Figure C) radio. Retain brackets for use 4. Unplug and remove radio. during kit assembly. 5. Remove factory brackets from radio. (Figure C) Retain brackets for use during kit assembly. (Figure B) Continue to Kit Preparation Continue to Kit Preparation (Figure D) (Figure A) (Figure C) 8 1.800.221.0932 | MetraOnline.com DASH DISASSEMBLY (CONT) Toyota FJ Cruiser 2007-2014 1. Remove two Phillips screws from bottom part of side trim panels. (Figure A) 2. Using a panel removal tool, carefully remove the side trim panels. (Figure B) 3. Remove (2) Phillips screws from radio trim panel. (Figure