© Crown copyright 2011 Printed and published by the Health and Safety Executive 08/11 should be at least at be should last the feed to available be MUST push-stick A machines ALL For Note: Circular sawing and benches Circular To prevent kickback, the gap between the front edge of edge front the between gap the kickback, prevent To the riving knife and back of the blade is set as close as close as set is blade the of back and knife riving the possible. This should be less than less be should This possible. The MUST be braked and stop stop and braked be MUST saw circular The Saw blade techniques and lifting aids for large for aids lifting and techniques are used to rip timber to size using a rip rip a using size to timber rip to used are To Crown guard no furtherthanthebaseofgulletattablelevel Maximum distance25mm Use the correct manual handling manual correct the Use prevent kickback,thefront ofthefencemustbe sheets, and use the correct PPE correct the use and sheets, Maximum distance8mm including website HSE’s long with a ‘bird’s mouth’. A second push-stick may be required for certain jobs certain for required be may push-stick second A mouth’. ‘bird’s a with long mm 450 Front extension within 10 seconds 10 within piece than 600mmdiameter Always Saw bladesless Saw fence Woodwork Information Sheet 16 Sheet Information Woodwork dimension/panel dimension/panel has more information on saws on information more has www.hse.gov.uk/woodworking.htm at table level table at mm 8 Saw table 300 mm of a cut and remove the cut piece and off-cut. Push-sticks Push-sticks off-cut. and piece cut the remove and cut a of mm 300 Hands mustbenocloserthan 300 mminfront oftheblade Riving knife The top guard top The Adjust the top guard so that it is as close as possible possible as close as is it that so guard top the Adjust Circular saw benches – Safe working practices working Safe – benches saw Circular Dimension/panel Saws cause the most accidents most the cause Saws material to length using a cross-cut fence cross-cut a using length to material machines Adjust thesawguard as closetotheworkpieceaspossible to the material being cut being material the to mouth Bird’s in woodworking in be fitted to dust extraction dust to fitted be MUST Guard Remember can also be used to cut to used be also can saws Rise/fall handle Material