This Submission Proposes Comment Resolutions for the Following Comments

IEEE P802.11 Wireless LANs

Comment Resolutions for 5006, 5300, 5344

Date: 2015-01-13

Author(s): Name Affiliation Address Phone email Liwen Chu Marvell

Abstract This submission proposes comment resolutions for the following comments: 5006, 5300, 5344.

Marvell S1G EIFS indication Interpretation of a Motion to Adopt

A motion to approve this submission means that the editing instructions and any changed or added material are actioned in the TGah Draft. This introduction is not part of the adopted material.

Editing instructions formatted like this are intended to be copied into the TGah Draft (i.e. they are instructions to the 802.11 editor on how to merge the text with the baseline documents).

TGah Editor: Editing instructions preceded by “TGah Editor” are instructions to the TGah editor to modify existing material in the TGah draft. As a result of adopting the changes, the TGah editor will execute the instructions rather than copy them to the TGah Draft.

CID Clause P L Comment Propose Change Resolution Num 500 8.4.2.1 17 44 Space between two Make wider space Accept 6 70w 8 consecutive bit between two position indications consecutive bit position (ie. B0 and B1) in the indications. Figure 8-575a53 is too narrow.

"B8 B15" in the Figure 8-716b

"B7 B22" in the Figure 8-722a13

"B0 B8" and "B9 B24" in the Figure 8- 722a14

CID Clause P L Comment Propose Change Resolution Num 530 9.31.1 28 50 Two S1G STAs shall Replace the first Accept 0 2 use the link sentence (excluding the adaptation procedure items) with: "For an S1G that is described ..." STA, the same link This paragraph adaptation procedure simply helps the specified in 9.31.3 (Link reader to interpret Adaptation using the subclause 9.31.3 VHT variant HT Control using the appropriate field) is applied with the S1G qualifiers. So following qualifications:" there is no need to quantify how many STAs and certainly there is no need to specify "shall" as the normative behavior is already covered in 9.31.3

Marvell S1G EIFS indication CID Clause P L Comment Propose Change Resolution Num 534 10.44c. 36 31 Need to clarify that Insert the following at Accept 4 6 0 the Max S1G MCS the end of the first values are those that sentence " where the consist the tuple. S1G-MCS values refer to those obtained from the Max S1G-MCS For n SS subfields of the S1G Operation element as defined in 8.4.2.170w (S1G Operation element)".

Marvell S1G EIFS indication