Router 1: Login and Hostname Setup

Lab #2

Username: lab

Password:

Router1>enable

Password:

Router1#config t

Enter configuration commands, one per line. End with CNTL/Z.

Router1(config)#hostname r1-libert76-Dand04

Router 1: Gig0/0 Setup r1-libert76- Dand04# Dand t

Enter configuration commands, one per line. End with CNTL/Z. r1-libert76- Dand04(config)#int gi0/0 r1-libert76- Dand04(config-if)#ip add 192.168.10.1 255.255.255.0 r1-libert76- Dand04(config-if)#description link to sw1 r1-libert76- Dand04(config-if)#no shut

Router 1: Show CDP Neighbor r1-libert76- Dand04(config)#exit r1-libert76- Dand04#show cdp neighbor

Device ID Local Intrfce Holdtme Capability Platform Port ID

Switch1 Gig0/0 147 S I WS-C295-24 Fas 0/20

Switch 1: Login and Hostname Setup

Username: lab

Password: switch1>enable

Password:

Password: switch1#conf t

Enter configuration commands, one per line. End with CNTL/Z. switch1(config)#hostname sw1-libert76- Dand04 sw1-libert76- Dand04(config)#

Switch 1: VLAN 1 Setup sw1-libert76- Dand04(config)#int vlan 1 sw1-libert76- Dand04(config-if)#ip add 192.168.10.2 255.255.255.0 sw1-libert76- Dand04(config-if)#no shut sw1-libert76- Dand04(config-if)#exit sw1-libert76- Dand04(config)#exit sw1-libert76- Dand04#show int vlan1 #4

Router – Switch Ping Test

Username: lab

Password: r1-libert76- Dand04>enable

Password: r1-libert76- Dand04#ping 192.168.10.2

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.10.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 3/9/15 ms

Router 1: Show IP Route

R1-libert76- Dand04#show ip route

Switch 1: VLAN 5 Setup sw1-libert76- Dand04#vlan data sw1-libert76- Dand04(vlan)#vlan 5 name accounting sw1-libert76- Dand04(vlan)#vtp transparent sw1-libert76- Dand04(vlan)#exit sw1-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. sw1-libert76- Dand04(config)#int fa 0/20 sw1-libert76- Dand04(config-if)#switchport access vlan 5 sw1-libert76- Dand04(config-if)#

Switch 1: Trunk Mode sw1-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. sw1-libert76- Dand04(config)#int fa0/20 sw1-libert76- Dand04(config-if)#switchp mode trunk sw1-libert76- Dand04(config-if)#exit sw1-libert76- Dand04(config)#exit sw1-libert76- Dand04#ping 192.168.10.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.10.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 2/8/13 ms

Router 1: IP Route and Ping r1-libert76- Dand04#ping 192.168.10.2

Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.10.2, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/7/10 ms r1-libert76- Dand04#show ip route

Gateway of last resort is not set

C 192.168.10.0 is directly connected, GigabitEthernet0/0

Router 2: Login and Initial Config

Username: lab

Password: router2>enable

Password: router2#conf t

Enter configuration commands, one per line. End with CNTL/Z. router2(config)#hostname r2-libert76- Dand04 r2-libert76- Dand04(config)#int fa0/0 r2-libert76- Dand04(config-if)#ip add 192.168.20.1 255.255.255.0 r2-libert76- Dand04(config-if)#no shut

#10

Router 2: Serial Link Setup r2-libert76- Dand04(config-if)#exit r2-libert76- Dand04(config)#int s0/0/1 r2-libert76- Dand04(config-if)#ip add 10.0.3.2 255.255.255.252 r2-libert76- Dand04(config-if)#description serial link to router 1 r2-libert76- Dand04(config-if)#no shut

#11

Router 1: Serial Link Setup r1-libert76- Dand04(config)#int s1/1 r1-libert76- Dand04(config-if)#ip add 10.0.3.1 255.255.255.252 r1-libert76- Dand04(config-if)#description serial link to router 2 r1-libert76- Dand04(config-if)#no shut

#12

Router 1: IP Route r1-libert76- Dand04#show ip route

#13

Router 2: Static Route and Ping r2-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. r2-libert76- Dand04(config)#ip route 0.0.0.0 255.255.255.255 10.0.3.1 r2-libert76- Dand04(config)#exit r2-libert76- Dand04#ping 192.168.10.2

#14 Switch 2: Setup switch2#conf t

Enter configuration commands, one per line. End with CNTL/Z. switch2(config)#hostname sw2-libert76- Dand04 sw2-libert76- Dand04(config)#int vlan 1 sw2-libert76- Dand04(config-if)#ip add 192.168.20.2 255.255.255.0 sw2-libert76- Dand04(config-if)#no shut

#15

Router 1: Static Route Setup

Username: lab

Password: r1-libert76- Dand04>enable

Password: r1-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. r1-libert76- Dand04(config)#ip route 0.0.0.0 255.255.255.255 10.0.3.2 r1-libert76- Dand04(config)#exit r1-libert76- Dand04#show ip route

#16

Router 2: IP Route r2-libert76- Dand04#show ip route #17

Gateway: Setup gateway#conf t gateway(config)#hostname gw-libert76- Dand04 gw-libert76- Dand04(config)#int s4/0 gw-libert76- Dand04(config-if)#ip add 10.0.1.1 255.255.255.252 gw-libert76- Dand04(config-if)#description serial link to router 1 gw-libert76- Dand04(config-if)#no shut gw-libert76- Dand04(config-if)#exit gw-libert76- Dand04(config)#int s4/1 gw-libert76- Dand04(config-if)#ip add 10.0.2.1 255.255.255.252 gw-libert76- Dand04(config-if)#description serial link to router 2 gw-libert76- Dand04(config-if)#no shut gw-libert76- Dand04(config-if)# gw-libert76- Dand04(config-if)#exit gw-libert76- Dand04(config)#exit gw-libert76- Dand04#show cdp neighbors

#18

Router 1: OSPF Setup and IP Route r1-libert76- Dand04(config)#router ospf 100 r1-libert76- Dand04(config-router)#network 10.0.1.0 0.0.0.3 area 0 r1-libert76- Dand04(config-router)#exit r1-libert76- Dand04(config)#exit r1-libert76- Dand04#show ip route

#19

Switch 1: Trace Route sw1-libert76- Dand04>tracero 192.168.20.2

#20

Router 1: OSPF r1-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. r1-libert76- Dand04(config)#ro ospf 100 r1-libert76- Dand04(config-router)#net 10.0.3.0 0.0.0.3 area 0

#20.1

Gateway: Show Route gw-libert76- Dand04#sho ip ro

#21 Router 2: OSPF Inter-area Setup r2-libert76- Dand04#conf t

Enter configuration commands, one per line. End with CNTL/Z. r2-libert76- Dand04(config)#ro ospf 100 r2-libert76- Dand04(config-router)#no net 192.168.20.0 0.0.0.255 area 0 r2-libert76- Dand04(config-router)#net 192.168.20.0 0.0.0.255 area 1

#22

Router 2: Running Config r2-libert76- Dand04#sho run

Building configuration...

Current configuration : 3357 bytes

! version 12.4 service timestamps debug uptime service timestamps log uptime no service password-encryption

! hostname r2-libert76- Dand 04

! no logging buffered

! boot system flash slot0: enable password enable123 ! username lab password 0 lab123

! ip subnet-zero

ip cef

! ip ssh time-out 120 ip ssh authentication-retries 3

! crypto mib ipsec flowmib history tunnel size 200 crypto mib ipsec flowmib history failure size 200

! fax interface-type modem mta receive maximum-recipients 0

! interface BRI0/1

description 0

bandwidth 16

no ip address

! interface BRI0/1:1

description 0

bandwidth 64

no ip address

encapsulation hdlc

! interface BRI0/1:2

description 0

bandwidth 64

no ip address encapsulation hdlc

! interface FastEthernet0/0

bandwidth 100000

ip address 192.168.20.1 255.255.255.0

full-duplex

! interface FastEthernet0/1

bandwidth 100000

no ip address

shutdown

! interface Null0

bandwidth 4294967

no ip address

encapsulation isl

! interface Serial0/0/0

description serial link to gw

bandwidth 1544

ip address 10.0.2.2 255.255.255.252

encapsulation hdlc ! interface Serial0/0/1

description serial link to router 1

bandwidth 1544

ip address 10.0.3.2 255.255.255.252

encapsulation hdlc

! vlan database

vlan 1 name default

vlan 1002 name fddi-default

vlan 1003 name token-ring-default

vlan 1004 name fddinet-default

vlan 1005 name trnet-default

! router ospf 100

network 10.0.2.0 0.0.0.3 area 0

network 10.0.3.0 0.0.0.3 area 0

network 192.168.20.0 0.0.0.255 area 1

! ip default-gateway 0.0.0.0 ip classless ip route 0.0.0.0 255.255.255.255 10.0.3.1 ip http server

! ip pim bidir-enable logging traps debugging

! snmp-server engineID local 0000009020000029BA3CF0 snmp-server community public RO snmp-server community private RW snmp-server packetsize 4500 call rsvp-sync

! line con 0

exec-timeout 10 0

exec-timeout 10 0 line vty 0 4

exec-timeout 10 0

! end