Part No: BW-031-07U Electric Wiring Kit for Towbars / 7-Pin / 12N / 12

BMW X5 G05 11/2018 >> X6 G06 11/2019 >> Part No: BW-031-07U X7 G07 04/2019 >>

Electric wiring kit for towbars / 7-pin / 12N / 12 Volt / ISO 1724

[email protected] www.ecs-electronicsuk.co.uk

If the vehicle is equipped with the "Remote-Controlled Parking" or "Parking Driver Assistant" function, this function MUST NOT be used with a trailer/bike rack attached!

This electric kit has to be installed by a professional workshop or a suitable qualified person. The installation instructions must have been read and fully understood before the start of any installation. Please contact your wiring kit provider or the hotline shown in the footer should you need assistance! Make sure the vehicle is approved/homologated by the manufacturer to tow a trailer! Also please check that there is a definite compatibility between this vehicle and the electric kit! Following the installation of the electric kit, the fitting instructions should be kept together with the vehicle service document and vehicle handbook. The fitting instructions contain important information relating to the use and function of the towing kit as well as for any diagnostic or activation process, that might have to be repeated in the future (e.g. after the performance of a vehicle software update). All warranty claims will be forfeited if the electric kit or components contained therein are used incorrectly or modified. If a towing socket adaptor has been used to connect to the trailer or bike rack, this must be removed from the trailer socket once the trailer or bike rack has been disconnected. If the trailer or bike rack is not equipped with a rear fog lamp, depending on the towing vehicle type, the correct function of the towing kit cannot be guaranteed. In such cases, a rear fog lamp should be retro fitted. This towing electric kit will not be covered under warranty if any technical or electrical modifications or software updates have been performed by the vehicle manufacturer after the initial commissioning of the kit. That applies especially to modifications or updates which may cause malfunctions in the trailer socket or any other part of the trailer electrical equipment! Depending on the type of trailer module used in this electric kit, diagnostic interrogation with the vehicle’s electrical system may be limited or will not function. The error memory inside the trailer module may not be able to be accessed by vehicle manufacturers diagnostic system. Error logs relating to the trailer electrical equipment, that may be generated in the vehicle manufacturers diagnostic system as a result of a test procedure, may be due to the incorrect installation of the towing electric kit or the false activation of the trailer module. We always recommend whenever possible, the following troubleshooting process: An analysis of the vehicle’s error memory and possibly clearing of all faults before the start of the installation! Try disconnecting the trailer module from the towing harness and re-start the fault clearing process! If in doubt, limit the time for troubleshooting to a max of 0,5 hours and call our Technical Support Team! Please follow our instructions carefully and always test the towing electrics using a true lighting board or a specifically designed bulb tester. If an LED tester is used, ensure it is equipped with correct load resistors or malfunctions will occur! This instruction is subject to changes and we reserve the right to make changes to design, colour etc. All of the data and illustrations may not be an exact representation but the text contained in this instruction must be observed!

1/19

ECS Electronics UK 20 Speedwell Close SALE: +44 (0) 7590 564639 Email-sales: [email protected] Revision: 4 / 23.04.2021 Hun�ngton TECHNICAL: +44 (0) 7440 202052 Email-technical: [email protected] Chester, CH3 6DX WEB: www.ecs-electronicsuk.co.uk BW-031-07U Part No: ********* U1 M

tronics.com ukts@ecs-elec www.ecs-electronicsuk.co.uk U2

1/** F Righ td Revision: * / ********** Unit 503 Queensway Business Park SALE Web: www.right TELFORD TF1 7UL UK TE Email: sales@right RC-MIT001-7 /******* T2 T1

X M

C G R 54 STOP A B 5x

E D

3x 3x 3x 20 Amp. 1x 20 Amp. minifuse

1x 10x 4x 1x

Option 2 Option 1 Option 3

R 54 STOP

12-16, 18 20-23 24-26 7-11

2/19

Left (58-L) respectively 12V Cigarette lighter / Right (58-R) tail light accessory socket STOP Stop light (54) / Loudspeaker / buzzer 54 high mounted, third stop light (54)

L Turn signal indicator left Park Distance Control

R Turn signal indicator right Switch / source of function

Rear fog light(s) Connect together

Reverse Reversing light(s) Disconnect

30+

+ Permanent power supply / 13pin socket, chamber 9 Look at / See further information 15+ + Charging wire for trailer battery / Look carefully at selected area 13pin socket, chamber 10 Trailer / trailer recognition Present / Occupied / OK

B+/30 Permanent current power supply Not present / Not occupied / Not OK

Ground or Earth (31) Acoustic indication

Ground connection battery terminal lug Attention / important advice

20 Amp. Positive connection battery terminal lug 20 Amp. Fuse / fuse capacity 20 Ampère

TOOLS

o C

The vehicle's cooling capacity may have to be increased when retrofitting a trailer coupling! ATTENTION! You must observe the manufacturer's instructions!!

Note: It may be necessary to check if this vehicle has a stored radio code before disconnecting the battery! ! Code 3:3

ATTENTION! In order to avoid mal-functions and damage to the vehicle’s electrical system the earth terminal must be disconnected from the vehicle’s battery before starting work!

Both the trailer module and the vehicle’s control unit for the electrical system can be damaged during work on the data bus connections if the battery is not disconnected!

1 Please pay attention to the manufacturer’s instructions when disconnecting and reconnecting the vehicle’s battery!

3/19

BMW X6 G06

BMW X7 G07

3 2

4/19

2 1 5 4

INFO

Option 1

BMW X5 G05 ø 25mm

BMW X6 G06

SEAL WITH SILICONE. 3

5/19

Option 1 1 2 ø 25mm BMW X7 G07

SEAL WITH SILICONE. 3

X 5

INFO

Option 2

ø 40mm

1 2

1 ø 24mm

2 3

3 SEAL WITH SILICONE. X

6/19

X X 7

SOCKET CONNECTION

STOP DIN/ISO L 1-7 R 1724 1/L 2 3/31 4/R 5/58-R 6/54 7/58-L Pmax 21W 21W 21W 42W 3x21W 42W

Yellow Blue White Green Brown Red Black

Option 1

! X

! 9

Option 2 1 2 3

7/19

BMW X6 G06

1 10 mm

2 G

BMW X7 G07

1 10 mm

2 G

8/19

M 4

9/19

R A White/Red White/Red R

3 4

1 2 Blue/Red

54 STOP B Green/Blue Green/Blue

54 STOP

3 4

54 STOP

10/19

Option 1

Boot lid module

Option 2 No CAN-data wire available in boot Option 3

11/19

BMW X5 G05

BMW X6 G06

BMW X7 G07

WH 14-Pin

1 M

Cut to length!

Black

Yellow C

Yellow/Red or Blue/Grey CAN-Data Wire E D Yellow/Brown or Brown/Grey !

Yellow/Brown CAN Low = or ! Brown/Grey 4 14-pin connector White Yellow/Red Chamber 14 Important! CAN High = or Please note Blue/Grey informations in picture 1! 14-pin connector White Chamber 13 3

Yellow Yellow C Black 2 Yellow/Brown or Brown/Grey Black C Yellow/Red or Blue/Grey C 18

12/19

Cut to length! C Black

Yellow C

Black 54-Pin

Option 2 1

Yellow/Red or Blue/Grey CAN-Data Wire Yellow/Brown or Brown/Grey ! E D

CAN Low Yellow/Brown or Brown/Grey 4 54-pin connector Black Chamber 49

CAN Low ! Yellow/Red or Blue/Grey 54-pin connector Black Chamber 50 3 Important! Please note Yellow informations in Yellow picture 1! C Black 2 Yellow/Brown or Black Brown/Grey C Yellow/Red or Blue/Grey C

13/19

Black

Black 1 C 3 M Black Black Yellow Cut to length!

Black C Yellow 21 C

Black 54-Pin

Option 3 1

1 CAN-Data Wire !

Black ! 54-pin

Important! Plea se note informations in picture 1!

2 3

14/19

Black Pos. 50

Yellow Pos. 49 E 6

20 Amp.

Red/Blue U2

15/19

B+/30 2

1 26

Optional Reverse ! MAX = 21W Reverse F Pink

Reverse 27 12S socket

Code ! 3:3

Optional

Trailer Simulator for 7- and 13-pin Sockets

Consult your supplier.

16/19

L R 54 STOP

V DC

0 Manual Range 6 Reverse + HOLD MINMAX RANGE

Hz V

Hz V mA Hz

OFF A Hz

400 mA V

10A COM

part no. LIGHTMATE II LIGHTMATE III

L R ! LED

L L L

120 160 6 80 4 60 3 P

40 2

20 1 10 1/min 0 mph x10000 Trailer turn COLD Indicator failure COMFORT P +19.0°C 31

17/19

• Rear lights • Side lights ! • Numberplate lights The parking lights or dimmed headlights must be switched on to activate this function!

Front and rear PDC

Optional Adapter socket

7-pin 13-pin

18/19

Part No: *********

tronics.com ukts@ecs-elec k.co.uk www.ecs-electronicsu

1/**

Righ td Revision: * / ********** Unit 503 Queensway Business Park SALE Web: www.right TELFORD TF1 7UL UK TE Email: sales@right RC-MIT001-7 /*******

19/19