Ford Falcon / Fairmont Wagon (Xa – El)
Total Page:16
File Type:pdf, Size:1020Kb
L.P. GAS CYLINDER INSTALLATION INSTRUCTIONS FORD FALCON / FAIRMONT WAGON (XA – EL) 210dia Triple Manifold Cylinder. This Automotive LP Gas cylinder must be installed in the vehicle in strict accordance with the latest requirements of AS/NZS1425. Any modifications to the cylinder will render the warranty null and void. General Cylinder Specifications: (3 cylinders) DIAMETER :210mm LENGTH :830mm COMBINED CAPACITY : 77L (Water) L.P GAS CAPACITY : 62L VALVE ORIENTATION : 30 degree. Installation: 1). This cylinder is designed to be installed in the rear spare wheel well of Ford Falcon / Fairmont Station wagons. 2). Lift up the rear carpet / mat and 3). Remove the spare wheel from the well. remove the spare wheel well cover board. 4). Cut off the spare wheel securing bracket 5). Place the cylinder into position, with the sub- and tap down all jagged edges. compartment box facing the passenger side. C:My documents\salesofficeandrew\XA-EL Ford Wagon. Revision 2 – 08/08/07 This is an Uncontrolled document. 6). Loosely fix the Angle Attachment bracket 8) Remove the cylinder, and place a punch shown to the cylinder rear left bracket and mark in the centre of the marked locations. Drill all mounting points with a coloured marker. out the holes using a 13mm drill bit. 9) Place the cylinder back into position ensuring 10) Using the bolts and backing plates supplied, the brackets line up with the holes. fix the cylinder into position. 11) Note the backing plate shown above is the 12). After the cylinder has been connected and backing plate for the Angle Attachment bracket tested in accordance with AS/NZ1425, fit the shown in Step 10. foam supports to the top flats on the cylinder and fit the Manchester Tank Luggage Board. NOTE: Existing Luggage boards will no longer fit after cylinder has been installed. C:My documents\salesofficeandrew\XA-EL Ford Wagon. Revision 2 – 08/08/07 This is an Uncontrolled document. .