Molerepeller TA-DG005 The Electrosonic Mole Repeller

Introduction Note:

Mole is the common name for the small, burrowing, The results obtained will depend largely on the type insectivorous mammals, found throughout the of soil. Some soils transmit sound and vibration far temperate Northern Hemisphere. Moles tunnel just better than others. Also the presence of rocks and below the surface of the ground, where they hunt for other objects in the soil will affect the coverage. food, their tunnels make ridges and mounds in Some experimentation may be necessary to gardens and lawns and for this main reason they determine the optimum location for installing the are regarded as pests. Their diet consists mainly of repellers. Use only Alkaline batteries as cheaper earthworms and insects, but also includes small batteries will not tolerate the wide temperature mammals such as mice. They have acute hearing variations encountered. and a highly developed sense of touch at the ends of their noses and tails and as a result can detect Installation very small vibrations, which to them is an indication 1. Loosen the green cap by twisting the head of approaching danger. anti-clockwise a few turns and ease out the cap The Mole Repeller is an electro-sonic device that with a gentle rocking motion. exploits the inherent instinct of the Mole by generating a strong vibration and sound for a few 2. Slide out the main control module and install two seconds every 25 seconds. The frequency of the D size alkaline batteries, negative towards the vibration is within the range 300-700 Hertz, which spring. Note that there is no ON/OFF switch and has been found to be optimum for this application. It once the batteries are installed. You will is designed to be pushed into the soil, preferably immediately hear a buzz which will repeat itself totally covered by the soil at a depth of about 15 CM every 25 seconds. ( 6 In. ).This ensures close acoustic coupled with the soil and results in transmission of the sound 3. Carefully slide the control module back inside the vibration over a greater distance. The Mole Repeller aluminum tube. is perfectly safe to use and will not harm the Mole or any other animal in the vicinity. No chemicals or 4. Before replacing the cap ensure that the end of sprays are used and there is no effect on the soil or the tube is clean. Gently ease the cap back into the environment. place ensuring that the square rubber seal is evenly in place and that the green plastic cap is Applications flush with the aluminum tube. Tighten the head Plantations, Orchards, Greenhouses, Golf Courses, securely. It is important that the cap is fitted Lawns, Trees and Shrubs, Flower Beds, Household correctly otherwise water may enter the tube Vegetable Gardens, etc. causing premature failure of the module.

Specifications 5. Install the repeller by first making a 5 CM ( 2 In. ) Material : Aluminum and plastic hole in the ground about 60 CM ( 2 Ft. ) deep, an Dimensions Case : 448 mm x 38 mm x38 mm earth auger would be useful to accomplish this 1.7 Ft. x 1.5 In. task. x 1.5 In. Weight : 350 g (excluding batteries) 6. Insert the repeller vertically into the prepared 0.77 Lb. hole Power Source: Two D size torch with the pointed end cap downwards. Cover the batteries not included entire repeller with soil, ideally the top of the Battery Life : Up to six months repeller should be at least 15 CM ( 6 In. ) below Frequency : 300-700 Hz the Duty Cycle : 1 buzz every 25 seconds surface. Pack the soil around the repeller as 2 2 Effective Area: Up to 700 M ( 7535 Ft. ) firmly max. as possible.

1