1. Remove Screws from Knee Bolster (Under the Steering Column) Attached to Panel Flange

RWAL CONTROLLER

The RWAL electronic control module is located under the central portion of the instrument panel. It is mounted on a bracket attached to the back side of the panel. The module is accessible through an opening created by removal of the knee bolster.

REMOVAL

1. Remove screws from knee bolster (under the steering column) attached to panel flange 2. Remove module lower attaching screws Screws are partially hidden by air duct but can be removed with long shank, number 2 Phillips screwdriver as shown. 3. Remove module upper attaching screw 4. Remove module and bracket from underside of instrument panel. 5. Disconnect harness wires from module. 6. If module is to be replaced, remove module from bracket. However, if module is only being removed for access to another component, leave module in place on bracket.