Address:Tripoli, Lebanon Phone Number: 009613105228 Email Address: R I H A M G I N Z A R L Y [email protected]
OBJECTIVE Seeking a challenging job in a progressive university that offers opportunities for advancement and where my skills can be employed and developed.
EDUCATION
Present Lebanese University and University of Rouen Phd research in hybrid electric vehicle prognosis
2010-2013 American University of Beirut Beirut, Lebanon Master of Electrical Engineering, major power, minor biomedical (Average 82/100) .
2005-2010 Beirut Arab University Beirut, Lebanon Bachelor of electrical engineering, section power and control (GPA 3.41/4) . 2005-2010 Lebanese University Tripoli, Lebanon Masters in Political and Administrative Sciences . 1990- 2005 College des soeurs des saintes Coeur Tripoli, Lebanon Bac 2 General sciences
WORK AND TEACHING EXPERIENCE 2014-2015 Beirut Arab University . Final year project supervisor: the project is a full electrical installation for a health care building. It contains low and medium voltage design. August 2014 European Union Council . Consultancy for project: street lightings fed from renewable energy source (solar panels) February 2013-Present Beirut Arab University of Tripoli Tripoli, Lebanon . Instructor at Beirut Arab University, teaching electric power lab, Power system analysis lab, Electronic lab, C language lab, High voltage lab (ETAP), Automation (PLC) lab and power CAD (electrical installation) lecture. July 2013 -Present AL Manar University of Tripoli Tripoli, Lebanon . Instructor at Al Manar University of Tripoli, teaching ELEC221- Analogue circuits 1, ELEC473- Power Electronics, ELEC330-power electronics 1 and Renewable Energy ELEC474. 2011-2012 AUB Beirut, Lebanon . Worked as an assistant in machine laboratory.
May 2010/February 2012 Qualco Beirut, Lebanon . Worked as a site engineer for the project “Medicinal School” and “Car Park” LAU BYBLOS. . Performed quantity survey and follow up on site of projects previously mentioned. . Carried out as Built Drawings for the following projects: “Faculty of science” and “gymnasium” BAU University-Debbye. .Priced many other projects.
August/September2010 Jubaili Saida, Lebanon Trainee . Assisted in the testing department, I was a member of the group performing tests on ATS boards.
Freelance projects: Electrical design of residential and industrial buildings at: . Batroumin, Koura, North Lebanon (2012-2013) (Design drawings and shop drawings + BOQ) . “ Zouk 81”project named, at Zouk Mkeiel, Lebanon (2012) (Design drawings and shop drawings + BOQ) . Industrial building for mechanical affairs, Chekka North Lebanon (2011) (Design drawings)
GRADUATION PROJECTS
Bachelor: A full electrical design of a commercial and residential area that contains residential buildings, villas, mall, school, administration buildings, street lighting. (Low and Medium voltage)
Master: Assessment of permanent magnet generators for small-scale wind power applications. (An analytical approach for the surface- mounted and interior permanent magnet AC generator was conducted to calculate the generated voltage and relevant mechanical speed. The analysis shows that using permanent magnets for the AC generator provides superior performance characteristics as compared to existing equivalent induction generators. Specifically, the magnetic loading of the machine increases when different types of magnets are used for field excitation. Then we presented an optimization of the design with different rotor topologies. This enhanced performance is translated into a drop in the wind speed requirements. The obtained results showed that, when using permanent magnet generators, wind power would be applicable for wider territories with lower average wind speeds; thus, increasing its market penetration rate.) PROJECTS Below are some of the projects achieved during my university studies: - Mini PLC project: DOL starter, delta star starting, speed control of motors…
- Power and Control board of a football play ground.
- Hybrid Electric Vehicle: Operation and circuit elaborated on “Simulink”.
- Wind Energy with Hydro Storage Element Project: Operation and Planning.
PAPERS - “Impacts of Machine Configurations on the Penetration Rates of Small- Scale Wind Power Units”, Global Engineering, Science and Technology Conference, 1 - 2 April 2013, Dubai, UAE, ISBN: 978-1- 922069-21-4 (The paper took the “Best Paper Award” in the conference)
- “ Design of a windmill permanent magnet generator”, FEA’s 2013 conference AUB, 9 May 2013
COMPUTER LITERACY Microsoft Office, AutoCAD, multisim, Pspice, mathlab(M-File), Primavera, calculux, Dialux, Revit ( architecture & MEP), ETAP, ecodial, C++
LANGUAGES Fluent in spoken and written Arabic, English, and French
ACTIVITIES . Member in the IEEE.
HOBBIES Sports, Swimming, Music, Traveling
REFERENCES AVAILABLE UPON REQUEST