Programming your Genie Intellicode 4. Programming multiple doors with your keypad A. Program your keypad according to the steps Wireless Keypad, BLACK COVER outlined in the Basic programming section listed above. Then… 1. Resetting your keypad to factory setting:  Open cover fully If, at any time, during programming, you should  Enter PIN number enter the wrong PIN or make a mistake, you should  Press PROG reset the keypad to its factory setting. Indicator will blink once per second  Open the keypad cover half way  Press PROG - Indicator will blink twice per  Press and hold the number 8 and the PROG second button while opening cover fully.  Press PROG - Indicator will blink three times  The indicator light will blink once and go per second out.  Enter the total number of doors (2 or 3)  Close the cover. You are now ready to re-  Press PROG program your keypad.  Close cover Your keypad is now ready to be program to the garage door openers. 2a. Basic Programming: B. Locate the learn code button on your garage  Open cover fully. Indicator will blink once door openers on go out  Press the learn code button once. Learn  Press 3-5-7 code indicator will flash  Press PROG. Indicator will blink once per  Open cover on keypad fully second  Enter PIN  Enter PIN 1 (up to 8 digits)  Press SEND  Press PROG Indicator will blink twice per  Enter door number 1-2-or-3 second  Press ↑↓ button again. Learn code LED will  Close cover. turn off. Wait for keypad backlight to go off. Your keypad is now ready to be programmed to the garage door opener. You will now be able to use your keypad normally. 2b. Basic opener Programming 5. Controlling multiple doors Locate the Learn code button on your  Intellicode/Codedodger garage door opener. Open cover fully Depending on model, the learn code button will be  Enter PIN number located under the light cover or on the rear panel.  Press SEND  Enter door number (1-2-or 3)  Press the learn code button. Learn code LED  Chosen door should operate will flash  Open cover on keypad fully 6. Adding temporary PIN  Enter PIN number  Open cover fully  Press the SEND button 4 times, or until the  Enter PIN 1 door begins to operate.  Press PROG Indicator will blink once per second You will now be able to use your wireless  Press PROG Indicator will keypad normally. blink twice per second  Enter temporary PIN  Press PROG Indicator will 3. Controlling a single door with your keypad. blink three times per second  Open keypad fully  Close cover  Press PIN number  Press SEND once Your keypad is now ready to be programmed to the  Door should operate normally garage door opener. See steps in Basic programming. (continued on next page) 7. Canceling the temporary PIN  The temporary PIN will remain active until PIN 1 is entered.

8. Changing a PIN  Open cover fully  Enter PIN to be changed  Press PROG -Indicator will blink once per second  Enter new PIN  Press PROG Indicator will blink twice if PIN 1 has changed or go out if PIN 2 was changed

9. Adding PIN 2  Open cover fully  Enter 1-5-9  Press PROG - Indicator will blink once per second  Enter PIN 2 (up to 8 digits)  Press PROG - Indicator will go out  Close cover  Your keypad is now ready to be programmed to the garage door opener. See steps in Basic programming.