29403X.00.050713
Total Page:16
File Type:pdf, Size:1020Kb
INSPECTION IMPORTANT INFORMATION - PLEASE READ AND SAVE CMC recommends inspection of any piece of life safety equipment prior to each use. Each department should develop a standard for inspection and each user should be Anchor Strap trained to inspect life safety equipment. When inspecting the anchor strap, check webbing for Sleeve cuts, worn or frayed areas, broken fibers, soft or hard spots, or discolorations. Check the stitching for pulled Made in USA threads, abrasion or breaks. If any of the above are noted of US and foreign components on the anchor strap, or if the strap has been subjected to shock loads, fall loads, or abuse other than normal use, destroy it. Keep the strap away from acids, alkalis, exhaust emissions, rust or strong chemicals. MAINTENANCE Product Label If the sleeve becomes soiled, it can be washed in cold water with a mild detergent. CMC recommends the use of LifeLine Cleaner. Dry out of direct sunlight. Do not dry in an automatic dryer. Constructed of cotton, nylon and PVC coated nylon materials. REPAIR WARNING All repair work shall be performed by the manufacturer. • SERIOUS INJURY OR DEATH MAY RESULT FROM THE All other repair work or modifications may void the IMPROPER USE OF THIS EQUIPMENT. warranty, and releases CMC Rescue, Inc. from all liability • THIS EQUIPMENT HAS BEEN DESIGNED AND MANUFACTURED and responsibility as the manufacturer. FOR USE BY EXPERIENCED PROFESSIONALS ONLY. SAMPLE INSPECTION AND MAINTENANCE LOG • DO NOT ATTEMPT TO USE THIS EQUIPMENT WITHOUT The sample log suggests records that should be PROPER TRAINING. maintained by the purchaser or user of rescue equipment. • USE, INSPECT, AND REPAIR ONLY IN ACCORDANCE WITH MANUFACTURER’S INSTRUCTIONS. Equipment Inspection and Maintenance Log Item __________ # __________ Date in Service ___________ Brand/Model ________________ Strength _________________ The CMC Rescue Anchor Strap Sleeve is an innovative new way to protect your anchor straps from the long term Date How Used or Maintained Comments Name wear that most often leads to their retirement. Made from the same tough #4 cotton duck and PVC coated nylon as our ProSeries Edge Guards, the Anchor Strap Sleeve protects against abrasion, chafing and dirt, and may provide limited protection from chemical exposure. The integral tag line allows the strap to be easily pulled into the sleeve, and can remain attached to the D-ring without interfering with its use. The anchor strap stitching remains visible for quick inspection after each use, and the entire strap can be removed for complete inspection at any time. USE INSTRUCTIONS CMC Rescue, Inc. P.O. Box 6870, Santa Barbara, CA 93160 USA 805-562-9120 / 800-235-5741 cmcrescue.com 1. Begin with the small D-ring next to the end of the ISO 9001:2008 Certified sleeve with the tag line tied to the outside loop. ©2013 CMC Rescue, Inc. Control No. 29403X.00.050713 2. Untie the tag line from the sleeve and tie it onto the D-ring as shown. This will allow the tag line to remain tied on without interfering with the use of the strap. 6. Pinch the sides of the sleeve at the end with the tag 3. Feed the D-ring into the end of the sleeve. line to locate the interior pocket. 4. Find the other end of the tag line sewn into the inside of the other end of the sleeve. Use it to pull the anchor strap through the sleeve. 5. Pull the anchor strap all the way through until it is 7. Stuff the excess tag line into the interior pocket. You centered in the sleeve. This should leave about 6 can leave the end of the tag line tied to the D-ring. inches of web extending from each end (except for the When you pull the strap out of the sleeve for inspection XXL anchor strap which will extend approximately 3 it will pull the tag line with it, allowing you to easily pull feet from each end of the XL sleeve). the strap back into the sleeve. .