Wishing Well Fountain

Item# WF9635 Wishing Well Fountain

1 爸爸爸爸

PACKAGE CONTENTS

A B C D

Part Description Quantit Part Description Quantity y

2 A Base Pedestal 1 F Round Board 1

B Pillar with a hole 1 G Big Screw 8

C Pillar without a hole 1 H Small Screw 1

D Fountain Topper 1 I Pump 1

E Pail 1

A SSEMBLY INSTRUCTIONS

Step 1: Place the base pedestal (A) and 2 Pillars (B and C) on a level surface.

Step 2: Route the pump (J) ’s power cord downwards through the resin tube in Base Pedestal (A). Lay the pump ( I ) in the hole of the base pedestal (A) .And then route the pump ( I )’s power cord through the base pedestal (A), the cord exits through the slot in the bottom of base pedestal (A).

Step 3: Insert the pillar with a hole(C) at the edge of the base pedestal (A) ,pls make sure the pillar (C) is assembled close to the side of hole of the base pedestal(A) ,and then put the big screw ( G ) to twist clockwise to lock in place securely.

Step4: Insert the pillar without a hole(D) at the other edge of the base pedestal,and put the big screw to twist clockwise to lock in place securely.

Step 5: Route the water tube of the fountain topper (D) downwards through the middle hole of the pillar(B), make sure the

3 water tube is come out in the end of pillar (B) ,then align the fountain topper (D) with pillar (B and C). Make sure matching the slot under the fountain topper (D) to the the blocks on pillar (B and C), Insert the fountain topper (D) and then put the big screw ( G ) to twist clockwise to lock in place securely.

Step 6:Put the Pail ( E ) in the middle hole at the edge of the base pedestal (A) .Then hang the Round Board (F) onto the fountain topper (D) ,detailed pls refer to below’s picture.

Step 7: Connect the water tube to the outlet nozzle of pump ( I ).,Make sure the connection is tight. Also connect the LED light.

Step 8: Fill the base pedestal with water. Make sure the pump ( I ) is completely submerged in water.

4 Step 9: Plug the pump power cord to the wall outlet to run the fountain.