BANDSAW BOX CREATIONS WOODSHOP CLASS www.youngfoundations.org/creations

WHAT’S IN YOUR PACKET? Lesson for teacher use……………………...... page 2 6 HRS. Box tutorial…..…….....……………..………...pages 3-6 1 Class Name: BANDSAW BOX Start class with a word of prayer.

SCRIPTURE So we, being many, are one body in Christ, and every one members one of another. Romans 12:5

QUOTE “How we love that precious Word! How the Christian should be established in the Faith that was once delivered to the saints, and not be tossed about, place to place, and joining different churches. Any church you want to belong to is all right, as long as you’re a Christian. But first put the first thing, which is that Birth that makes you kinfolks to God, as God became kinfolks with you. He become kinfolks, that He might raise you up. Before He could raise you up, He has to give you Eternal Life. Then God had to become kinfolks, to take death, to raise you up. Then you have to become kinfolks to Him, in order to go in the resurrection. You see what it is? It’s just a swap. God became you, that you might become God. See? God became a part of you, flesh, that you might by His grace become a part of Him, that’s all, to have Eternal Life.”

Rev. William Marrion Branham 57-0915M Hebrews Chapter Six #3

QUOTE MINUTE MARKER: 31:41-32:39, PARAGRAPH 562-563

2 BANDSAW BOX TUTORIAL

Materials needed: assorted finish (ex: mineral oil)

Tools needed: glasses clamps measuring tape pencil sand paper bandsaw pin gun (optional)

Cut List: 7 pieces 7” long x 4 ½” wide x 5/8” thick

*Parental assistance recommended for students under 16. 3 1.

Glue and all 2. 7 pieces of wood Let the glue dry and then together. scrape off the excess. 4. Cut out the design using a bandsaw. (The middle Draw the design of piece will be your drawer on the your drawer.) 3. face of the box.

Mark 1/2” in on 5. both sides of the 6. drawer piece. Glue and clamp the slit back together where the cutting started.

4 Cut a 1/2” off both sides of Draw the design of the the drawer piece with the drawer on the drawer bandsaw. Be sure to mark piece. the front and back of the drawer pieces. 7. 8. 9.

Glue and clamp the front and back of the drawer back onto the drawer. Cut out the design of the drawer using a bandsaw. 10.

12. Make a handle. Use 11. Sand everything. your creativity! 5 13.

Glue the handle to the front of the Do a final sanding. drawer. 14.

15. Apply a finish.

Great job!

6