Arxiv:2106.02595V2 [Gr-Qc] 26 Jun 2021 Ments – Fully Characterize the Horizon Geometry
Total Page:16
File Type:pdf, Size:1020Kb
Tidal deformation of dynamical horizons in binary black hole mergers Vaishak Prasad,1 Anshu Gupta,1 Sukanta Bose,1, 2 and Badri Krishnan3, 4, 5 1Inter-University Centre for Astronomy and Astrophysics, Post Bag 4, Ganeshkhind, Pune 411 007, India 2Department of Physics and Astronomy, Washington State University, 1245 Webster, Pullman, WA 99164-2814, U.S.A 3Max-Planck-Institut f¨urGravitationsphysik (Albert Einstein Institute), Callinstr. 38, 30167 Hannover, Germany 4Leibniz Universit¨atHannover, Welfengarten 1-A, D-30167 Hannover, Germany 5Institute for Mathematics, Astrophysics and Particle Physics, Radboud University, Heyendaalseweg 135, 6525 AJ Nijmegen, The Netherlands (Dated: June 29, 2021) An important physical phenomenon that manifests itself during the inspiral of two orbiting com- pact objects is the tidal deformation of each under the gravitational influence of its companion. In the case of binary neutron star mergers, this tidal deformation and the associated Love numbers have been used to probe properties of dense matter and the nuclear equation of state. Non-spinning black holes on the other hand have a vanishing (field) tidal Love number in General Relativity. This pertains to the deformation of the asymptotic gravitational field. In certain cases, especially in the late stages of the inspiral phase when the black holes get close to each other, the source multipole moments might be more relevant in probing their properties and the No-Hair theorem; contrast- ingly, these Love numbers do not vanish. In this paper, we track the source multipole moments in simulations of several binary black hole mergers and calculate these Love numbers. We present evidence that, at least for modest mass ratios, the behavior of the source multipole moments is universal. [This manuscript has been assigned the LIGO Preprint number LIGO-P2100109.] I. INTRODUCTION a source distribution that is deformed due to an exter- nal tidal field [14] or involve the application of black hole The general treatment of the tidal deformation of com- perturbation theory [8{13]. A limit of the compactness pact objects has been perturbative. In such a treatment, is then taken to deduce the corresponding Love numbers an external tidal field is taken to induce a deformation of for black holes. the compact object. The contribution of that field can be The problem with the \limiting compactness" ap- distinguished from the field of the object itself, e.g., when proach is that black holes do not have a source distribu- the former is treated perturbatively. Every lth multipolar tion. Furthermore, in a true sense, the horizons of black order of the external tidal field induces an lth multipolar holes cease to be null hypersurfaces in a dynamical tidal moment in the configuration of the compact object, and environment and are no longer isolated. Also, in the per- the constant of proportionality relating these is called a turbative approach, the gravitational field far away from Love number. the blackhole is studied. Hence, it is desirable to employ A sizeable literature exists on applications of tidal de- an alternative treatment with a differently defined set formation and Love numbers [1{3], especially, in how of quantities that characterize the tidal deformability of they encode information about neutron star equation of black holes in the strong field regime. In this sense, the state [4] in gravitational-wave signals [5{7]. On the other dynamical horizon formalism is an ideally suited frame- hand, tidal deformations of black holes and the associated work to treat the problem of the tidal deformation of Love numbers are discussed in, e.g., Refs. [8{10] for the black holes. In that formalism, for black holes in a vac- non-spinning case and Refs. [11{13] for the spinning case. uum, a set of numbers { called the source multipole mo- Since black holes are solutions to vacuum field equa- arXiv:2106.02595v2 [gr-qc] 26 Jun 2021 ments { fully characterize the horizon geometry. In a tions, the usual definition of the multipolar configuration tidal environment, these numbers can change, e.g., ow- of the system involving an integral of the mass density of ing to an alteration in the horizon geometry in response the system is irrelevant here. Instead, one has to address to the external tidal field. Using this approach, one can how the external tidal field induces a change in the ge- directly study the deformation of the horizon geometry ometry of the horizon. The information of the geometry due to an external tidal field. In this work, we address of the horizon is encoded in the source multipole mo- this question in a binary black hole merger scenario. We ments 1. One may expect a similar relation between the describe and use a convenient definition of tidal deforma- source multipoles and the lth order multipolar external bility suited to a binary black hole system and compute tidal field. Past treatments of tidal deformability typi- them numerically using full numerical relativity simula- cally start either with the assumption that there exists tion data of binary black hole mergers of non-spinning black holes. We use the framework of quasi-local hori- zons for our analysis; see e.g. [15, 16] for reviews. We 1 Geometric multipoles have also been used to refer to the source use the source multipole moments to address this ques- multipoles of the horizon in literature. tion. In particular, we use the mass multipole moments 2 to characterize the deformation in the horizon geometry single final dynamical horizon turns out to have interest- and define a set of dimensionless tidal coefficients. We ing topological and dynamical properties [27{30]. Again, then calculate the leading order tidal coefficients that this is beyond the scope of this paper. Here, we shall characterize the deformation of a black hole's multipole only consider the two dynamical horizons corresponding moments in the tidal environment of its companion in a to the two individual black holes before they merge. binary black hole merger scenario. For each of the two dynamical horizons, we shall cal- The plan for the rest of the paper is as follows. Sec. II culate the source multipole moments. These were first briefly reviews basic concepts and equations for dynam- introduced in [31] for isolated horizons, and extended ical horizons and describes the definition of the source and used in [32] for dynamical horizons. These multi- multipole moments of horizons. The details of Numerical pole moments have found applications, for example, in simulations are given in Sec. III. In Sec. IV we compute predictions of the anti-kick in binary black hole mergers the tidal coefficients and describe the fitting procedure. [33] and for studying tidal deformations of black holes The results are summarised in Sec. V followed by Sec. [34, 35] VI with discussion and conclusions. Appendix A con- For defining these multipole moments, let S be a tains comparison of distance measures among centroid MOTS on a Cauchy surface Σ. Let Kab be the extrin- distance and various orders of post-Newtonian approxi- sic curvature of Σ embedded in spacetime, ra the unit mations. space-like normal to S and tangent to Σ. Let the areal All the equations and quantities are expressed in geo- radius of S be denoted by RS , its mass by MS and an- metric units, where G = c = 1. The masses of the hori- gular momentum by JS. Furthermore, let S be axisym- zons of the primary and secondary black holes in the ini- metric and let 'a be the axial symmetry vector field on a tial data are M1 and M2, and their mass ratio is defined S. The symmetry vector ' can be used to construct a to be q ≡ M2=M1, which is always ≤ 1. Additionally, the preferred coordinate system (θ; ') on S analogous to the total mass of the black hole horizons in the initial data, usual spherical coordinates on a sphere; let ζ = cos θ. denoted by M = M1 + M2 is set to one. In a few places We can then use spherical harmonics in this preferred where tracking the dependence on M is important, we coordinate system to construct multipole moments. As show it explicitly. expected we have two sets of moments Mn, Jn such that M0 is the mass MS and J1 is the angular momentum JS . The expressions for the multipole moments are the II. PRELIMINARIES following n I Our calculation of the tidal deformations of black holes MS RS 2 Mn = R~Pn(ζ)d S; (2) is based on the formalism of quasi-local horizons [15{21]. 8π S A detailed description of this formalism is beyond the scope of this article and we shall restrict ourselves to a and brief overview of the most relevant concept, namely, that Rn−1 I of black hole source multipole moments. J = S P 0 (ζ)K 'arbd2S; (3) n 8π n ab The starting point is the notion of a marginally S trapped surface, first introduced by Penrose in the con- where P (ζ) is the nth Legendre polynomial and P 0 (ζ) text of the black hole singularity theorems [22]. More n n its derivative. specifically we need here the notion of marginally outer In a binary black hole merger scenario, the individual trapped surfaces (MOTS), which are closed space-like horizons of the black holes are dynamical and many of 2-dimensional surfaces of spherical topology, such that the above assumptions do not hold. For example, the their outgoing null-normals `a have vanishing expansion Ψ of the two black holes are not time-independent, and Θ . Thus, if S is a MOTS,q ~ the Riemannian metric 2 (`) ab neither are their areas, curvature, and other geometric on S, and `a an outward-pointing null-normal to S, then quantities on S .