Single-mode Fast Media Converter + Media Converter 8 Ports RJ45 Model: HTB-3100S-A/B x8

Description: A fiber media converter is a simple networking device that makes it possible to connect two dissimilar media types such as with fiber optic cabling. They were introduced to the industry nearly two decades ago, and are important in interconnecting fiber optic cabling-based systems with existing copper- based, structured cabling systems. They are also used in metropolitan area network access and data transport services to enterprise customers.

10/100 Rate Converting to Fiber Media Converters transparently connect 10/100 Ethernet to fiber. 10/100 converters provide an economical path to extend the distance of an existing network, the life of non-fiber based equipment, or the distance between two devices Network Administrators can "see-everything" with the advanced features such as Auto-Negotiation, Auto-MDIX, Link Pass-Through, Far End Fault, and Remote Loopback. This allows for more efficient troubleshooting and less on-site maintenance.

The Media Converter is 8 ports 10/100Mbps RJ45 to one port 100M Single Fiber SM, SC, up to 25km. Auto negotiation of 10/100Mbps and auto MID/MID-X for TX port Provide switch configuration of Half-Duplex / Full-Duplex transfer mode for FX port. It can transmit the traditional 100M up to 2km by multimode fiber cable or 20km by single mode fiber cable.

Features:  Optical Port: 100Mbps, Single SC single-mode fiber, support 100M Ethernet.  RJ45 Port: CAT5E/CAT6 10M/100M, Full Duplex or Half Duplex; Supports MDI/MDI-X auto crossover.  128 K's data buffer RAM  Support for low-delay time pure data transmission and full/half-duplex flow control  Built-in watch-dog timer to monitor any error in internal data exchange  Complies with IEEE IEEE 802.3/802.3u/802.3af.  Status LED's for TX, FX LINK/ACT, POWER, FDX to easily monitor network status.

Specifications: . Optical Port: - 1310nm Single mode - Transfer Distance: up to 25km - Connectors: Single SC connector - Fiber core: 8.3um, 8.7um, 9um and 10um on single mode fiber - Optical Power (dBm): -15~ -8 - Receiving Sensitivity (dBm): ≤-34

. Ethernet Port: - Standard: IEEE 802.3, IEEE 802.3u - Available speed: auto-detective 10/100Mbps Full-Duplex and Half-Duplex auto-negotiation - Connectors: RJ-45 connector; MDI/MDI-X connection auto-sensing

. LED Indicators: - FX, TX, Link/Act (Left/Right), FDX, PWR - FX: Light on when fiber speed is 100Mbps, while “OFF” means the rate is 10 Mbps - TX: Light on when TP speed is 100Mbps, while “OFF” means the rate is 10 Mbps - Link/ACT: Left side is indicate for fiber port link/act and right side for TP, light flashing when data transmitting and receiving - FDX: Light on when TP full-duplex mode is active, light off when TP half-duplex mode is active - PWR: Light on when DC power on, else light off

. Power Requirement: - Output voltage: DC5V 2A - Power dissipation: ≤1 watts

. Environmental Limits: - Operating Temperature: 0°C to 60°C - Storage Temperature: -20°C to 70°C - Humidity: 5% to 90% RH

Operating Instructions: Made in China