Objective: Provide Information Necessary to Relate Customer Requirements and Expectations s1

Specifications

1. Functional Requirements 1.1. The System will be powered by rechargeable batteries. 1.2. A single power switch to start the system will be located externally on the case. 1.3. External environmental plug from camera hookup will be provided. 1.4. External continuous power hookup for both AC and DC input to the Power Control Module will be available. 1.5. Camera will be stored in case and removable with simplified hookup to Camera Mast. 1.6. The unit will be portable enable a single person to carry. Weight of unit should be less than 75lbs. 1.7. Operate from -10C to 80C minimum (current TRX1200 Gateway). Desirable operation from -20C to 85C. 1.8. Ability to secure the unit – Portable and Securable.

2. Case Mechanical/ Physical 2.1. The system will be self contained and storable in a single outdoor environmental case. 2.2. Adjustable mast capable of mounting camera at a minimum of 7’ in height. 2.3. Portable and Securable

3. Electronics Board Design 3.1. Power Control Module 3.1.1. Charging Unit 3.1.2. LVD module 3.1.3. Powerpole bus 3.2. User Status Panel (status on all major sub-systems) 3.2.1. Battery Status 3.2.2. Connection Status 3.3. Portable Power, Battery Power, Charge Design

4. Electronics and Software Integration: 4.1. Commercial off the Shelf Color IP Video Camera 4.2. Adjustable mast capable of mounting camera at a minimum of 7’ in height 4.3. TRX1200 Gateway 4.4. Dual Band Cellular Amplifier – Optional integration 4.5. External Cellular Antennas for Wireless Wide Area Network (WWAN) 4.6. External Wifi Antennas for Wireless Local Area Network (WLAN) 4.7. Microphone, Telemetry 4.8. A ground plane for external antennas shall be included.

2. Camera/Video 4.9. Will Provide color video with a minimum of 640 x 480 resolution 2 Frames per Second. 4.10. Video stream will be adjustable providing a higher frame at lower resolutions 4.11. Camera may include Pan/Tilt/Zoom (PTZ) capability. 4.12. The multimedia stream may provide real time sound. 4.13. May include video/sound capture capability. 4.14. Camera Control will be available through WAN connection.

3-四月-18 Page 1 of 2 3. TRX1200/Communications 4.15. WWAN connectivity will function over cellular GSM and CDMA, Standard WLAN 802.11 a/b/g , and Ethernet Packet Networks 4.16. Will provide WLAN 802.11 a/b/g 4.17. Will Provide external antenna capability for both WLAN and WWAN 4.18. Will provide dual 10/100 Ethernet ports 4.19. Provide security in the form of VPN and Wireless 802.11 standards (WEP,WPA) 4.20. Communications setup and control will be available via remote Graphical User Interface.

4. Power Control Unit/Battery Backup 4.21. Will provide 14watts at 12volts for operation of TRX1200 and Video Camera 4.22. Will provide a maximum run time under battery power operation. 4.23. Will function continuously with 12VDC. 4.24. Trickle charge will occur whenever continuous AC or DC power is provided. 4.25. Will work with available industry standard batteries such as Sealed Led Acid 4.26. Low Input Voltage cutoff protecting backup battery 4.27. Reverse Polarity protected 4.28. LED indicators for ON, OFF, and Current state of Charge 4.29. External leads to power an External LED Panel 4.30. An External LED Panel for Battery status 4.31. Operating Temperature -20C to 70C 4.32. Will have a voltage Shut Down Timer providing: 4.33. Deploy time ranging from 60 to 300 seconds 4.34. Low Voltage shutdown ~below 10.5VDC 4.35. Voltage Reconnect at 12.0VDC 4.36. Will not allow the overcharging of the batteries.

3-四月-18 Page 2 of 2