FINE TECHNO ENGINEERS. WORKS: PLOT NO.468,ROADNO.12KATHWADA G.I.D.C.,OPP.VEPARI MAHA MADAL,ODHAV,AHMEDABAD, Mo. No. 7405074055, Ph. No. 079-22973231, 22876501 E-MAIL: [email protected]

Specification

11 Draw Wet Slip Type Wire Drawing Machine:

MATERIAL TO BE DRAWN E.C. Grade. Aluminum /Al uminum Alloy INLET SIZE OF ROD 9.5 mm. dia. FINISHED SIZE OF WIRE 2.59 mm. dia. CAPSTON DIA 450 mm. dia. x 90 mm H.P. REQUIRED 12 0 H.P Induction motor with AC Drive control panel MAIN BODY The main body of the machine would be made of 20 mm thick M.S. plate of IS 2062 quality obtained from SAIL. These plate would be cut of joined together with the latest technology of welding to make it a totally leak proof and rigid. TRAIN One part of the main body will house chain wheel train would be hardened to give extra long life These gear would operate in oil bath so that sufficient lubrication is continuously provided to these running chain wheel as well as the bearings on which these train run frictionless. ( Gear oil will not be part of our scope of supply) CAPSTAN The capstan would be made out of EN -31 steel (a) Size 453 mm dia. x 90 mm width. (b) The endless cover ring on which the wire old be pulled would be made of EN- 31, hardened and ground. The hardness on the periphery of the ring would be of the ring would RH 55 to RH 58. If these rings are made joint-less design then it would result in scratches & dent while pulling, copper as this has more UTS compared to equivalent dia. of EC grade aluminum. DIE HOLDER A unique type of self adjusting die holder will be provided to hold both TC and diamond dies. (TC/ diamond dies are not our scope of supply) DIE LUBRICATION Fully immersed type with je t spray type of lubrication system is provided. (Lubricant drawmet-15 wills not our scope of supply pumps/ tanks for lubricants storage also will not in our scope of supply.) TRAVERSING UNIT Roll -ring HT -4, 40 mm Dia. shaft traverse limit -250 mm to 400 mm. GEAR BOX Unique type of gear box is provided which does away with any type of worm reduction gearbox. This gear box decreases the power requirement of the system and makes the machine absolutely jerk-less. (variable speed) Gear box gears trains are spur gears. AREA REDUCTION 20 % to 25% for Aluminum BEARINGS Standard bearings are used in the machine of renowned make like NPZ/TEN SPOOLING ARRANGEMENT Separate single spooling with 7.5 hp motor & 7.5 hp ac drive Synchronize with main ac drive panel spools of size 550and 630 MM dia. flange DIN standard traverse width. The traverse width can be adjusted to accommodate various flange dia. and width of spools. The layering and tension control would be done with slip t ype of clutch. FOUNDATION BOLTS We will be Provided with Machine. SPOOL LOADING Pintle Type