UCSF Lab Standard Operating Procedure s18

Total Page:16

File Type:pdf, Size:1020Kb

UCSF Lab Standard Operating Procedure s18

UCSF Lab Standard Operating Procedure

Chemical Process, Name or Hazard Class: Boron Tribromide

Please fill out the form completely. Insure all users have access to this SOP. Refer to instructions for assistance. Department: Enter text. Date SOP was written: Enter date. This lab specific SOP has been reviewed and approved by: Principal Investigator Name: Enter text. Principal Investigator Signature Lab Manager/Supervisor: Enter text.

Type of SOP: ☐ Process ☒Hazardous Chemical ☐ Hazardous Class

Purpose

Boron Tribromide is a corrosive, flammable liquid and an acute toxin.

Use caution, reacts violently with water.

May be fatal if inhaled. Material is extremely destructive to the tissue of the mucous membranes and upper respiratory tract.

Benzphetamine hydrochloride is a pharmaceutical drug used to treat weight loss.

Physical & Chemical Properties/Definition of Chemical Group

CAS#: 10294-33-4

Class: Acute toxin, Flammable liquid, Corrosive

Molecular Formula: BBr3

Form (physical state): Liquid

Color: Colorless

Boron Tribromide 1 Date: Click here to enter a date. Modified from SOP templates developed by UCLA EH&S (http://www.sop.ehs.ucla.edu/) Boiling point: 91.3 °C

Potential Hazards/Toxicity

Boron tribromide is a corrosive, flammable liquid and an acute toxin.

Use extreme caution, reacts violently with water.

Avoid heat, flames and sparks. Avoid exposure to moisture.

May be fatal if inhaled. May cause irritation of the respiratory tract with burning pain in the nose and throat, coughing, wheezing, shortness of breath and pulmonary edema.

Vapors and/or direct eye contact can cause severe eye burns. Can cause skin burns or an allergic skin reaction. Repeated exposure to vapors and/or dust can cause eye injury.

Boron tribromide has the following permissible exposure limits: 1 ppm or 10 mg/m3.

Has the following acute toxicity data:

Oral (LD50): 160 mg/kg [Rat].

Engineering Controls

Handle using a chemical fume hood with good ventilation and electrically grounded lines and equipment.

Personal Protective Equipment (PPE)

Respirator Protection If lab personnel would like to use respirator on a voluntary basis, they must be trained and fit-tested by EH&S. This is a regulatory requirement. (http://or.ucsf.edu/ehs/8193-DSY/version/default/part/4/data/)

Hand Protection Gloves must be worn. Nitrile gloves are recommended.

NOTE: Consult with your preferred glove manufacturer to ensure that the gloves you plan on using are compatible with Boron tribromide.

Refer to glove selection chart from the links below: http://www.ansellpro.com/download/Ansell_8thEditionChemicalResistanceGuide.pdf OR http://www.allsafetyproducts.biz/page/74172 OR http://www.showabestglove.com/site/default.aspx OR http://www.mapaglove.com/

Boron Tribromide 2 Date: Click here to enter a date. Modified from SOP templates developed by UCLA EH&S (http://www.sop.ehs.ucla.edu/) Eye Protection ANSI approved properly fitting safety glasses or chemical splash goggles.

Skin and Body Protection Flame resistant/cotton lab coats must be worn and be appropriately sized for the individual and buttoned to their full length. Laboratory coat sleeves must be of sufficient length to prevent skin exposure while wearing gloves. Full length pants and close-toed shoes must be worn at all times by all individuals that are occupying the laboratory area. The area of skin between the shoe and ankle should not be exposed.

Hygiene Measures Wash thoroughly and immediately after handling. Remove contaminated clothing and wash before reuse.

First Aid Procedures

If inhaled Move into the fresh air immediately and give oxygen. If not breathing give artificial respiration. Get medical attention immediately.

In case of skin contact Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Thoroughly clean shoes before reuse. Get medical attention immediately.

In case of eye contact Check for and remove any contact lenses. Rinse thoroughly with plenty of water for at least 15 minutes and consult a physician. Seek immediate medical attention and continue eye rinse during transport to hospital.

If swallowed Do NOT induce vomiting unless directed by medical personnel. Never give anything by mouth to an unconscious person. Seek medical attention immediately.

Special Handling and Storage Requirements

Precautions for safe handling: Avoid contact with skin and eyes and inhalation. Keep away from sources of ignition. Avoid heat and shock or friction when handling.

Conditions for safe storage: Flammable materials should be stored in a flammable storage cabinet. Keep container tightly closed in a cool, dry, and well-ventilated place away from incompatible materials and conditions. Avoid dust generation, moisture, and heat. Keep cool and protect from sunlight.

Spill and Accident Procedure Chemical Spill Dial 9-911 from campus phone or 415-476-1414 from cell phone or 415-206- 8522 (SFGH only)

Boron Tribromide 3 Date: Click here to enter a date. Modified from SOP templates developed by UCLA EH&S (http://www.sop.ehs.ucla.edu/) Spill – Assess the extent of danger. Assist contaminated or injured persons. Evacuate the spill area. Avoid breathing vapors. If possible, confine the spill to a small area using a spill kit or absorbent material. Keep others from entering contaminated area (e.g., use caution tape, barriers, etc.).

Small (<1 L) – If you have training, you may assist in the clean-up effort. Use appropriate personal protective equipment and clean-up material for chemical spilled. Double bag spill waste in clear plastic bags, label and take to the next chemical waste pick-up.

Large (>1 L) – Dial 9-911 from campus phone or 415-476-1414 from cell phone or 415-206- 8522 (SFGH only) for assistance.

Chemical Spill on Body or Clothes – Remove clothing and rinse body thoroughly in emergency shower for at least 15 minutes. If discomfort persists, proceed to the Emergency Department. If no further discomfort is experienced, have the SDS ready and contact Poison Control Hotline at 1-800- 222-1222 for further exposure information. Notify your direct supervisor and EH&S at 415- 476-1300 during work hours, or 9-911 during non-working hours and weekends.

Chemical Splash Into Eyes – Immediately rinse eyeball and inner surface of eyelid with water for 15 minutes by forcibly holding the eye open. If discomfort persists, proceed to the Emergency Department. If no further discomfort is experienced, have the SDS ready and contact Poison Control Hotline at 1-800-222-1222 for further exposure information. Notify your direct supervisor and EH&S at 415-476-1300 during work hours, or 9-911 during non-working hours and weekends.

Medical Emergency Dial 9-911 (campus phone) or 476-6911 (cell phone)

Note: All serious injuries must be reported to EH&S at 415-476-1300 within 8 hours.

Non-Life Threatening Emergency– Go to Occupational Health Programs (OHP) Clinic, 415-885- 7580, 2330 Post Street, Suite 460 Hours of Operation for Appointments: Monday - Friday 7:30 a.m. - 4:00 p.m. (except Holidays).

Note: All serious injuries must be reported to EH&S at 415-476-1300 within 8 hours.

Needle stick/puncture exposure (as applicable to chemical handling procedure) – Wash the affected area with antiseptic soap and warm water for 15 minutes. For mucous membrane exposure, flush the affected area for 15 minutes using an eyewash station. Page the needle stick nurse by dialing 415-353-7842 (STIC).

Decontamination/Waste Disposal Procedure

Clean contaminated surfaces with soap and water and paper towels. Dispose of the paper towels as hazardous waste.

Safety Data Sheet (SDS) Location

Boron Tribromide 4 Date: Click here to enter a date. Modified from SOP templates developed by UCLA EH&S (http://www.sop.ehs.ucla.edu/) Online SDS can be accessed at http://or.ucsf.edu/ehs/7241-DSY/msds.html

Protocol/Procedure

Quantities covered by this SOP: ______(g , ml) to ______(g, ml)

Temperature range covered by this SOP: __ °C – __ °C

General Overview and Purpose: Enter the experimental purpose

Procedure: Enter experimental procedure. You can copy procedure from your lab notebook or from literature.

NOTE

Any deviation from this SOP requires approval from the Principal Investigator.

Boron Tribromide 5 Date: Click here to enter a date. Modified from SOP templates developed by UCLA EH&S (http://www.sop.ehs.ucla.edu/)

Recommended publications