Panasonic UHD TX43HX700E | PDF Download
Total Page：16
File Type：pdf, Size：1020Kb
Load more
Recommended publications
-
Component Video Sync Formats (EL8102) ®
Component Video Sync Formats (EL8102) ® Application Note October 13, 2004 AN9513.1 Introduction 0 to This application note will examine a variety of sync formats 0 to +0.7V and a method for removing the sync pulse from component +0.7V video signals (see Figure 1). The EL8102 is a single supply 0 to Video Op Amp with rail to rail output stage that is ideal for -0.3V video signal amplification and sync stripping functions. This COMPONENT (RGB) EL8102 OUTPUT product was developed for video design engineers who need VIDEO INPUT to remove sync from component RGB (red, green, blue) and monochrome RS-170 video data (see Figure 7). Recently FIGURE 1. SYNC STRIPPER WAVEFORMS the term RGB has been turned around and called GBR (green, blue, red) as video distribution systems normally put RF RB 750 6.8K green on channel 1, blue on channel 2 and red on channel 3. +5V This is consistent with the hook-up of the color difference DC standards. RG 750 RT 1103 75 TABLE 1. RGB STANDARDS SPECIFICATIONS (BROADCAST - VOUT + ENGINEERING 11/94) VIN R RT RIN L SMPTE/EBU NTSC NTSC 75 75 75 N10 (NO SETUP) (SETUP) Max 700mV 714mV 714mV FIGURE 2. EL8102 APPLICATION CIRCUIT VIDEO AMPLIFIER Min 0mV 0mV 54mV WITH SYNC STRIPPER Range 700mV 714mV 660mV Transmitting two-dimensional moving pictures electronically requires the handling of a large amount of information and Sync -300mV -286mV -286mV this is done by slicing the 2-D picture into horizontal strips of Peak-To- 1V 1V 1V video and sending them sequentially. -
TITAN 1080P-500, 1080P-250 High Brightness Digital Video Projector 16:9 Widescreen Display User Manual
TITAN 1080p-500, 1080p-250 High Brightness Digital Video Projector 16:9 widescreen display User Manual 107-280B Digital Projection TITAN 1080p-500, 1080p-250 User Manual Declaration of Conformity Directives covered by this Declaration 2004/108/EC Electromagnetic Compatibility Directive. 2006/95/EC Low Voltage Equipment Directive. Products covered by this Declaration Large screen video projector type The CE mark was fi rst applied in: TITAN 1080p-500, June 2007 Basis on which Conformity is being declared The products identifi ed above comply with the protection requirements of the above EU directives, and the manufacturer has applied the following standards. EN 55022:1998 - Limits and Methods of Measurement of Radio Disturbance Characteristics of Information Technology Equipment. EN 55024:1998 - Limits and Methods of Measurement of Immunity Characteristics of Information Technology Equipment. EN 55103:1997 - Product family Standard for Audio, Video, Audio-Visual and Entertainment Lighting Control apparatus for Professional Use. EN 60950-1:2001 - Specifi cation for Safety of Information Technology Equipment, including Electrical Business equipment. The technical documentation required to demonstrate that the products meet the requirements of the Low Voltage directive has been compiled by the signatory below and is available for inspection by the relevant enforcement authorities. Signed: Authority: D.J. Quinn, Product Development Director Date: 25 June 2007 Attention! The attention of the specifi er, purchaser, installer, or user is drawn to special measures and limitations to use which must be observed when these products are taken into service to maintain compliance with the above directives. Details of these special measures are available on request, and are also contained in the product manuals. -
Shmups.System11.Org • View Topic - GBS 8200/8220 CFW Project
shmups.system11.org • View topic - GBS 8200/8220 CFW Project http://shmups.system11.org/viewtopic.php?f=6&t=52172 shmups.system11.org Shmups Forum FAQ Search Register Login It is currently Tue Nov 10, 2015 9:56 pm View unanswered posts Board index » Shmups » Hardware View active topics GBS 8200/8220 CFW Project Page 1 of 9 [ 242 posts ] Go to page 1, 2, 3, 4, 5 ... 9 Next Print view Previous topic | Next topic Author Message dooklink Post subject: GBS 8200/8220 CFW Project Posted: Tue Nov 11, 2014 9:01 am Here is a project that I've been working on for the GBS scaler boards. I'm not well versed in posting these kinds of things, so this could be a bit confusing for the moment. I'm also new to the forums but have been reading a lot of information on here and getting into CRT retro gamming as I mentioned in the introduction thread . Joined: 07 Nov 2014 Small Summary Posts: 85 I have created some code for a Raspberry Pi running Rasbian to interface with Location: Australia any GBS board (8200 or 8220). This programs the register settings in the scaling chip, the TVIA Trueview 5725, directly via I2C at 3.3V. The on board MTV230GMV microcontroller, sometimes going by rebadged labels such as GBS800MV, is bypassed by shorting the jumper on Port 8 (P8). This puts it into In System Programming (ISP) mode, which means it can't interfere with the custom settings being programmed. Here is a short list of the improvements I have been able to get working thus far: Pure line double mode, allowing correct 30Hz drop shadows with no interpolation YPbPr component output, with Sync on Luma included Resolution changes, including 576p50Hz Correct 50Hz input, this works on some versions of the original firmware and not others Finer control of the scaling and image position Control of the image processing chain to adjust all sorts of image quality settings Over sampling of the output using 4x oversampling of the pixel/dot clock I have created some python and bash scripts that allow for a black and white interactive menu from the Raspberry Pi's composite acting as pure Luma. -
Titan Sx+-500 User Manual.P65
TITAN sx+-500 High Brightness Digital Video Projector User Manual 105-947C Rev C March 2008 Digital Projection TITAN sx+-500 User Manual Declaration of Conformity Directives covered by this Declaration 89/336/EEC Electromagnetic Compatibility Directive, amended by 92/31/EEC and 93/68/EEC. 73/23/EEC Low Voltage Equipment Directive, amended by 93/68/EEC. Products covered by this Declaration Large screen video projector type TITAN sx+-500 Basis on which Conformity is being declared The products identified above comply with the protection requirements of the above EU directives, and the manufacturer has applied the following standards. EN 55022:1998 - Limits and Methods of Measurement of Radio Disturbance Characteristics of Information Technology Equipment. EN 55024:1998 - Limits and Methods of Measurement of Immunity Characteristics of Information Technology Equipment. EN 55103:1997 - Product family Standard for Audio, Video, Audio-Visual and Entertainment Lighting Control apparatus for Professional Use. EN 60950:2000 - Specification for Safety of Information Technology Equipment, including Electrical Business equipment. The technical documentation required to demonstrate that the products meet the requirements of the Low Voltage directive has been compiled by the signatory below and is available for inspection by the relevant enforcement authorities. The CE mark was first applied in June 2006 Signed: Authority: D.J. Quinn, Product Development Director Date: 1 June 2006 Attention! The attention of the specifier, purchaser, installer, or user is drawn to special measures and limitations to use which must be observed when these products are taken into service to maintain compliance with the above directives. Details of these special measures are available on request, and are also contained in the product manuals. -
0600 A(C05) Japan
Printed in Japan 402520600 Printed on 100% recycled paper. 02.03-.4A(C05) About The Manuals and Notations Used Types of Manual The documentation for your EPSON projector is divided into the following three manuals. The manuals cover the following topics. • User’s Guide (this manual) This Users Guide contains information on installing the projector, basic operation, using the projector menus, troubleshooting and maintenance. • Safety Instructions/World-Wide Warranty Terms This manual contains information on using the projector safely, and also includes World-Wide Warranty Terms and a Troubleshooting check sheet. Be sure to read this manual thoroughly before using the projector. • Quick Reference Guide Contains an overview of the most commonly-used projector functions for easy reference. You should keep this Quick Reference Guide near the projector at all times and refer to it before starting presentations and while using the projector in order to check details of operation. Notations used in this Users Guide General information Caution : Indicates procedures which may result in damage or injury if sufficient care is not taken. Tip : Indicates additional information and points which may be useful to know regarding a topic. Indicates that an explanation of the underlined word or words in front of this symbol appears in the Glossary of Terms. Refer to the Glossary in the Appendix. (P.101) Indicates operating methods and the order of operations. Procedure The procedure indicated should be carried out in the order of the numbers. Meaning of "unit" and "projector" When "unit" or "projector" appears in the text of this Users Guide, they may refer to items which are accessories or optional equipment in addition to the main projector unit itself. -
TP T Series Transmitters TP T 15 HD a TP T 15 HD AV TP T BNC DA4 Audio/Video Twisted Pair Cable Transmitters
TP T Series Transmitters TP T 15 HD A TP T 15 HD AV TP T BNC DA4 Audio/Video Twisted Pair Cable Transmitters 68-546-03 Rev. H 12 09 Precautions Safety Instructions • English Warning This symbol is intended to alert the user of important operating and maintenance Power sources • This equipment should be operated only from the power source indicated on the product. This (servicing) instructions in the literature provided with the equipment. equipment is intended to be used with a main power system with a grounded (neutral) conductor. The third (grounding) pin is a safety feature, do not attempt to bypass or disable it. This symbol is intended to alert the user of the presence of uninsulated dangerous Power disconnection • To remove power from the equipment safely, remove all power cords from the rear of voltage within the product’s enclosure that may present a risk of electric shock. the equipment, or the desktop power module (if detachable), or from the power source receptacle (wall plug). Caution Power cord protection • Power cords should be routed so that they are not likely to be stepped on or pinched by Read Instructions • Read and understand all safety and operating instructions before using the equipment. items placed upon or against them. Retain Instructions • The safety instructions should be kept for future reference. Servicing • Refer all servicing to qualified service personnel. There are no user-serviceable parts inside. To prevent the risk of shock, do not attempt to service this equipment yourself because opening or removing Follow Warnings • Follow all warnings and instructions marked on the equipment or in the user covers may expose you to dangerous voltage or other hazards. -
Lightning 30 40 45 1080P Series User Manual.Pdf
LIGHTNING 30/40/45-1080p LIGHTNING 40/45-1080p Ultra Contrast LIGHTNING 40/45-1080p 3D LIGHTNING 40/45-1080p 3D-Ultra Contrast Super High Brightness Digital Video Projector 16:9 widescreen display User Manual 108-721B Digital Projection LIGHTNING 1080p, 1080p 3D/UC User Manual Declaration of Conformity Directives covered by this Declaration 2004/108/EC Electromagnetic Compatibility Directive. 2006/95/EC Low Voltage Equipment Directive. Products covered by this Declaration Large screen video projector type The CE mark was first applied in: LIGHTNING 30-1080p July 2007 LIGHTNING 40-1080p July 2007 LIGHTNING 45-1080p August 2009 LIGHTNING 40-1080p Ultra Contrast July 2007 LIGHTNING 45-1080p Ultra Contrast August 2009 Basis on which Conformity is being declared The products identified above comply with the protection requirements of the above EU directives, and the manufacturer has applied the following standards. EN 55022:1998 - Limits and Methods of Measurement of Radio Disturbance Characteristics of Information Technology Equipment. EN 55024:1998 - Limits and Methods of Measurement of Immunity Characteristics of Information Technology Equipment. EN 55103:1997 - Product family Standard for Audio, Video, Audio-Visual and Entertainment Lighting Control apparatus for Professional Use. EN 60950-1:2001 - Specification for Safety of Information Technology Equipment, including Electrical Business equipment. The technical documentation required to demonstrate that the products meet the requirements of the Low Voltage directive has been compiled by the signatory below and is available for inspection by the relevant enforcement authorities. Signed: Authority: D.J. Quinn, Product Development Director Date: 28 August 2009 Attention! The attention of the specifier, purchaser, installer, or user is drawn to special measures and limitations to use which must be observed when these products are taken into service to maintain compliance with the above directives. -
TITAN 1080P-600, Reference 1080P, TITAN 1080P-700, 1080P Ultra Contrast High Brightness Digital Video Projector 16:9 Widescreen Display User Manual
TITAN 1080p-600, Reference 1080p, TITAN 1080p-700, 1080p Ultra Contrast High Brightness Digital Video Projector 16:9 widescreen display User Manual Rev D June 2011 108-451D Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual Declaration of Conformity Directives covered by this Declaration 2004/108/EC Electromagnetic Compatibility Directive. 2006/95/EC Low Voltage Equipment Directive. Products covered by this Declaration Large screen video projector type The CE mark was first applied in: TITAN 1080p-600 October 2007 TITAN 1080p-700 June 2008 TITAN Reference 1080p October 2007 TITAN 1080p-Ultra Contrast June 2008 Basis on which Conformity is being declared The products identified above comply with the protection requirements of the above EU directives, and the manufacturer has applied the following standards. EN 55022:1998 - Limits and Methods of Measurement of Radio Disturbance Characteristics of Information Technology Equipment. EN 55024:1998 - Limits and Methods of Measurement of Immunity Characteristics of Information Technology Equipment. EN 55103:1997 - Product family Standard for Audio, Video, Audio-Visual and Entertainment Lighting Control apparatus for Professional Use. EN 60950-1:2001 - Specification for Safety of Information Technology Equipment, including Electrical Business equipment. The technical documentation required to demonstrate that the products meet the requirements of the Low Voltage directive has been compiled by the signatory below and is available for inspection by the relevant enforcement authorities. Signed: Authority: D.J. Quinn, Product Development Director Date: 13 June 2008 Attention! The attention of the specifier, purchaser, installer, or user is drawn to special measures and limitations to use which must be observed when these products are taken into service to maintain compliance with the above directives.