TOOLS NEEDED BILL OF MATERIALS • FLOOR JACK PART# DESCRIPTION QTY • 2 JACK STANDS 2 TON M03606 FT SPACER 2 • 2 WHEEL CHOCKS • DRILL + 5/16-1132 DRILL BIT M02533 FT BUMP STOP 2 • SPRING COMPRESSOR KJ09127 • STANDARD HAND TOOLS M03194 FT BUMP STOP 2 1984 TO 2001 JEEP CHEROKEE XJ S10210 REAR SHACKLE 2 2WD & 4WD S10921 FT TRACK BAR 1 3” LIFT KIT MOUNT BU79097 HARDWARE KIT 1 www.Daystaproducts.com Tech Support Contact Info
[email protected] Instruction Sheet P11282-00 Phone: 623.907.0081 2007 Daystar Products International Inc. Fax: 623.907.0088 841 South 71st Avenue Thank you for choosing Daystar Products Other Jeep Cherokee products. Daystar recommends a certified technician install this system . In addition to these instructions , professional knowledge of disassemble/reassembly proce- • KJ01009 1” inch transfer case drop dures as well as post instructions checks must be known. Attempts to install this • KJ03002 Front control arm bushing kit system without this knowledge and expertise may jeopardize the integrity and/or • KJ02008 Rear spring bushing kit operating of the vehicle. • KU70083 Upper adjustable control arm kit • KU70084 Lower adjustable control arm kit Please read all the instructions before beginning the installation. Check the kit • KJ70028 Front winch bumper w/o skid plate hardware against the parts list. Be sure you have all the needed parts and under- • KJ70034 Rear bumper stand where they go. If anything is missing , do not proceed with the installa- • KJ70035 Rock Rails w/o side plates tion, call Daystar Products to obtain needed items. More product at www.Daystarproducts.com Product Use Information Upper control arms As a general rule, the taller a vehicle is the easier it will roll.